AVLS Cheat Sheet - Prairie Hydraulic Equipment Ltd

AVLS Cheat Sheet - Prairie Hydraulic Equipment Ltd
Verify the Following on the AVLS Computer
-POWER LED is ON (Red)
-GPS LED is Green and Flashing
-RADIO LED (Green) can be ON or OFF, but
must come ON at least once by the end of your
shift.
If the GPS LED is not flashing, the AVLS is NOT
monitoring or recording your truck information
(even if the RADIO LED is on). Please check the
antenna connections (bottom of AVLS Computer)
and verify the roof-mounted antenna is not blocked
by nearby structures. Ideally, the GPS signal
should lock-in within 30 seconds after power-up.
Note that GPS signals are typically not available
indoors.
If the RADIO LED is not always on, this is OK.
The AVLS computer will store information until it
is within a cellular-services area. However, Live
Data and truck history will not be available until
the RADIO LED comes ON. If the RADIO LED
never comes on, check antenna connections
(bottom of AVLS computer) and ensure the roof-
mounted antenna is not blocked by nearby
structures.
If the POWER LED does not come on, check
power connections to the terminal box and the
AVLS computer.
If the POWER LED comes on but no other LEDs
come on within one or two minutes, check antenna
connections (bottom of AVLS computer) and
ensure the roof-mounted antenna is not blocked by
nearby structures.
If you have any operational issues with the AVLS
equipment that you cannot quickly resolve, please
notify your supervisor immediately.
Billing Switch
Please ensure when you are operating a billable
activity or are within a billable segment, you have
the billing switch activated. The switch is RED
when it is activated, and WHITE when
deactivated.
Driver ID Change
Accu-Cast/PHE-V: Hold the “Program” switch
down while powering up the controller until
“Route Setup” is displayed, then release the
toggle. Rotate the “Conveyor” knob 3 clicks
clockwise from the “Off” position. Use the
UP/DOWN toggle to change the operator number,
then rotate “Conveyor” knob one more click
clockwise and press BLAST to save the changes.
CS-230/AC: Turn controller on; ID should be
prompted automatically (if not, contact your
supervisor to have this corrected). Use the
UP/DOWN push-buttons to change the ID (the
longer the buttons are held down, the faster the
number changes). When correct ID is achieved,
press BLAST to save the change.
**IMPORTANT: The BLAST button will not
function if any PAUSE switches are activated.
Ensure all remote PAUSE switches are off if the
BLAST button does not operate**
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising