Yaesu FT-2900R Step-by-Step Programming Guide

Yaesu FT-2900R Step-by-Step Programming Guide
Yaesu FT-2900R Step-by-Step Programming Guide
Noji Ratzlaff
Set the radio to communicate with a repeater at 147.080+ MHz, 77.0 Hz
Note: ‘SET’ means to press and hold the MHz/SET button
0.
Turn on the radio and make sure it’s unlocked
1.
Press D/M R once or tw ice until the display
reads VFO
2.
Set the frequency
5.
Select the transm it pow er level
press LOW repeatedly
6.
Set the squelch type
SET - 49 - M Hz - TONE - M Hz - SET
1-4-7-0-8-0
or for repeaters that send a tone
3.
If the + sign appears at the top, skip to step 5.
4.
Set auto repeater shift
SET - 49 - M Hz - TSQL - M Hz - SET
7.
Set the tone
SET - 4 M Hz - ON - M Hz - SET
SET - 52 - M Hz - 77.0 - M Hz - SET
Your radio is now set to transm it as specified
Store and name the current repeater and tone settings in a memory channel
0.
Follow the procedure above to set your radio
for the frequency of your choice
1.
Press and hold M W
2.
Rotate the large dial to select the memory
channel to store the frequency
4.
Set the channel nam e
SET - 30 - M Hz - dial - LOW - M Hz - SET
(Press REV for backspace)
3.
The stored m em ory channel now has a name
Press and hold M W to store the frequency
The frequency is now stored in radio memory
Recall the memory channel for transmitting
1.
M om entarily press M W
2.
Turn the big knob to the channel of your choice
The stored channel is now ready for use
Set the radio to communicate at 146.740 MHz simplex
Note: the Yaesu FT-2900R will automatically turn
off repeater offsets if its current frequency falls
within the simplex ranges of the ARRL Band Plan
and the ARS (menu item 4) setting is ON. So, if
the simplex frequency you select is outside these
ranges, you must first set ARS to OFF.
3.
If neither the + nor - sign appears at the top,
skip to step 5.
4.
Disable auto repeater shift
0.
Turn on the radio and make sure it’s unlocked
5.
1.
Press D/M R once or tw ice until the display
reads VFO
2.
Set the frequency
SET - 4 M Hz - OFF - M Hz - SET
Set the squelch type
SET - 49 - M Hz - OFF - M Hz - SET
6.
Set the transm it pow er level
press LOW repeatedly
1-4-6-7-4-0
Your radio is now set to transm it simplex
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising