s1 series
S1 SERIES
S.C.S. SMART CONTROL SYSTEM
FILTER SYSTEM
Air cycle during normal operation
1. Turning on and function selector
The blue backlighting indicates
that the extractor is ready to be
started. Selection of the manual
of the manual - automatic mode.
Regulation of engine power from
350 W to 1200 W, in the manual or
automatic automatic mode.
Air cycle during filter cleaning
4. Multifunction LED
GREEN
Motor on. The led lights up each time
extraction is activated.
The silent operation of the extractor
makes this type of signal necessary.
AUTOMATIC FILTER CLEANING
YELLOW
Cartridge filter
To ensure maximum extraction efficiency under all working conditions, the S1 version E extractors have an automatic filter cleaning
system (Rupes patent). By means of a system of valves, the air flow passing through the filters is inverted in alternation every 30
seconds, thus ensuring efficient cleaning action. With this innovative system, the operator is able to continue working without any
interruption of or reduction in the extraction process.
2. Selection of the diameter of the extraction
hose (M version)
To ensure operator safety, the
extractors in the M version, are
equipped with a system for controlling
the suction power. The system emits
an alarm if the speed of the air in the
extraction hose drops below the safety
levels. For proper functioning of the
extractor, set the specific selector
on the diameter of the hose utilized
before starting to work.
Container for liquids full (E versions).
This led switches on to signal the
blocking of the extractor when the
level of liquids in the container has
exceeded the maximum level.
All the vacuum cleaner in the S1 Series are equipped with a double panel filter for
a total of 1 sq. meter of filter surface area. All vacuum cleaner, in both the L and
M versions, are supplied with a filter made of material certified for class M dust
extraction. The H versions are instead supplied with filters for the higher dust class,
i.e., H. Two versions of the filters are available:
paper filters for extraction of fine and dry dust;
polyester filters: washable filters suitable for extraction of fine and dry dust.
Recommended for the extraction of liquids without the need for a filter bag.
3. Connection of tools for automatic starting of
the extractor
Filter bags
RED
Service. This led signals the need for
routine maintenance to be carried out at
an Authorized RUPES Service Center.
There are two different types of filter bags for the S1 series vacuum cleaner:
polyethylene bags recommended for dust and debris originating from cleaning procedures
filter bags in polyester for class M dust
Container drums
The S1 series vacuum cleaners are available in two versions with 30 and 45-liter
drums. Their special structure ensures their resistance and manageability during
movement in all workplaces. Their shape enables maximum expansion of the filter
bag, fully using the volume of space provided by the drum.
Option of connecting one electric tool of up to 2400 W of power and one
pneumatic tool, or two pneumatic tools.
Vacuum cleaner connector attachment
All vacuum cleaner in the S1 series are supplied with a multipurpose swivel extraction attachment that makes it possible to use extraction hoses with diameters
of 25, 29, 38 and 50 mm, making the extractor adaptable to any application.
CHARACTERISTICS
EFFICIENCY AND ORGANIZATION
Equipped with
- Swivel connection Ø50mm
- Hose assembly, Ø29 mm
- Filter bag M Class (L and M versions) (code 130.1108)
Air regulator
S 145
TECHICAL SPECIFICARIONS
S 130
W
1x1200
1x1200
Kg
10,5
13,5
2400
Max. power supplied by power outlets
W
2400
Pressure
mm/h2o
2000
2000
Noise level
dB(A)
70*
73*
Container volume
l
30
45
Air flow rate
m3/h
165**
165**
L
L-M
Indicted for dust classes
51 cm
Thanks to the new connector attachment with an air
regulator patented by RUPES, the hose for connection
with pneumatic tools ensures maximum extraction
efficiency. In fact, the regulator makes it possible to
obtain the correct air flow rate and thus to optimize
extraction based on the type of application.
Power
Weight
Connection for 2 hoses
Filter surface area
m2
1
1
Connectable tools
n
1
1
Electrical outlets for tools
n
1
1
Air connections for tools
versions
P
P
Automatic filter cleaning
versions
E
E
Ø internal connector attachment
mm
50
50
Feed pressure
bar
6
6
Max.air flow rate
l/min
1450
1450
63,5 cm
S 130
S145
PNEUMATIC VERSION:
43 cm
45 cm
*dB(A) According to EN 60704-3 standard
**According to EN 60335-269 standard
Extracted dust classification
The 2-way union complete with 1 clapet valve enables
the use of two tools simultaneously. One electric and
one pneumatic or two pneumatic tools can be connected
to the vacuum cleaner at the same time.
Storage compartment
Support plane
Tool holder
L Versions
M Versions
H Versions
Class L dust extractors with a
maximum tolerated exposure
value > 1.0 mg/m3 (according to
the EN60335-2-69/A2 standard).
Class M dust extractors with a
maximum tolerated exposure
value > 0.1 mg/m3 (according to
the EN60335-2-69/A2 standard),
and a selector for the extraction
hose diameter.
Class H dust extractors with a
maximum tolerated exposure
value > 1.0 mg/m3 (according to
the EN60335-2-69/A2 standard).
And selector for the extraction
hose diameter.
TYPICAL APPLICATIONS
In the rear part of the 45-liter vacuum
cleaner, there is a capacious attachment
storage compartment, where the power
cord and the extraction hose can be
stored after use.
In the upper part of the head of the S 130
and S 145 extractors, there is a convenient,
multipurpose shelf where tools and related
attachments can be stored.
The practical support is available
on request for the S 145 series.
The practical toolholder turns the
vacuum cleaner into a convenient
and functional work station.
SUGGESTED VERSION
Fine dust, subject to the general limit
for dust, i.e., 3 mg/m3
L, M, H
Dust from mineral substances
containing aluminium oxide
L, M, H
Paint dust
*(L) M, H
Wood dust
M, H
Plaster or chalk dust
M, H
Zinc chromate dust
H
Dust containing PAH**
H
Asbestos dust
H
*(L): Use is possible, but with some restrictions. **PAH: Polycyclic aromatic hydrocarbons.
NOTE: The suggest versions are indicative. You are advised to check current regulations and standards.
ACCESSORIES
S130
Professional vacuum cleaner predisposed for connection with
electric and pneumatic tools, with automatic cleaning of the
filters (E version)
S 130
S 130PL
AUTOMATIC FILTER CLEANING
AUTOMATIC STARTING OF
ELECTRIC TOOLS
•
AUTOMATIC STARTING OF
PNEUMATIC TOOLS
•
INDICATED FOR DUST CLASSES
S 130EPL
•
•
•
•
•
•
LIQUIDS SENSOR
L
L
•
L
ANTISTATIC HOSE ASSEMBLY FOR ELECTRIC TOOL
L
•
FILTER MADE OF PAPER
HOSE ASSEMBLY FOR PNEUMATIC TOOL
ANTISTATIC HOSE ASSEMBLY FOR PNEUMATIC TOOL
S 130EL
•
HOSE ASSEMBLY
ANTISTATIC HOSE ASSEMBLY
HOSE ASSEMBLY FOR ELECTRIC TOOL
•
FILTER MADE OF POLYESTER
•
WHEELS WITH BRAKE LOCK
•
•
•
•
•
POWER REGULATOR EXTRACTOR
•
•
•
•
SERVICE INDICATOR
•
•
•
•
Description Antistatic hose assembly Antistatic hose assembly Antistatic hose assembly Antistatic hose assembly Antistatic hose assembly Antistatic hose evaflex (in roll) S145
Professional vacuum cleaner predisposed for connection with
electric and pneumatic tools, with automatic cleaning of the
filters (E version)
S 145L
AUTOMATIC FILTER CLEANING
AUTOMATIC STARTING OF
ELECTRIC TOOLS
•
AUTOMATIC STARTING OF
PNEUMATIC TOOLS
S 145PL
S 145EL
S 145EPL
S 145EM
S 145EPM
•
•
•
•
•
•
•
•
•
•
•
LIQUIDS SENSOR
INDICATED FOR DUST CLASSES
L
L
•
•
•
•
L
L
M
M
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
FILTER MADE OF PAPER
•
FILTER MADE OF POLYESTER
•
ATTACHMENT STORAGE COMPATMENT
•
•
WHEELS WITH BRAKE LOCK
•
POWER REGULATOR EXTRACTOR
SERVICE INDICATOR
Tool holder support for S 145
series extractors
Code
9GAT02004/AS
9GAT02001/AS
9GAT02002/AS
9GAT02003/AS
9GAT02014/AS
9.1264/30/AS
Description Hose assembly Hose assembly Hose assembly Hose assembly Hose assembly Hose assembly Hose assembly Evaflex hose (in roll) Evaflex hose (in roll) Hose assembly
Polyester filter
Size Ømm Tools 5m 25 electric 5m 29 pneumatic 5m 29 electric 8m 29 pneumatic 8m 29 electric 5m 38 pneumatic 8m 38 pneumatic 30m 29 -
30m 25 -
10m 29 pneumatic
•
ACCESSORIES
Description
Model
Tool holder support
series extractors
S 145
Paper extraction filter
S 130 / 145
Fleece bag
S 130/S 145
Polyethylene disposal bag
S 130 / S145
Qty/pkg.
Code
049.1108/C
1
036.1108
030.1108/5
5
Code
9GAT02014/C
9GAT02004/C
9GAT02001/C
9GAT02002/C
9GAT02003/C
9GAT02019/C
9GAT02023/C
9.1264/30
9GT03047/30
9GAT02021/C
Polyethylene disposal bag
Fleece bag
•
•
DIAMETER SELECTOR HOSE
Size Ømm Tools 5m 29 pneumatic 5m 29
electric
8m 29 pneumatic
8m 29
electric
5m 25
electric
30m 29
-
052.1108/5
Due to its constant desire to improve its products, RUPES S.p.A. reserves the right to make any technical or design modification to its products without prior notice.
The manufacturer shall not be responsible for printing errors. This document voids and replaces previous ones.
RUPES S.p.A
Via Marconi 3A
20080 Vermezzo (MI) - Italy
T +39 - 02.94.69.41
F +39 - 02.94.94.10.40
E rupes@rupes.it
W www. rupes.com
RUPES USA, Inc.
Follow us on:
14320 Longs Peak Court
Longmont, CO 80504-9698 USA
T +1-970-535-0100
F +1-303-723-8680
E orders@rupesusa.com
W www.rupesusa.com
9.Z859/16/GB
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising