Saddle Valve assembly installation

Saddle Valve assembly installation
SADDLE VALVE ASSEMBLY
Installation Instructions:
1. To assemble the saddle valve to existing water source:
Place the saddle valve over and around your existing 3/8” copper tubing. Evenly tighten
the securing screws so that the saddle valve is securely fastened onto the copper tubing.
DO NOT OVERTIGHTEN, THIS MAY CAUSE THE COPPER TUBING TO CRIMP AND
REDUCE FLOW.
2. To Mount the Female Quick Disconnect:
YOU HAVE TWO OPTIONS.
Option “A”
Take the other end of the 1/4” water
tubing that comes from the saddle
valve and connect it to the female
quick disconnect. This is done by
placing the hose coupling nut over
the water tubing and placing the
hose into the back of the female
quick disconnect, then tightening the
coupling nut.
A-44303 Saddle valve assembly
Option “B”
w/female connector & tubing
If you wish, the female quick
disconnect may be mounted directly
through the sink top or vanity counter. If you choose this way, you must first drill a
1/2” diameter hole through the surface in the space desired. (see Diagram “B”)
Then mount the female quick disconnect and tighten the mounting nut to securely
hold it in place. Then proceed to place the hose coupling nut over the 1/4” water
tubing. Place this tubing into the back of the female quick disconnect and tighten
the hose coupling nut securely.
3. To Pierce Existing Water Tube:
You are now ready to pierce the copper tube. Turn the handle of the saddlevalve in
a CLOCKWISE direction until it will go no further. The Saddle valve is now installed
and in the OFF position. Turn the handle of the Saddle valve counter-clockwise
until resistance is felt. Water is ready to flow into the dental unit. Check for leaks.
4. To Connect the Scaler to the Quick Disconnect:
Push the male quick disconnect from the scaler into the female quick disconnect
until they lock and installation is complete.
22
Securing screws
3/8” Copper tubing
Rubber Gasket
Securing nut
Hose coupling nut
Mounting nut
1/4” Tubing
Female quick
disconnect
Option A
W
A
L
L
Option B
Engler Engineering Corporation will not be held liable for any damage including, but not limited
to leakage caused by improper installation of our products.
23
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising