INSTRUCTIONS AND WARRANTY

MODEL NO. SPF50E

SALTON ELITE PEDESTAL FAN 50CM

Congratulations on purchasing our Salton Elite Pedestal Fan. Each unit is manufactured to ensure safety and reliability. Before using this appliance for the first time, please read the instruction manual carefully and keep it for future reference.

IMPORTANT SAFEGUARDS

When using any electrical appliance, basic safety precautions should always be followed including the following:

1. Please read the instructions carefully before using any appliance.

2. Always ensure that the voltage on the rating label corresponds to the mains voltage in your home.

3. Incorrect operation and improper use can damage the appliance and cause injury to the user.

4. The appliance in intended for household use only. Commercial use invalids the warranty and the supplier can not be held responsible for injury or damage caused when using the appliance for any other purpose than that intended.

5. Avoid any contact with moving parts.

6. Close supervision is required when any appliance is used near or by children or invalids.

7. Check the power cord and plug regularly for any damage. If the cord or the plug is damaged, it must be replaced by the manufacturer or a qualified person in order to avoid an electrical hazard.

8. Do not use the appliance if it has been dropped or damaged in any way. In case of damage, take the unit in for examination and/or repair by an authorised service agent

9. To reduce the risk of electric shock, do not immerse or expose the motor assembly, plug or the power cord to water or any other liquid.

10. Never immerse the unit in water or any other liquid for cleaning purposes.

11. Remove the plug from the socket by gripping the plug. Do not pull on the cord to disconnect the appliance from the mains. Always unplug the unit when not in use, before cleaning or when adding or removing parts.

12. The use of accessory attachments that are not recommended or supplied by the manufacturer may result in injuries, fire or electric shock.

13. Do not let the cord hang over the edge of a table or counter. Ensure that the cord is not in a position where it can be pulled on inadvertently.

2

14. Do not allow the cord to touch hot surfaces and do not place on or near a hot gas or electric burner or in a heated oven.

15. Do not use the appliance on a gas or electric cooking top or over or near an open flame.

16. Use of an extension cord with this appliance is not recommended. However, if it is necessary to use an extension lead, ensure that the lead is suited to the power consumption of the appliance to avoid overheating of the extension cord, appliance or plug point. Do not place the extension cord in a position where it can be pulled on by children or animals or tripped over.

17. This appliance is not suitable for outdoor use. Do not use this appliance for anything other than its intended use.

18. DO NOT carry the appliance by the power cord.

19. Do not leave this appliance unattended during use. Always unplug the unit when not in use or before cleaning.

20. Always operate the appliance on a smooth, even, stable surface. Do not place the unit on a hot surface.

21. Ensure that the switch is in the “Off” position after each use.

22. Do not cover the grill, or use the unit in close proximity to curtains or other hanging materials.

23. The manufacturer does not accept responsibility for any damage or injury caused by improper or incorrect use, or for repairs carried out by unauthorised personnel.

24. In case of technical problems, switch off the machine and do not attempt to repair it yourself. Return the appliance to an authorised service facility for examination, adjustment or repair. Always insist on the use of original spare parts. Failure to comply with the above mentioned pre-cautions and instructions, could affect the safe operation of this machine.

25. In case of technical problems, switch off the machine and do not attempt to repair it yourself. Return the appliance to an authorised service facility for examination, adjustment or repair. Always insist on the use of original spare parts. Failure to comply with the above mentioned pre-cautions and instructions, could affect the safe operation of this machine.

3

ASSEMBLY OF THE BASE SECTION

1. Attach the weight to the bottom of the stand using 4 screws.

2. Attach the column to the stand with 4 screws

3. Unscrew and take off the height adjustment screw

4. Slide the stand cover down the column to rest on the stand.

5. Pull up the height extension tube and refit the height adjustment screw. Tighten the height adjustment screw before assembling the top section of the fan.

6. Fit the motor section to the height extension tube and tighten the thumbscrew. Ensure that the thumbscrew is fully tightened before operating the unit. Tighten the tilt adjustment knob.

7. Remove the fibre glass sleeve from the shaft, and unscrew the rear guard retaining nut by turning it counter-clockwise. Discard the fibre glass sleeve.

8. Set the rear guard grill onto the shaft with the handle uppermost and screw on the guard retaining nut in a clockwise direction until tight.

9. Place the blade onto the shaft and screw on the blade retaining nut in a counterclockwise direction until tight.

10. Open the clips on the front guard grill and place the front and rear guard grills together. Align the locking screw holes and tighten the locking screw and nut.

11. Secure both guard grills firmly by fitting and tightening the locking screw and nut.

4

OPERATING INSTRUCTIONS

1. Ensure the unit is on the ‘O’ Off setting on the ‘Piano keys’. Insert the power plug into the power supply.

2. Select the speed at which you want the unit to operate:

‘O’ is Off

‘1’ is low speed

‘2’ is intermediate speed

‘3’ is high speed

3. To adjust the tilt of the fan head, set the unit to ‘O’, and wait for the fan blade to stop turning. Loosen the tilt adjustment knob. Tilt the motor to the desired angle and tighten the tilt adjustment knob.

4. To adjust the height of the fan, set the unit to ‘O’ and wait for the fan blade to stop turning. Loosen the height adjustment screw, while holding the height adjustment tube (upper section of the shaft) firmly. Carefully raise or lower the fan and firmly tighten the height adjustment screw.

5. Ensure all adjustment screws are tightened firmly before starting the fan.

CLEANING AND MAINTENANCE



This appliance is for household use only and is not user-serviceable.



Do not open or change any parts by yourself. Please refer to a qualified electrical service department or return to the supplier if servicing is necessary.



Always remember to unplug the unit from the electrical outlet when not in use and before cleaning. Ensure that the speed control is set to “0”.



The appliance should be cleaned with a damp cotton cloth. Do not let water enter the motor unit.



Do not use bleach or other abrasive substance or solvents to clean your appliance as it can be damaging to the finish.



Do not immerse the mixer in water or any other liquid, or hold it under a running tap to clean.



To remove stubborn spots/marks, wipe the surfaces with a cloth slightly dampened in soapy water or mild non-abrasive cleaner. Rinse and dry a clean, dry, soft cloth.

5

STORING THE APPLIANCE



Unplug the unit from the wall outlet and clean the unit as instructed above. Ensure that all parts are dry before storing.



Store the appliance in its box or in a clean, dry place.



Never store the appliance while it is still wet or dirty.



Never wrap the power cord around the appliance.

SERVICING THE APPLIANCE

There are no user serviceable parts in this appliance. If the unit is not operating correctly, please check the following:



You have followed the instructions correctly



That the unit has been wired correctly and that the wall socket is switched on.



That the mains power supply is ON.



That the plug is firmly in the mains socket.

Should the appliance still not work after checking the above:

Consult the retailer for possible repair or replacement. If the retailer fails to resolve the problem and you need to return the appliance, make sure that:



The unit is packed carefully back into its original packaging.



Proof of purchase is attached.



A reason is provided for why it is being returned.

If the supply cord is damaged, it must be replaced by the manufacturer or an authorised service agent, in order to avoid any hazard. If service becomes necessary within the warranty period, the appliance should be returned to an approved Amalgamated

Appliance (Pty) Ltd service centre. Servicing outside the warranty period is still available, but will, however, be chargeable.

6

CHANGING THE PLUG

Should the need arise to change the fitted plug, follow the instructions below.

This unit is designed to operate on 230V-240V current only. Connecting to other power sources may damage the appliance. Connect a three-pin plug as follows:

The wires in this mains lead are coloured in accordance with the following code:

Green/Yellow = Earth

Blue = Neutral

Brown = Live

7

PLEASE AFFIX YOUR PROOF OF PURCHASE/RECEIPT HERE

IN THE EVENT OF A CLAIM UNDER WARRANTY THIS RECEIPT MUST BE

PRODUCED.

W A R R A N T Y

1.

Tedelex Trading (Pty) Limited (“Tedelex”) warrants to the original purchaser of this product

(“the customer”) that this product will be free of defects in quality and workmanship which under normal personal, family or household use and purpose may manifest within a period of 1

(one) year from the date of purchase (“warranty period”).

2. Where the customer has purchased a product and it breaks, is defective or does not work properly for the intended purpose, the customer must notify the supplier from whom the customer bought the product (“the supplier”) thereof within the warranty period. Any claim in terms of this warranty must be supported by a proof of purchase. If proof of purchase is not available, then repair, and/or service charges may be payable by the customer to the supplier.

3. The faulty product must be taken to the supplier's service centre to exercise the warranty.

4. The supplier will refund, repair or exchange the product in terms of this warranty subject to legislative requirements. This warranty shall be valid only where the customer has not broken the product himself, or used the product for something that it is not supposed to be used for.

The warranty does not include and will not be construed to cover products damaged as a result of disaster, misuse, tamper, abuse or any unauthorised modification or repair of the product.

5. This warranty will extend only to the product provided at the date of the purchase and not to any expendables attached or installed by the customer.

6. If the customer requests that the supplier repairs the product and the product breaks or fails to work properly within 3 (three) months of the repair and not as a result of misuse, tampering or modification by or on behalf of the customer, then the supplier may replace the product or pay a refund to the customer.

7. The customer may be responsible for certain costs where products returned are not in the original packaging, or if the packaging is damaged. This will be deducted from any refund paid to the customer.

JOHANNESBURG

CAPE TOWN

DURBAN

TEDELEX TRADING (PTY) LTD (JOHANNESBURG)

TEL NO. (011) 490-9000

TEL NO. (021) 552-5161

TEL NO. (031) 792-6000 www.amap.co.za

8