1. KEY TO DIAGRAMM 1. ON/OFF switch 2. Pump and

1. KEY TO DIAGRAMM 1. ON/OFF switch 2. Pump and
QUICK MILL S.R.L.
Via Stati Uniti d’America, 6/8
20030 Senago (Mi) Italia
Tel.02/9986106 – Fax 02/99010947
Reg.delle Imprese di Milano (MI-1999-193954)
Cap.Soc. € 52.000,00 i.v. - R.E.A Milano 1593567
C.F.-P.IVA 12859930153 – N.Mecc.MI 300877
il gusto della perfezione
1. KEY TO DIAGRAMM
1. ON/OFF switch
2. Pump and water button
3. Red Light: coffee/water
4. Steam button
5. Red Light: steam
6. Passive cups heater
7. Lever to deliver coffee
8. Drip tray with grid
9. Water/steam tap
10.
Steam spout
11.
Grouphead
12.
Hole to refill the water tank
13.
Hole cover
14.
1 cup filter holder with filter
15.
2 cups filter holder with filter
16.
Gauge
17.
Green light: machine is on
18.
1 measuring spoon/presser
2. SAFETY REGULATIONS
Before connecting the coffee machine, read carefully the instructions.
Check if the voltage rating of the appliance, as quoted under the machine,
corresponds with that of your power circuit.
Do not submerge the machine in water.
Clean the machine with a damp sponge.
If the power supply cable is damaged, it must be replaced by an authorized
QUICK MILL Service Center.
The following components can reach a very high temperature and can cause
burns:
- Grouphead (11)
- The chromed part of the grouphead
- The water/steam tap and the relevant spout
Do not allow children to operate the appliance unless under close supervision.
Quick Mill cannot be held responsible for
irrational use.
non correct, wrong or anyway
3. GENERAL INSTRUCTIONS
This machine is suited to make coffee, warm water and steam. It cannot be used
for any other purpose.
Never use the machine without water.
We suggest to keep the original package (in case of return of the machine to the
supplier).
4. BEFORE OPERATING THE COFFEE MACHINE
- Remove the cups heater (6). Take away the intake and escape water tubes
and remove the water tank.Clean the water tank and fill it with fresh
water.Put the water tank in its original position.
IMPORTANT: Pay attention that the silicone tubes are completely submerged
in the water and are not bended.
- Turn the water/steam tap (9) counter clockwise and put a container under
the water spout (10).
- Push button (2).
OPERATING INSTRUCTIONS
Press the main power switch (1). Open the water tap (9) to exhaust the air of the
boiler. As soon as some water drops go out, switch off the button (2) and close
the tap (9) turning it clockwise. When the boiler has reached the right
temperature the red light (3) goes off and the machine is ready to operate.
5 . PREPARING COFFE
- Use the filter holder with filter for one cup only for the delivery of one cup
of coffee and the filter holder with filter for two cups only for the delivery
of 2 cups of coffee.
- Fill the filter and press lightly the coffee with the presser. Place the filter
holder in its seat on the group (11). The right quantity for one good coffee
is 7 gr.
- Too much coffee makes difficult to insert the filter holder in the group and
a few coffee will cause a too rapid flow producing coffee with no cream.
- To get a good coffee the right degree of grinding is very important.
- Place the cup/s under the filter holder.
- Place the lever (7) completely in up position to deliver coffee.
- After the delivery of coffee, put the lever completely in down position. The
valve of the grouphead will discharge the surplus of water into the drip
tray (8). The light (3) goes on when the programmed temperature fails.
6. HOT WATER DELIVERY
(The appliance must be ready to operate)
- Place the container under the water/steam spout (10) Open the
water/steam tap (9) turning the knob counterclockwise.
- Press button (2).
- To stop the delivery of water it is sufficient to switch off button (2) and to
turn off the tap (9).
Il may happens that first some steam flows out and after a few seconds the
water will flow slowly.
7. STEAM DELIVERY
(The appliance must be ready to operate)
- To deliver steam it is necessary to put up button (4). The steam light (5)
goes on. When it goes down the machine is ready to deliver steam.
- Half-fill a suitable container with milk. Submerge the steam spout (10) in
the milk. Turn on the tap (9). As soon as a non-stop steam comes out, put
the steam spout just under the level of the milk. By foaming the milk you
must hear a flapping noise which is caused by the air outflow. That means
that you are doing right. Milk foams at 77°, therefore first you must foam
the milk and after you must heat it
- After each delivery of steam your must put button (2) in up position for
the manual recharge of the boiler and wait till the boiler is full. Than put
it in down position.
If this rule is not respected, warranty will automatically become void.
8. CLEANING THE MACHINE
A careful cleaning of the machine is very important for its reliability, its life and
the operating safety.
- Clean the filter weekly with a brush and fresh water moving it from the
filter holder.
- Even if coffee flows out regularly, clean the gasket of the group monthly
using a curved utensil similar to a pipe-pick.
- If water is very hard, each 2/6 months decalcify it using a decalcifying
product for coffee machines or lemon (no vinegar).
TECHNICAL FEATURES
Dimensions: L 22 ,5 x H 38,5 x D 40 cm.
Net weight : 17 kg
Power :
1500 Watt
Voltage:
230V 50Hz
Or
110V 60 Hz
Or
100V 50/60 Hx (Japan)
Boiler Capacity: 0,75 lt.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising