weekly programmable electronic timer

weekly programmable electronic timer
WEEKLY PROGRAMMABLE ELECTRONIC TIMER
• DIN Rail Installation
• Advanced pre-setting one week before
• Latest technology COMS quartz Mico-controller
• Digital electronics general purpose time switch with daily and weekly programs
• Repeat programs with 8ON/OFF settings
• To-the-minute setting accuracy
• LCD displays real time to Hour/Minute and ON/AUTO/OFF
TECHICAL DATA
Voltage Limit:
AC180V ~ 264V (60/60Hz)
Number of circuits:
1c
Hysteresis:
< 2s/d (at 25°C)
Load capacity:
16A 250VAC (ohmic load cos Ø=1)
On/off operation:
8 on & 8 off
Service life:
Mechanically: 10^7
Minimum interval:
1 minute
DIMENSIONS:
Electrically: 10^5
Weight:
Approx. 150g
Ambient temperature:
-10~55°C
Display:
LCD
Storage temperature:
-20~70°C
Battery Backup:
150h
Power consumption:
5VA
CONNECTIONS
OPERATING INSTRUCTIONS:
1. When the timer is put into use for the first time, connect it to the electrical power supply and
let
the battery recharge. Once the battery is fully charged, press the reset key.
2. The timer switch is set to 24h mode in the factory. Should you wish to change to 12h mode,
press the “” key.
3. Programming:
Step Key Programming
1 Press P Setting 1 ON time (display 1 on)
2* Press D+ Select days of week (if you want the same settings
every day, you need not press this key)
3 Press H+/M+ Set hours and minutes
4 Press P Setting 1 off time (display 1 off)
5 Press D+ Select days of week (if you want the same settings
every day, you need not press this key)
6 Press H+/M+ Set hours and minutes
7 Repeat step 2-6 Set 2-8 on/off time
8** Press “” End
To cancel engagements, press “MANUAL” and then “--:--“ is displayed on LCD to confirm
cancel.
You may press “MANUAL” again to resume initial settings.
* 10 Different Modes: 1 = MO, 2 = TU, 3 = WE, 4 = TH, 5 = FR, 6 = SA, 7 = SU,
8 = MO TU WE TH FRI, 9 = SA SU, 10 = MO TU WE TH FR SA SU
** If you do not need 8 time setting press “” key to end.
4. CLOCK SETTINGS
(1) Press “” and “D+” together till correct date is shown.
(2) Press “” and “H+” together till correct hour is shown.
(3) Press “” and “M+” together till correct min is shown.
(4) Press “MANUAL” key to display ON AUTO or AUTO OFF. (If this clock in you program in
ON select ON AUTO, and this clock in your program is OFF select AUTO OFF)
5. If you always want to use time switch ON or OFF, please press “MANUAL” key to display
“ON” or “OFF”
NOTE
THE POWER CONSUMPTION OF CONNECTED ELECTRICAL APPLIANCES SHALL BE WITHIN THE
LIMITATION OF FOLLOWING RATED CAPACITY.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement