XPress Ethernet Bridge - Datasheet

XPress Ethernet Bridge - Datasheet
XPress™ Ethernet Bridge
900 MHz Wireless Ethernet Bridge
The XPress Ethernet Bridge provides a secure point-topoint or point-to-multipoint IP connection without the
expense and limitations of physical cabling.
Overview
The XPress Ethernet Bridge replaces costly wiring with a
solution that can wirelessly connect industrial PLCs, digital
signs, security cameras, access controllers and more. With a
range of up to 15 miles, the ability to transmit through as many
as 10 standard walls, a 1.5 Mbps data rate, and the added range
and capabilities of the 900 MHz band, the easy-to-use, longrange XPress Ethernet Bridge communicates where Wi-Fi and
other wireless data products fall short.
Application Highlight
The XPress Ethernet Bridge features a built-in spectrum analyzer,
allowing users to monitor RF interference. Frequency agility
enables the product to automatically select the best available
radio channel at start-up, monitor the signal-to-noise ratio and
move the network to a new channel if necessary. A web interface
simplifies installation, allows users to monitor packet success
and signal strength and facilitates remote troubleshooting.
The XPress Ethernet Bridge is housed in a weatherproof
enclosure. It is available in pre-paired units or single units for
point-to-multipoint applications.
Features/Benefits
Target Applications
• Easy-to-use web interface simplifies configuration and remote troubleshooting
• Check packet success and signal strength with the web interface
• Outdoor line-of-sight range of up to 15 miles (with high gain antenna)
Industrial Automation
Building Automation
Remote Devices
• AES encryption, FIPS 197 and optional FIPS 140-2 provide secure communication
• Built-in NAT supports multiple IP client devices
Smart Energy
• Frequency agility ensures reliable connection between radios
• Monitor RF interference with built-in spectrum analyzer
www.digi.com
Specifications
XPress™ Ethernet Bridge
Performance
Indoor/Urban Range
Up to 1000 ft (300 m) w/ 2.1 dB dipole antenna
Outdoor/RF Line-of-Sight Range
Up to 2 miles (3.2 km) w/ 2.5 dB dipole antenna, Up to 15 miles (24 km) w/ high-gain antenna
Transmit Power Output
125 mW (+21 dBm), 4W EIRP w/ 15 dBi antenna
Throughput Data Rate
935 Kbps
RF Data Rate
1.536 Mbps
Receiver Sensitivity
-97 dBm (@10e-4 BER)
Features
Suppported Protocols
TCP/IP, Rockwell (RSLinx EtherNet/IP, CSP), Modbus/TCP
Browser Management Tools
QoS statistics, Network settings, Spectrum analyzer, Firmware upgrading
Data Connection
10/100Base-T RJ-45, Auto MDI/MDIX
Interference Immunity
DSSS (Direct Sequence Spread Spectrum)
Encryption
128-bit AES, FIPS 197/NIST certified (optional FIPS 140-2)
Radio Channels/Bandwidth
12 channels (6 in international version) with 2.0833 MHz spacing and 1.75 MHz occupied bandwidth
Frequency Band
ISM 902-928 MHz (915-928 MHz international version)
Frequency Agility
Radio channel automatically selected and adaptively optimized
Manual Frequency Mode
Channel selected with DIP switch or web browser interface
Status LEDs
Power, RF TX/RX, Ethernet link, channel, link quality
Error-Correction Technique
Sub-block error detection and retransmission
Adjacent-Band Rejection
>60 dB - SAW receiver filter attenuates cellular and pager interference
Regulator Type
Switching regulator
Antenna Connector
RF RPTNC female
PoE (Power over Ethernet)
Proprietary system included
Subscriber Units
Up to 16 active (63 total) per access point
Serial Number Based Mating Protocol
Yes
Dimensions (L x W x H) and Weight
7.9 in x 3.6 in x 2.4 in (20.0 cm x 9.1 cm x 6.1 cm); 415 grams
Power Requirements
Power Consumption
Transmit: 1.7W, Receive: 0.8W
Transmit Current Draw
9 - 48 VDC Power over Ethernet, 175 mA at 9 VDC, 140 mA at 12 VDC, 35 mA at 48 VDC
Power Connector
Use PoE injector, power jack P5-2.1 mm center positive
Environmental
Operating Temperature
Radio/Enclosure: -40° C to +70° C; POE injector: -40° C to +85° C; Power supply: 0° C to +40° C
Weatherproofing
The XPress Ethernet Bridge is IP65 rated. The PoE injector and power supply are not weatherproof and should be installed indoors.
Regulatory Approvals
FCC (U.S.A)
Yes
IC (Canada)
Yes
ETSI (Europe)
N/A
C-TICK (Australia)
Yes
TELEC (Japan)
N/A
Visit www.digi.com for part numbers.
91001402
C6/1112
DIGI SERVICE AND SUPPORT - You can purchase with confidence knowing that Digi is here to support you
with expert technical support and a strong one-year warranty. www.digi.com/support
Digi International
Worldwide HQ
877-912-3444
952-912-3444
Digi International
France
+33-1-55-61-98-98
www.digi.fr
Digi International
Japan
+81-3-5428-0261
www.digi-intl.co.jp
Digi International
India
+91-80-4287-9887
Digi International
Singapore
+65-6213-5380
© 2008-2012 Digi International Inc.
All rights reserved. Digi, Digi International, the Digi logo, the Wireless M2M logo and XPress are trademarks or registered trademarks
of Digi International Inc. in the United States and other countries worldwide. All other trademarks are the property of their respective
owners. All information provided is subject to change without notice.
Digi International
China
+86-21-5150-6898
www.digi.cn
BUY ONLINE • www.digi.com
info@digi.com
Mouser Electronics
Authorized Distributor
Click to View Pricing, Inventory, Delivery & Lifecycle Information:
Digi International:
XEB09-C XEB09-BISA XEB09-I
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising