MSDS
MATERIAL SAFETY DATA SHEET (MSDS)
Katun Corporation
10951 Bush Lake Road
Minneapolis, MN USA 55438
(952) 941-9505
PN:025513
Effective: November 24, 2004
Replaces edition dated:
SECTION 1 - IDENTITY OF PRODUCT
Katun Toner for use in: Sharp AR M 208, M 208 N, M 236, M 237, M 276, M 277, N 275, 235,
275, AR 5127, IM 2315, IM 2715
Katun PN: 025513
________________________________________________________________________________
SECTION 2 - INGREDIENT INFORMATION
Hazardous Components
Colorant
CAS#
Proprietary
Weight %
< 10 %
Non-hazardous Components
Resin
Wax
CAS#
Proprietary
Proprietary
Weight %
< 95 %
<5%
SECTION 3 - HAZARD IDENTIFICATION
Inhalation:
Eye/Skin:
Ingestion:
Acute and Chronic:
Chronic:
Irritation of respiratory tract my occur in heavy dust conditions
Irritation of eyes.
None known or determined for the product.
None known health hazard when used as intended in a copy machined
None known or determined for the product.
SECTION 4 - FIRST AID MEASURES
Swallowed:
Skin Contact:
Eye Contact:
Inhaled:
Drink water if ingested.
Wash contaminated areas with soap and water.
Flush eyes thoroughly with water. Seek medical attention if irritation persists.
Remove victim to fresh air.
N/A = Not Applicable
Page 1 of 3
MATERIAL SAFETY DATA SHEET (MSDS)
PN:025513
SECTION 5 - FIRE-FIGHTING MEASURES
Flash Point and Method: NA
Flammable Limits In Air: NA
Fire Extinguishing Media: Water fog, foam, dry chemical, CO2
Unusual Fire and Explosion Hazards: None
SECTION 6 - ACCIDENTAL RELEASE MEASURES
Steps to be taken in case material is released or spilled: Vacuum or sweep up as with any non-toxic
powder.
SECTION 7 - HANDLING AND STORAGE
Storage Temperature:
Special Sensitivity:
Precautions:
Standard room temperature (68°F). Avoid excessive heat.
Do not store next to strong oxidizers.
Eye protection and respirators may be required for bulk handling.
SECTION 8 - EXPOSURE CONTROLS
Respiratory Protection: Not necessary.
Ventilation:
Mechanical ventilation is acceptable.
Protective Gloves:
None required when product is used as intended.
Eye Protection:
None required when product is used as intended.
Other Protective Clothing or Equipment: None required when product is used as intended.
Work/Hygienic Practices: Avoid breathing dust if sample is spilled
SECTION 9 - PHYSICAL & CHEMICAL PROPERTIES
Boiling Point:
Specific Gravity (H2O=1):
Relative Vapor Density (Air=1):
Relative Evaporation Rate (Butyl Acetate=1):
Physical State:
Odor:
Solubility in Water:
NA
1.3-1.8
NA
NA
Solid
Faint
Insoluble
SECTION 10 - STABILITY AND REACTIVITY
N/A = Not Applicable
Page 2 of 3
MATERIAL SAFETY DATA SHEET (MSDS)
Stability:
Stable
Conditions to Avoid:
Avoid open flame.
Incompatibility (Materials to Avoid):
Hazardous Decomposition or Byproducts:
Hazardous Polymerization:
PN:025513
None with common materials with which the product may
reasonably come into contact.
Toxic decomposition products formed on combustion.
None
SECTION 11 - TOXICOLOGICAL INFORMATION
No information available.
SECTION 12 - ECOLOGICAL INFORMATION
No information available.
SECTION 13 - DISPOSAL CONSIDERATIONS
Waste Disposal Method:
Dispose of in accordance with local, state or federal regulations.
SECTION 14 - TRANSPORT INFORMATION
D.O.T. Shipping Name:
Not regulated.
SECTION 15 - REGULATORY INFORMATION
OSHA Status:
TSCA Status:
SARA Title III:
Not regulated
This product meets the requirements of the Toxic Substances Control Act.
Product not listed. SARA listed ingredients at or above De Minim reporting levels are
noted in paragraph 2, if any.
RCRA Hazardous waste number/status: If discarded in its purchased form, this product would not be a
federal hazardous waste either by listing or by characteristic. States, however, often
have stricter criteria. Users should check with their state regulatory agencies for current
hazardous waste criteria. Under RCRA it is the responsibility of the product user to
determine at the time of disposal whether a materiel containing the product or derived
from the product should be classified as a hazardous waste (40CFR261.20-24).
SECTION 16 - OTHER INFORMATION
All information appearing herein is based upon data obtained from the manufacturer and/or recognized
technical sources. This information is believed to be correct, but does not purport to be all inclusive and shall
be used only as a guide. It is the user’s responsibility to determine the suitability of this information for the
adoption of necessary safety precautions and/or compliance with federal, state, and local laws and regulations.
N/A = Not Applicable
Page 3 of 3
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising