Replacing the fuser assembly

Replacing the fuser assembly
Replacing the fuser assembly
1
Printing
Order a new fuser assembly when toner fog or background shading appears on printed
pages. See Ordering supplies for information on ordering a fuser assembly.
Paper handling
Complete the following steps to replace the fuser assembly. Refer to the documentation that
comes with the fuser assembly for detailed installation information.
CAUTION! The fuser assembly is hot! Turn the printer off and wait twenty minutes
Maintenance
before changing the fuser assembly.
1 Turn the printer off, unplug the printer power cord, and wait twenty minutes.
Troubleshooting
2 Remove the top cover and all installed output options. If a duplex unit is installed,
remove it.
3 Remove the fuser cover.
Administration
4 Lift up and remove the fuser cleaner.
5 Open the rear access door and remove the redrive.
Index
6 Remove the old fuser assembly.
Note: For best results, use Lexmark supplies with the printer. If you are in the
U.S. or Canada, call 1-800-438-2468 for information about Lexmark
Authorized Supplies Dealers in your area. In other countries, contact the
place where you bought your printer.
www.lexmark.com
Lexmark T620 and T622
Replacing the fuser assembly
Printing
7 Install the new fuser assembly and replace the redrive.
8 Close the rear access door and replace the fuser cover.
Paper handling
9 If you have a duplex unit, reinstall it. Reinstall all output options and the printer top
cover.
Maintenance
10 Plug the printer power cord into a properly grounded electrical outlet.
11 Reset the maintenance counter.
Troubleshooting
Administration
Index
www.lexmark.com
Lexmark T620 and T622
2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising