Devilink RS

Add to my manuals
8 Pages

advertisement

Devilink RS | Manualzz
GB-DAS
Devilink™ RS
Installation Manual
Devilink™ RS
The Devilink™ RS (Room Sensor) has a built-in temperature sensor which measures the ambient temperature. It
allows you to control the heating based on room temperature, in the room where installed. With the Devilink™ RS
you can also adjust the temperature.
Installation scenario:
Devilink™ CC
Devilink™ FT
Ambient temperature
Floor temperature
Communication/link test
Battery warning
Tamper proof. Locked by CC
2
Placement of Devilink™
DevilinkTM RS
Not on a wall where it will be subjected to direct
sunlight.
Installation height should typically be between
80-150 cm.
In wet rooms it should be installed on an even
surface, according to local building regulations.
At least 50 cm away from windows/doors that
will be left open occasionally.
Not on the inner side of a wall facing the
outside.
3
3. Light indications
Installation
of Devilink™
(LED) RS
1.Remove the front cover by gently
pressing the release tab on the
bottom side of the sensor.
2. Mount the room sensor
a. Mark up drill holes
b. Drill holes
c. Place fixing plugs in holes
d. Screw mount the RS
3. Mount batteries
4.Put front cover on by placing the top
of the cover in place first and then
gently press the bottom end in place.
Configuration:
See Step-by-Step guide in Devilink™ CC instruction
manual.
4
Trouble shooting
Short green flash
Not included in network
Green fast flash
Inclusion in progress
Red flash +
for 5 sec.
Inclusion failed
ON
Link test in progress
Red flash +
for 5 sec.
Link test failed
ON + Red LED
flash every 2½ min.
Low battery level
ON + Red LED
flash every 30 sec.
Critical battery level
E5
Floor sensor short circuited
E6
Floor sensor lost
ON
Tamper proof enabled by
Devilink™ CC
Flash
Limited by Devilink™ CC
Factory reset a Devilink™ RS:
Take the front cover off . Take out one battery and hold the
ON/OFF/Install button down while reinserting the battery.
Keep holding down the install button until it flashes (approx. 5 sec.)
5
Technical specifications
Battery
Alkaline 2xAA, 1.5V
Battery lifetime
Up to 4-5 years
Backlight
Green LED
Ambient temperature
-10˚ to +35˚C
Battery monitoring
The sensor has a built-in
monitoring circuit, which will
detect low or critical battery
level.
Transmission
frequency
868.42MHz
Transmission range in
normal buildings
Up to 30m
Transmission power
Max. 1 mW
IP class
21
Dimensions
81 mm x 66 mm x 21 mm
Disposal Instruction:
Equipment containing electrical components should not
be disposed together with domestic waste.
It must be collected separately with other electrical and
electronic waste according to local legislation.
6
The 2 Year DEVI Warranty
You have purchased a DEVI heating system
which we are sure will serve to improve the
comfort and economy of your application.
DEVI provides superior electrical heating solutions for total climate control in and around
homes and buildings. DEVI offers a complete
product program with DeviflexTM heating cables
or DevimatTM heating mats, DeviregTM thermostats, DevifastTM fixing strips and Devi Self-limiting heating cables combined with additional
products completing the product program.
This 2 year warranty applies to all DEVI products.
Should you, against all expectations, experience
a problem with your DEVI product, you will find
that DEVI offers a 2 year warranty from the date
of purchase on the following conditions:
During the warranty period DEVI shall offer a
new comparable product or repair the product
in case the product is found to be faulty by reason of defective design, materials or workmanship. Repair or replacement shall be carried out
at DEVI’s discretion. DEVI shall not be liable for
any consequential or incidental damages in-
cluding, but not limited to, damages to property
or extra utility expenses.
This warranty shall only be valid on production
of proof of purchase and must be submitted to
the installer or seller without undue delay.
An extension of the warranty period following
repairs undertaken under warranty cannot be
granted.
The DEVI Warranty shall not cover any damage
caused by incorrect conditions of use, incorrect
installation or if installation has been carried out
by non-authorised electricians. All work will be
invoiced in full if DEVI is required to inspect or
repair faults that have arisen as a result of any
of the above.
The DEVI Warranty shall not extend to equipment which has not been paid in full.
DEVI will, at all times, provide a rapid and effective response to all complaints and inquiries
from our customers.
The warranty explicitly excludes all claims exceeding the above conditions.
Warranty Certificate
The DEVITM Warranty is granted to:
Name:
Address:
Country:
City:
Telephone:
Attention:
The Warranty Certificate must be completed correctly for the Warranty to be valid.
Please read the Warranty conditions above.
Type of thermostat:
Electrical installation by:
Article number:
Date:
Suppliers Stamp:
8
VICKC102
DEVI A/S
DK • 7100 Vejle
Phone +45 7488 8500
Fax +45 7488 8501
09/2009
Article: 08095916
Version: 01.01

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement