Storm Drone 4 / Storm Drone 6 Quick Reference - 1

Storm Drone 4 / Storm Drone 6 Quick Reference - 1
Storm Drone 4 / Storm Drone 6
Quick Reference
How to Bind
1. Switch on transmitter, move ALL trims back to neutral, move throttle stick to lowest point
and then switch OFF transmitter.
2. Connect Drone battery, the RX071 receiver should be flashing red quickly, that means it is
looking for transmitter.
3. Now switch on transmitter, DO NOT touch anything as transmitter is looking for receiver.
4. In about 10 seconds, the transmitter will have two Beep tone, and receiver turn solid red,
that means binding is successful.
Defining Stick Range for Storm Drone 6 (Do this every time)
1. Bind the Drone with transmitter first as mentioned above.
2. Move Throttle Stick to higest point.
* By default the motors WILL NOT move unless you do the unlock throttle stick gesture,
so it’s safe for you to move throttle stick to higest point.
3. Flip the Gear switch on the transmitter to Position 1, you should see “Green” LED on the
gyro board.
4. Move both stick in maximum circle, do a few times.
5. After a few rounds, move Throttle Stick to higest point again.
6. Flip the Gear switch on the transmitter back to Position 0, , you should see “Green” LED
on the gyro board goes out.
7. Now move the throttle stick to lowest point, now you have successfully defined stick
range.
-1-
Storm Drone 4 / Storm Drone 6
Quick Reference
Gyro Calibration (Do this occassionally)
1. Bind the Drone with transmitter first as mentioned above.
2. Put Drone on Flat Surface, make sure Gear Switch on the transmitter is on Position 0.
3. Move Left stick to TOP LEFT and move Right Stick to TOP Right, you should see “Green”
LED on the gyro board.
4. Now please wait for 1~2 minutes, Gyro is gathering data.
5. When it’s done, “Green” LED on the gyro board will goes out.
6. Now Gyro should be well calibrated, you can unlock Throttle Stick to fly.
How to Unlock Throttle?
1. You need to unlock throttle stick before flying, otherwise motor will not move.
2. Move Left stick to Lower LEFT and move Right Stick to Lower Right, you should see
“Green” LED on the gyro board flash once.
3. Now please move a little on the throttle stick to confirm if motor is unlocked.
4. While not in flight (landed), please lock the Throttle by doing the same stick gesture,
this is for safety reason.
Storm Drone 4 / 6 Tips :
1. If you find drone is unstable, please do the Stick Range and Gyro Calibration right the
way before it gets worse.
2. When taking off, move throttle quickly to 50% so drone life off at once, because ground
wind will affect the drone when taking off, drone would be unstable and flip over.
3. For Storm Drone 4, default 3S 2200mah battery can fly about 6 mintues,
for Storm Drone 6, default 3S 2500mah battery can fly about 5 minutes, please keep an
eye on the flight time.
-2-
Storm Drone 4
Connections
1
Front
3
CW
CCW
White
Red
Black
White
4
Motor 1
Motor 2
Motor 3
Motor 4
2
To USB Cable
Not used
11.1V Gyro Power Input
Not used
Not used
Calibration
Rudder
Throttle
Aileron
Elevator
White
Red Black
-3-
Storm Drone 6
Connections
1
Front
2
6
White
Red
Black
White
3
CW
CCW
5
Motor 1
Motor 2
Motor 3
Motor 4
Motor 5
Motor 6
4
To USB Cable
Not used
11.1V Gyro Power Input
Not used
Not used
Calibration
Rudder
Throttle
Aileron
Elevator
White
Red Black
-4-
Storm Drone 6
Landing Skids Installation
1. Put the legs at the 3 o’clock and 9 o’clock direction of the drone, on the lower deck.
2. Secure the tiny black screw from above, it goes into the silver hex shape rod on the leg.
Tiny black screw
Secure it with 1.5mm
Hex Screwdriver
-5-
Storm Drone 6
Power Supply for Gimbal and FPV
The main power cable of the Storm Drone 6 is actually a
1 split 9 T-Join to JST power cable. The drone is using 7 of them, you
will find two extra plugs inside the drone, please pull them out, and
you can power up the Gimbal and FPV Transmitter.
-8-
Storm Drone 4 / Storm Drone 6
Transmitter
Gimbal Tilt Control
(If available)
Not used
Not used
Gyro Config
0 : OFF
1 : ON
Not used
Throttle Up
Yaw Left
Go Forward
Yaw Right
Strafe Left
Throttle Down
Strafe Right
Go Backward
Stick Mode 2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising