Ethernet EGX100 gateway

Ethernet EGX100 gateway
EthernetEGX100gateway
Converters
Function
PB0
E90
The EGX100 serves as an Ethernet gateway for PowerLogic® System devices and
for any other communicating devices utilizing the Modbus protocol.
The EGX100 gateway offers complete access to status and measurement
information provided by the connected devices, for example, via the System
ManagerTM Software (SMS) installed on a PC.
DE52790
Architecture
4
Setup
SetupviaanEthernetnetwork
Once connected to an Ethernet network, the EGX100 gateway can be accessed by
a standard internet browser via its IP address to:
bspecify the IP address, subnet mask, and gateway address of the EGX gateway
bconfigure the serial port parameters (baud rate, parity, protocol, mode, physical
interface, and timeout value)
bcreate user accounts
bcreate or update the list of the connected products with their Modbus
communication parameters
bconfigure IP filtering to control access to serial devices
baccess Ethernet and serial port diagnostic data
bupdate the firmware.
Setupviaaserialconnection
Serial setup is carried out using a PC connected to the EGX100 via an RS232 link.
This setup:
bspecifies the IP address, subnet mask, and gateway address of the EGX gateway
bspecifies the language used for the setup session.
9
Livre 1.indb 197
18/04/2007 11:02:36
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising