SX1068 Software Upgrade for Netflix Repair

SX1068 Software Upgrade for Netflix Repair
SX1068 Software Upgrade for Netflix Repair
Please read carefully before proceeding with the software upgrade
•
•
•
•
•
•
Tablet must be fully charged before proceeding.
This software upgrade will erase all your personal data from the tablet and revert the tablet back to
factory reset form, please backup your personal information before proceeding.
Use single card reader with this software upgrade because some multi-card reader may not fully
read the whole software.
After upgrade, SD card must be removed immediately from the tablet before powering up the
tablet again.
To use the SD card again for any other purpose, please follow instruction at the end to erase the
card, otherwise it will perform upgrade every time you put the SD card into any computer or tablet
and start the upgrade automatically.
After you downloaded the Phoenixcard (software burning tool) and A20_0329_1122 (software img
file), make sure that they are both installed in your PC before proceeding.
Procedures
1. Installation
After unzipping Phoenixcard file, open the file PhoenixCard.exe to run the software.
2. Phoenix Software interface
PhoenixCard software interface will appear as follows :
3. Inserted the card reader with micro SD card to the PC drive.
4. Click
Select the corresponding letter that matches the card reader drive.
When there are multiple removable storage devices(RSD), select the corresponding drive letter of the
card reader.
Note: One suggestion is not to insert other RSDs when programming this SD card to avoid data
corruption caused by the faulty operation.
5. Click on this button
to open img. file selection dialog box.
Select the firmware which is to be programmed (A20_0329_1122).
6. For Write Mode, Choose
7. Click on this button
8. Programmed message will display in the box as below :
9. When you see the words “Burn End”, the burning of the SD card has completed.
10. Before proceeding with software upgrade on your tablet, please backup any data that you need on
the tablet. Once you did the software upgrade, all you personal data will be removed from the
tablet.
11. Remove SD card from reader and insert card in the side slot of SX1068 (power should be off when
inserting the card). After inserting the card, click power on for software update, you should see the
following picture:
Note: At the same time, do not do any other operation. Otherwise, the data in SD card will be removed.
11. Wait until the upgrade is completed, the unit will power off by itself.
12. Remove the SD card and power unit on, the upgrade is now completed and Netflix will work properly on
SX1068.
Operation to recover formatted card
Steps are as follows:
Step one: Run phoenixcard.
Step two : Inserted the card reader with micro SD card to the PC drive
Step Three : Click
Step Four : Select the corresponding letter that matches the card reader drive
When there are multiple removable storage devices(RSD), select the corresponding drive letter of the card reader.
Note: One suggestion is not to insert other RSDs when SD card is programmed to avoid data corruption caused by
the faulty operation.
Step five : Click the following button to restore the format operation.
Step Six: Pull out the card, now you can use this SD card again for other purpose.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising