Verse Alloy Rack Installation Instructions

Verse Alloy Rack Installation Instructions
Verse Alloy Rack Installation Instructions
ELECTRA BICYCLE COMPANY , LLC. • 3270 CORPORATE VIEW, SUITE A, VISTA, CA 92081
TEL 760-607-2453 • ORDERLINE 800-261-1644 • FAX 760-598-7350 • ELECTRABIKE.COM
Verse Alloy Rack Installation Instructions
DIFFICULTY LEVEL: Easy
1) TOOLS NEEDED
Required:
· 4mm hex wrench
· 10mm or adjustable wrench
· 8mm or adjustable wrench or
Phillips screwdriver
2) PARTS LIST
(1) rack
(2) adjustable arms, 220mm long
(2) adjustable arms, 230mm long
(4) M5 hex head machine screws
w/washers, 17mm long
NOTE: The rack includes two sets of adjustable
arms. Be sure to use the correct arms for the
frame size of your Verse.
220mm (short) arms fit:
18.5” ladies’
19” men’s
22” men’s
230mm (long) arms fit:
16.5” ladies’
17” men’s
ELECTRA BICYCLE COMPANY , LLC. • 3270 CORPORATE VIEW, SUITE A, VISTA, CA 92081
TEL 760-607-2453 • ORDERLINE 800-261-1644 • FAX 760-598-7350 • ELECTRABIKE.COM
STEP 1: Installation of arms to rack top
1) Using chart from the previous page, select the proper arms for your Verse.
a. If needed, replace arms by removing plastic end caps and sliding new arms into place.
2) Install arms to rack top using included bolts.
10mm nuts on mounting block are to be
facing out.
STEP 1:2
Note: Arms will arc upward when using 220mm arms and arc downward when
using 230mm arms.
3) Do not fully tighten hardware yet.
STEP 2: Installation of rack to bicycle
1) Using two machine screws, install rack to
frame dropouts.
STEP 2:1
Note: Use upper dropout mount on
bicycle, lower dropout mount is designed for fender mounting.
2) Attach rack arms to seat collar rack mount.
3) Make sure that top of rack deck is level.
STEP 2:2
ELECTRA BICYCLE COMPANY , LLC. • 3270 CORPORATE VIEW, SUITE A, VISTA, CA 92081
TEL 760-607-2453 • ORDERLINE 800-261-1644 • FAX 760-598-7350 • ELECTRABIKE.COM
4) Tighten rack top hex bolts with 4mm
hex wrench.
5) Tighten 10mm nuts on underside of rack deck with 10mm wrench.
6) Mount reflector to rear rack mounting plate
using 8mm wrench or Phillips screwdriver.
If you have questions regarding assembly,
please visit your local Electra dealer or call
Electra Customer Service at 800-261-1644
(8AM – 4PM Pacific Time).
STEP 2:4
STEP 2:5
STEP 2:6
ELECTRA BICYCLE COMPANY , LLC. • 3270 CORPORATE VIEW, SUITE A, VISTA, CA 92081
TEL 760-607-2453 • ORDERLINE 800-261-1644 • FAX 760-598-7350 • ELECTRABIKE.COM
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising