How to Update FCV-1150

How to Update FCV-1150
How to update FCV-1150
2/4
How to Update FCV-1150
FCV-1150 is updated by following steps below.
1. Connect PC to FCV-1150
Connect a PC to FCV-1150 through a network hub with LAN cables as shown in
Fig.1. If the hub is not used, software update may fail. Do not turn on FCV-1150
yet.
FCV-1150
PC
Operation environment:
Windows 2000 and its order
versions, and Windows XP (32 bits)
Update software does NOT support
to use Windows XP (64 bits) and
Vista.
HUB
LAN cable
(straight cable)
Fig.1
LAN cable
(straight cable)
2. Change TCP/IP configuration on your PC
IP address: 172. 31. xx. xx
Subnet mask: 255.255.0.0
See Appendix for the setup procedure.
3. Update FCV-1150 software
1. Download “Upgrade” folder from the Technet.
2. Double click Upnet.bat file in Upgrade folder, and the following display appears.
Fig.2
If the PC fails to communicate with FCV-1150, error message in Fig.3 appears.
Fig.3
How to update FCV-1150
3/4
3. Turn on FCV-1150. After about 15 seconds, the PC starts upgrading the
program as shown in Fig.4. After about 90 seconds, the software upgrade is
terminated, and FCV-1150 restarts automatically.
Fig.4
Press any to continue ..
Fig.5
4. Make sure that “0252359-01.03” is the program number in the FCV-1150
startup display.
5. Press any key on the PC to quit the FCV-1150 update software.
How to update FCV-1150
4/4
Appendix How to set IP address and subnet mask on your PC
1. Go to “Start” and select “Control Panel.”
2. Open “Network Connections.”
Step 1
Step 2
3. Right Click on “Local Area Connection” and select “Properties.”
4. Select “Internet Protocol (TCP/IP)” and click on “Properties.”
Step 3
Step 4
5. Fill the IP fields as shown below.
IP address: 172.31. xx. xx
Subnet mask: 255. 255. 0. 0
Any number
Step 5
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising