Smart Lifter Roller Disc Nano Remote

SMART Lifter Roller Disc Nano Garage Door Openers

Transmitter Frequency 433.92Mhz

Garage Door Openers

1. Locate the “code” button on the receiver board at the bottom of the unit. Press and release t he “code” button once. The courtesy light on the unit will illuminate.

2. Press and release a button on your new remote twice (some roller door models will require 3 presses).

3. If programming is successful the courtesy lights will turn off, or the unit will beep. Test the unit to confirm.

Garage Gate Receivers

1. Locate the control panel on your garage/gate receiver. To locate it

– it may require you to remove a light cover.

2. Press the “code” “program” or “learn” until “code learn” is displayed on the screen or a light illuminates on the control panel.

3. Press the button on the new remote you wish to use with the garage/gate, twice (some roller door models – you must press the button 3 times).

Liability Disclaimer: These instructions are based on carefully documented information and years of research.

The author remotesandkeysonline can not be held accountable for discrepancies due to options or manufactures variations.