GeoVision Technical Handbook 9 2.1.2 IP Camera Setup 1. In

GeoVision Technical Handbook 9 2.1.2 IP Camera Setup 1. In
2.1.2 IP Camera Setup
1. In Multicam, click on “Configure” icon.
2. Select “General Setting” -> “Camera/Audio Install” -> “IP Camera Install”.
3. If IP address is known, select “Add Camera” to
manually add the camera by entering the IP address, port,
user name, password, and camera model manually.
 GeoVision IP Device’s default user name and
password is admin/admin
4.
Otherwise, select “Scan Camera”.
a. In the search result, double-click on the desired
IP Camera and enter the “User name” and
“Password” of the IP Camera.
b. Select “Query”.
c. Click on “Dual Streams” button to switch from
single stream to dual-stream model, if applicable.
d. Click on “Apply”.
e. Click on “Close”.
f.
Right-click on the IP Camera in the IP Device
Setup window.
g. Select “Display position” then map the camera
on to desired camera position.
h. When the status of the connection changed to
“Connected”, click on “OK”.
 For detailed instruction, refer to p.123 of v8.4 User Manual
GeoVision Technical Handbook 9
2.1.3 Image and Audio Setup
1. In Multicam, click on “Configure” icon.
2. Select “General Setting” -> “Camera/Audio Install” -> “IP Camera Install”.
3. Right-click on the IP camera and select “Preview & Audio Setting”.
4. To flip the image, select the corresponding option under Image Orientation.
5. To enable audio, check “Wave Out”.
6. To enable audio recording, check “Rec Audio”.
a. Adjust Monitor Sensitivity to adjust audio detection sensitivity.
b. Adjust Gain Control to increase or decrease audio volume.
 High gain may result in increased noise and decreased I audio quality.
c. Select “Round-the-Clock Audio” for 24/7 audio recording.
7. Click “OK”.
8. Click “OK” again to exit IP Device Setup.
 For detailed instruction, refer to p.126 of v8.4 User Manual
GeoVision Technical Handbook 10
2.1.4 On Demand Display
On Demand Display is only applicable to IP devices which support dual-stream funciton. Dual-stream can
be enabled on GeoVision IP cameras via the web interface. For more information, refer to IP Camera’s
user manual.
1. In Multicam, click on “Configure” icon.
2. Select “General Setting” -> “Camera/Audio Install” -> “IP Camera Install”.
3. Right-click on the IP camera and select “On Demand Display”.
4. Select Enable or Disable.
5. Select the resolution limit for higher resolution streaming.
a. For the example above, with resolution limit of 800x600, the IP camera will stream
320x256 resolution by default when the camera is viewed in multiple-channel division.
The IP camera will stream 1280x1024 instead when going into four-division view or
single-channel view, when live view resolution of the camera is greater than 800x600.

For detailed instruction, refer to p.137 of v8.4 User Manual
GeoVision Technical Handbook 11
2.1.5 Supported IP Device Brands List
GeoVision v8.4 software supports the following IP device brands.
To view a specific list of IP device models supported associated with each brand, visit GeoVision’s
website at http://www.geovision.com.tw/english/4_21.asp
GeoVision Technical Handbook 12
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising