slingshot™ wireless stereo speaker

slingshot™ wireless stereo speaker
®
SLINGSHOT™
WIRELESS STEREO
SPEAKER
Equipped with Bluetooth® Wireless Technology
system requirements
Bluetooth® enabled transmitting device (Bluetooth®
enabled phones, MP3 players, etc.)
BEFORE USE
Please read all instructions carefully before using
the speaker.
PARTS.
1. SPEAKER
2. TRACK REWIND
3. TRACK FORWARD
4. VOLUME +/5. HANDS-FREE PHONE
GETTING STARTED
6. POWER/PLAY/PAUSE
7. LED INDICATOR
8. BUILT-IN MIC
9. RESET BUTTON
10. USB PORT
PAIRING WITH BLUETOOTH® ENABLED DEVICES
Refer to your Bluetooth® enabled device’s user’s
manual for further information.
1.
CHARGING
Be sure speaker is fully charged before initial use.
The SPEAKER has a built-in rechargeable DC3.7V
1000mA Lithium battery that will last for up to 53 hours
in standby mode when fully charged.
1. Plug the micro USB cable into the back of the speaker.
2. Plug the other end of the cable into a USB port.
3. It will take approximately ***___ hours to charge the
SLINGSHOT fully.
7.
8.
2.
6.
3.
4.
5.
1. Place the SLINGSHOT SPEAKER and device where they
are no more than 1 meter apart.
2. Activate your device’s Bluetooth® function. Set your
device to search for Bluetooth® enabled devices.
3. Press and hold POWER/PLAY/PAUSE button for 3
seconds. When you hear 4 tones, release the button.
4. While searching for the device, the SLINGSHOT’s LED
indicator will light steadily.
5. If you release too soon, power SLINGSHOT off and
start over.
6. Wait until “Slingshot” appears in the list on your
Bluetooth device
7. Select “Slingshot”.
8. When Bluetooth connection is made, there will be a
beep sound and the LED will blink slowly.
SPlASH-PROOF
The Slingshot Speaker is water resistant, with an IPX4
rating and will resist splashing water from all angles.
9.
ENERGY SAVING MODE
10.
If the Bluetooth® communication link is disconnected
for 5 minutes, the unit will power off automatically
CONTROLS
POWER/PLAY/PAUSE BUTTON
Press and hold POWER/PLAY/PAUSE BUTTON to turn
unit on, play music, pause music.
TRACK BUTTONS
Press <</>> buttons to select track.
VOLUME BUTTONS
Press -/+ buttons to adjust volume. When you reach
maximum volume, a beep will sound
PHONE BUTTON
Music will automatically pause when you receive an
incoming call. Press PHONE BUTTON to answer an incoming call. Press PHONE BUTTON to hang up. When call
is finished, speaker automatically reverts back to music.
Note: Press the PHONE BUTTON twice to redial the last
outgoing number.
RESETTING THE UNIT
If the unit is not responding to any commands, it may
need to be reset. Use a straightened paper clip or
toothpick to press the RESET button located at the rear
of the unit.
Please Note: The reset operation clears the system memory.
All of your previous settings will be erased. Do not use a
sharp, pointed object to press the RESET button.
IMPORTANT SAFETY INSTRUCTIONS
Read all safety instructions before using the SLINGSHOT™
When used in the directed manner, this unit has been designed
and manufactured to ensure your personal safety. However,
improper use can result in potential electrical shock or fire
hazard. Please read all safety and operating instructions carefully before installation and use, and keep these instructions
handy for future reference.
1. Ventilation
The unit should be situated so that its location does
not interfere with its proper ventilation. Do not place on
a bed, sofa, rug or similar surface that may block the
vents (see parts diagram). Do not cover the
ventilation openings with items like newspapers, table
cloths, curtains, etc. Do not place in a built-in
installation, such as a bookcase or cabinet,which may
impede the flow of air through the ventilation openings,
keep a minimum distance 20 cm around the apparatus
for sufficient ventilation.
2. Heat & Flame
The unit should be situated away from heat sources
such as radiators, heat registers, stoves or other
appliances (including amplifiers) that produce heat. No
naked flame sources, such as lighted candles, should be
placed on the apparatus.
3. Care and Maintenance
- Do not subject unit to excessive force, shock, dust or
extreme temperature.
- Do not tamper with internal components of unit.
- Surface clean only with a dry or damp cloth only.
- Do not use solvents or detergents.
- Avoid leaving unit in dusty places.
- Keep unit away from heating appliances and sources of
electrical noise, such as fluorescent lamps or motors.
4. Attachments
Do not use attachments not recommended by the
product manufacturer.
5. Damage Requiring Service
This unit should be serviced by qualified service
personnel when: A. The unit has been dropped or the
enclosure damaged. B. The unit exhibits a marked
change in performance or does not operate normally.
6. Periods of Non-Use
If the unit is to be left unused for an extended period
of time, such as a month or longer, take out the
batteries from the unit to prevent damage or corrosion.
7. Servicing
The user should not attempt to service the unit
beyond those methods described in the user’s operating
instructions. Service methods not covered in the operat
ing instructions should be referred to qualified service
personnel.
8. Do not submerge unit in liquid.
Do not use abrasive cleaning solvents to clean the receiver.
Do not expose the receiver to extremely high or low
temperatures.
Don’t dispose of the receiver in a fire, as it will result in an
explosion.
Don’t attempt to disassemble the receiver as it may get
damaged.
If you don’t plan to use the receiver for an extended period of
time, store it in a dry, dust free place.
(a) CAUTION: Changes or modifications not expressly approved
by the party responsible for compliance could void the user’s
authority to operate the product.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
Warnings
Do not change the parts without professional instructions. Any
change may cause malfunctions.
Keep the wrapping bag out of the reach of children to avoid a
choking hazard.
Always move the product carefully to avoid damage to outer
covering and inner components.
The product should not come in contact with acid or alkali. It
should not be operated where there is corrosive or excessivelymoist air around to avoid corrosion of the electrical contacts
Customer Assistance
Phone: 866.710.8424
Email: info@blueflamegear.com
Colors and specifications depicted on this guide may vary slightly from your
product. Ages 14+. This product is not a toy.
Blueflame Technologies LLC. 745 Boylston Street. Boston, MA 02116 USA. Made
In China. Blueflame and the Blueflame logo are trademarks of Blueflame
Technologies LLC. The Bluetooth® word mark and logos are owned by the
Bluetooth SIG, Inc. and any use of such marks by Blueflame Technologies LLC is
under license. Other trademarks and trade names are those of their respective
owners. © 2013 Blueflame Technologies LLC. All Rights Reserved.
Limited Warranty: blueflamegear.com/warranty
BF4081.M.EF.01
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising