62 VAL6 Infrared Heater - Diesel

62 VAL6 Infrared Heater - Diesel
62
Please read this guide carefully
before operating the equipment
VAL6 Infrared Heater - Diesel
MOST IMPORTANT - RISK ASSESS!!!
Before you commence any work at your chosen work area, you should undertake some preliminary
hazard identification and risk control precautions. Ideally more than one person should do this.
This is undertaken by:
1. Physically inspecting the work site
2. Reviewing the best way/job steps required to complete the task
3. Reviewing the Safe Work Information supplied with the equipment
4. Reviewing other reference documentation and expert advice
The hazard identification and control process steps are defined as:
1. Identify the Hazards (e.g. uneven ground, ground hardness, or other site conditions)
2. Assess the Risk (e.g. possible injury resulting from material falling into pit area)
3. Select the Control Measure (e.g. ensure ground is level and suitable, ensure spacers, pins, struts
etc are appropriate and correctly fitted)
4. Re-assess the Risk (risk of falling material now negligible). This is undertaken to ensure that the
risk control measures adopted have not introduced any new risks to the work area.
HELP
If you are unhappy with any aspect of the
equipment, return it to the nearest Kennards Hire
Centre for exchange or phone for assistance. Do
not attempt repairs yourself.
Refer to your Hire Contract for details of our
AFTER HOURS EMERGENCY NUMBER.
SAFETY DO’S
DO take your time; Read this User Guide and
any other Safety Information provided
(E.g. decals, manufacturer's instructions),
completely and in its entirety, BEFORE installing
the equipment.
DO ensure that the equipment is suitable for your
needs and working environment
Do ensure that the equipment is assembled and
used according to the manufacturers and hirer’s
instructions.
DO wear appropriate PPE if necessary
depending on task.
DO where possible operate in a clear work area
free from non-essential persons, children,
animals or hazards.
DO check and assess the equipment at the start
and end of each day and report any damage or
defects.
DO ensure any relevant permits are obtained
for operating on a particular site.
DO ensure that you have a secure footing and
clear access and avoid standing on damp, wet or
slippery surfaces.
DO ensure the work environment is well lit with
all aspects of the job easily seen and discernable.
SAFETY DON’TS
DO NOT operate any equipment if you are tired or
suffering any medical condition, or if under the
influence of drugs or alcohol which may cause
lethargy or dangers to yourself or others.
DO NOT use equipment for a job it was not
designed for.
DO NOT operate any equipment with personnel
within the work zone.
DO NOT use faulty or damaged equipment. If in
doubt contact your local Kennards Hire Centre
As far as is reasonably possible this heater has been designed to ensure that it is safe and without risk to health when installed and operated in accordance with
these instructions. This heater should only be operated by suitably qualified or experienced persons.
Please take note of the following:
1.
2.
3.
4.
ůĞĐƚƌŝĐĂůƉŽǁĞƌƐŽƵƌĐĞŵƵƐƚďĞϮϰϬs͘
ůǁĂLJƐƵƐĞĐůĞĂŶĚŝĞƐĞů͘
tŚĞŶŚĂŶĚůŝŶŐĨƵĞů͕ƚĂŬĞĂůůŶĞĐĞƐƐĂƌLJƉƌĞĐĂƵƚŝŽŶƐƚŽƉƌŽƚĞĐƚƐŬŝŶΘ
ĞLJĞƐǁŝƚŚĂƉƉƌŽƉƌŝĂƚĞWW͘
ƚƚŚĞĞŶĚŽĨǁŝŶƚĞƌĚƌĂŝŶƚŚĞĚŝĞƐĞůĨƌŽŵƚŚĞƚĂŶŬ͘dŚĞŚĞĂƚĞƌƐǁŝůů
ŶŽƚďĞƵƐĞĚŝŶƐƵŵŵĞƌĂŶĚƚŚĞĚŝĞƐĞůǁŝůůŐŽƐƚĂůĞŝĨŝƚŝƐůĞĨƚŝŶƚŚĞ
ƚĂŶŬĨŽƌƚŚĂƚůŽŶŐ͘
EĞǀĞƌĂƚƚĞŵƉƚƚŽůŝĨƚƚŚŝƐŚĞĂƚĞƌďLJLJŽƵƌƐĞůĨ͕ĂůǁĂLJƐŚĂǀĞĂƐĞĐŽŶĚ
ƉĞƌƐŽŶƚŽĂƐƐŝƐƚǁŝƚŚƚŚĞůŝĨƚŝŶŐ͘
6. dŚĞŚĞĂƚĞƌƌĞŵĂŝŶƐŚŽƚĂĨƚĞƌƚƵƌŶŝŶŐŽĨĨƚŚĞƉŽǁĞƌƐŽŬĞĞƉĐůĞĂƌŽĨ
ƚŚĞŚĞĂƚĞƌĞůĞŵĞŶƚƵŶƚŝůŝƚ͛ƐĐŽŽů͘
7. sĞŶƚŝůĂƚŝŽŶŝƐƌĞƋƵŝƌĞĚĨŽƌŝŶĚŽŽƌƵƐĞ͘
ϴ͘EĞǀĞƌƌĞĨƵĞůƚŚĞŚĞĂƚĞƌǁŚŝůĞŝƚŝƐŝŶŽƉĞƌĂƚŝŽŶ͘tĂŝƚƵŶƚŝůƚŚĞ
ŚĞĂƚĞƌŚĂƐĐŽŽůĞĚďĞĨŽƌĞƌĞĨƵĞůŝŶŐ͘
5.
IMPORTANT – WHEN SWITCHING OFF THE HEATER LEAVE THE UNIT PLUGGED IN TO THE POWER POINT FOR AT LEAST 3
MINUTES. THIS ALLOWS THE FAN TO COOL THE UNIT DOWN.
1.
2.
3.
4.
1.
2.
3.
4.
5.
6.
7.
OPERATION
Ensure there is diesel in the tank and the fuel cap is in place.
Ensure the unit is plugged in to a 240V power point.
Switch on the heater.
Do not do any of the following: - (a) Wet the heater (heater cannot be
used in the rain or operated with wet hands). (b) Operate the heater
5.
near combustible materials. (c) Use petrol for fuel. (d) Operate the
heater unattended. (e) Make any adjustments with the heater
running. (f) Clean the unit with a pressure washer. (g) Disassemble
the pump unit.
To prevent fire or damage to combustible surfaces always use a
“Heat Shielding Mat” provided with the heater.
DAILY CHECKS
Fuel tank level. Always use clean fuel & replace fuel cap. Use only
good quality diesel.
Check electrical cord for fraying or damage.
Check nozzle. The nozzle will clog and is a consumable item.
Note: The fuel filter is a consumable item and should be changed
annually.
Report immediately any abnormal consumption of fuel.
Report immediately any electrical or mechanical operating difficulties.
Log and report any defects.
This operating and safety brochure is intended as a guide only for the safe operation of this equipment. It does not override license
requirements nor is it a substitute for a structured operating lesson.
If you are unsure about any aspect of the equipment or its capabilities or if you are in doubt as to its proper usage, feel free to consult our
trained employees for instruction or the answers to any questions you may have regarding the safe operation of this equipment.
www.kennards.com.au
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising