EIA/CCIR Monochrome Video Graphic Printer UP-895MD G et near photographic, high glossy prints when you use Sony's new UP-895MD monochrome video graphic printer with specially developed UPP-110HG paper. Designed for medical diagnostic equipment such as ultrasound systems, and with useful features including superb image quality, high-speed output, and compatibility with both EIA and CCIR video signals, the UP-895MD is the ideal choice for medical black-and-white print applications. High-resolution 1280 dots x 608 lines printing (in WIDE 2 scan mode) and 256 steps of gray level 12.8 dpm or 325 dpi print resolution High quality, glossy, near photographic printing with newly developed printing paper, UPP-110HG Smoothing feature for smoother, clearer image output Automatic selection of EIA/CCIR video signal Worldwide power supply for AC 100 to 120 / 220 to 24O V Automatic paper load system for simple operation Multiple copies (up to a maximum of ten) Audible alarm when printer needs paper or the video signal is absent Compact and lightweight Fast printing of approximately 3.9 seconds per screen (with smoothing feature turned off and printer set to STANDARD print mode) Thermal head protection Wide scanning function (NORMAL/WIDE 1/WIDE 2) 2x zoom for either half of picture in either STANDARD or SIDE mode Selectable 4:3/1:1 aspect ratio Approx. 201 prints* out of UPP-11OHG (18 m)** Standard Side Normal Small *Appro*. 193 prints when each image cut out "In default setting '.\ Thermal head: Thin film thermal head, 1280 dots Gradations: 256 steps of gray level (quasi) Printed picture size: STANDARD print mode, at 4:3 aspect ratio (EIA) NORMAL: 90 x 69 mm (3 5/8 x 2 3/4 inches) WIDE V. 94 x 72 mm (3 3/4 x 2 7/8 inches) WIDE 2: 100 x 74 mm (4 x 3 inches) (CCIR) NORMAL: 90 x 68 mm (3 5/8 x 2 3/4 inches) WIDE 1: 94 x 71 mm (3 3/4 x 2 7/8 inches) WIDE 2: 100 x 74 mm (4 x 3 inches) STANDARD print mode, at 4:3 aspect ratio Effective pixels: (EIA) NORMAL: 1150 dots x 472 lines WIDE 1: 1210 dots x 490 lines WIDE 2: 1280 dots x 508 lines (CCIR) NORMAL: 1150 dots x 560 lines WIDE 1: 1210 dots x 582 lines WIDE 2: 1280 dots x 608 lines Approx. 3.9 seconds/screen Printing speed: (STANDARD print mode, smoothing off) Approx. 6.8 seconds/screen (SIDE print mode, smoothing off) Approx. 7.8 seconds/screen (STANDARD print mode, smoothing on) 8-bit frame memory Picture memory: Front panel j VIDEO IN: BNC, CCIR or EIA composite video signal, 1.0 Vp-p, 75 Ω/high impedance selectable VIDEO OUT: BNC, Loop through or E to E selectable Stereo mini jack for an optional Remote Remote: Control Unit RM-91 Power requirements: AC 100 to 120 / 220 to 240 V, 50/60 Hz Power consumption: Max. 120 W Approx. 154 (W) x 105 (H) x 260 (D) mm Dimensions: (6 1/8 x4 1/4 x 10 1/4 inches) 3.4 kg (7 lb 8 oz) Mass: Supplied accessories: AC power cable BNC cable (1.5 m) Printing paper, roll (UPP-110HG) Head-cleaning sheet Operation manual High Quality Printing Paper UPP-110S Consumables: (110 mm x 20 m) High Density Printing Paper UPP-110HD (110 mm x 20 m) High Glossy Printing Paper UPP-110HG (110 mm x 18 m) Optional accessory: Remote Control Unit RM-91 Safety regulations: UL-2601-1, CSANo.22.2, No.601.1, EN60601-1, EN60950 FCCCIassA, ICES003, EN60601-1-2, EMC regulations: EN50081, EN50082-1 Input/Output: Rear panel 2x zoom UPP-110HG 256 B/W Distributed by ©1999 Sony Corporation. All rights reserved. Reproduction in whole or in part without written permission is prohibited. Features and specifications are subject to change without notice. All non-metric weights and measures are approximate. Sony is a registered trademark of Sony Corporation.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project