ASWP Series Weatherproof Horn Strobes
Fire Alarm Systems | ASWP Series Weatherproof Horn Strobes
ASWP Series Weatherproof Horn Strobes
▶ 24 VDC, filtered or unfiltered
▶ Wall or ceiling mount models
▶ Selectable continuous horn or temporal (Code 3) tones
each with three selectable volume settings
▶ Synchronize with SM and DSM modules
▶ Cost‑efficient two‑wire operation with low profile
design
▶ Suitable for outdoor use when mounted on a WPBB
back box
The Wheelock ASWP Series consists of 24 V, square horn
strobes for use with a WPBB‑R Weatherproof Back Box in
outdoor and extreme environment applications. The series
includes wall and ceiling mount models. The strobe is listed
as 75 cd on axis at -31°F (‑35°C). Choose between
continuous horn or temporal pattern (Code 3) tone when
constant voltage from the fire alarm control panel (FACP)
is applied. Each tone has three field-selectable volume
levels.
Synchronize these horn strobes with the SM (single) or
DSM (dual) modules or a compatible control panel. The
audible response can be silenced while maintaining strobe
activation, a requirement in some jurisdictions.
Note
These products are not suitable for
hearing‑impaired applications.
Certifications and Approvals
Cooper Wheelock, Inc. holds these Listings and Approvals:
Region
Certification
USA
UL
CSFM
ULSZ: Audible Signal Appliances (UL464),
UUKC: Signaling Appliances and
Equipment for the Hearing Impaired
(UL1971)
2475W model only: 7125-0785: 131
NYC/MEA
151‑93‑E, Vol. 26
CBFP
City of Chicago Bureau of Fire Protection
ADA
Complies with Americans with Disabilities
Act
ANSI
Complies with American National Standards Institute ANSI 117.1
NFPA
Complies with National Fire Protection Association NFPA 72
OSHA
Complies with Occupational Safety and
Health Administration OSHA 29
Part 1910.165
Installation/Configuration Notes
Compatible Products
The following products are compatible with the ASWP
Weatherproof Horn Strobe:
Category
Product ID
Product Description
Control
D70221
Conventional FACP
Panels
D70242
Addressable FACP
D7024
Conventional FACP
D80241
Analog FACP
D91241
Addressable FACP
D10024A1
Analog FACP
www.boschsecurity.com
2 | ASWP Series Weatherproof Horn Strobes
Modules
SM‑12/24‑R
Synchronization module (red)
Mechanical Properties
DSM‑12/24‑R
Dual synchronization module (red)
Dimensions
(H x W x D):
4-13/16 in. x 4-13/16 in. x 2-1/2 in.
(12.2 cm x 12.2 cm x 6.4 cm)
Material:
Molded plastic enclosure incorporating a Xenon flashtube and Lexan lens.
Candela Ratings
(on axis):
75 cd at -31°F (-35°C)
180 cd at +77°F (+25°C)
1
For synchronization, use the SM or DSM modules with
these control panels. The synchronization module must be
set for 24 V operation. When used, the D7022 must be set
for 24 VDC operation.
2 When used with a D7039 Multiplex Expansion Module, the
D7024 becomes an addressable fire alarm control panel
(FACP).
Mounting Considerations
Outdoor or Severe Environment Applications
For an outdoor application or a severe environment
(NEMA 3R) application, mount the horn strobe and a
WPBB‑R Weatherproof Back Box on a flat wall or ceiling so
the entire rear surface of the back box is covered. The drain
holes in the back box must point toward the ground. The
knockouts on the rear surface of the back box must remain
intact.
Power Requirements
Current (maximum RMS)
High dBA
168 mA VDC; 235 mA FWR
Medium dBA
155 mA VDC; 225 mA FWR
Low dBA
150 mA VDC; 220 mA FWR
Voltage Ranges
24 V nominal:
16.0 to 33.0 VDC or FWR
Sound Output Ratings (reverberant dBA at 10 ft [3 m]) at 24 VDC
Continuous Horn
The knockout hole on top of the back box is sized for a
half‑inch conduit and matching connector. A proper
watertight conduit fitting must be used.
High Volume Setting:
91 dBA
Medium Volume Setting:
88 dBA
Low Volume Setting:
83 dBA
Mount these horn strobes on the indicated back box for the
indicated applications:
Temporal (Code 3) Horn
Conduit
Applications
WPBB‑R
•
Surface
Mounted
Flush
Mounted
•
All models have an attractive cover plate for a clean,
finished appearance.
Wiring
Note
Do not use these units in coded or pulsed
signaling circuits.
The input terminals accept wires with diameters between
18 AWG (1.2 mm) and 12 AWG (2.3 mm).
High Volume Setting:
87 dBA
Medium Volume Setting:
84 dBA
Low Volume Setting:
79 dBA
Trademarks
Trademark names are used throughout this document. In
most cases, these designations are claimed as trademarks
or registered trademarks in one or more countries by their
respective owners. Rather than placing a trademark symbol
in every occurrence of a trademark name, Bosch Security
Systems, Inc. uses the names only in an editorial fashion
and to the benefit of the trademark owner with no intention
of infringing the trademark.
Lexan is a registered trademark of General Electric Corporation, USA, in the
United States and other countries.
Parts Included
Quant.
Component
1
Horn strobe
1
Cover plate
1
Hardware pack
1
Literature pack
Technical Specifications
Environmental Considerations
Relative humidity:
Up to 95%, non‑condensing
Temperature (operating):
-31°F to +150°F (-35°C to +66°C)
ASWP Series Weatherproof Horn Strobes | 3
Ordering Information
ASWP‑2475W‑FR Weatherproof
Wall‑mount Horn Strobe (red)
Red, 24 V, wall‑mount device for use with a
WPBB‑R Weatherproof Back Box in outdoor
and extreme environment applications
ASWP-2475W-FR
ASWP‑2475C‑FR Weatherproof
Ceiling‑mount Horn Strobe (red)
Red, 24 V, ceiling‑mount device for use with a
WPBB‑R Weatherproof Back Box in outdoor
and extreme environment applications
ASWP-2475C-FR
ASWP‑2475C‑FW Weatherproof
Ceiling‑mount Horn Strobe (white)
White, 24 V, ceiling‑mount device for use with
a WPBB‑R Weatherproof Back Box in outdoor
and extreme environment applications
ASWP-2475C-FW
Accessories
WPBB‑R Weatherproof Back Box
Used to surface mount the ASWP Series
Weatherproof Horn-strobes for outdoor or severe environment applications
WPBB-R
www.boschsecurity.com
4 | ASWP Series Weatherproof Horn Strobes
Americas:
Bosch Security Systems, Inc.
130 Perinton Parkway
Fairport, New York, 14450, USA
Phone: +1 800 289 0096
Fax: +1 585 223 9180
security.sales@us.bosch.com
www.boschsecurity.us
Europe, Middle East, Africa:
Bosch Security Systems B.V.
P.O. Box 80002
5600 JB Eindhoven, The Netherlands
Phone: + 31 40 2577 284
Fax: +31 40 2577 330
emea.securitysystems@bosch.com
www.boschsecurity.com
© Bosch Security Systems Inc. 2010 | Data subject to change without notice
T3461921035 | Cur: en-US, V5, 4 Jul 2010
Asia-Pacific:
Represented by
Robert Bosch (SEA) Pte Ltd, Security Systems
11 Bishan Street 21
Singapore 573943
Phone: +65 6258 5511
Fax: +65 6571 2698
apr.securitysystems@bosch.com
www.boschsecurity.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising