High quality cutting with simple operation

High quality cutting with simple operation
Paper Cutter PC-640
PC-640
Paper Cutter
High quality cutting with
simple operation
Features
1. Accurate Cutting - The backgauge enables you to adjust the cutting length accurately within 0.5mm /
0.019".
2. Cut Line - The LED cutting line shows the actual cutting position to allow easy and accurate positioning
and operation.
3. Safety - The PC-640 employs updated safety standards. Two button operation, safety cover, and
emergency stop features for operator safety.
Paper Cutter PC-640
Simple and safe operation
suitable for office use.
Easy Operation
Clamp the stock by turning the pressure handle by hand, and
press the two cutting buttons. The backgauge can be adjusted by
0.5 mm / 0.019" by turning the positioning handle. The backgauge
can be locked when you repeat the same cutting position.
Pressure Handle
Backgauge
Backgauge
Handle
Operator Safety
Cutting Buttons
Double Safety Circuit
The system is further equipped with a hard-wired secondary safety
interrupt for operator safety.
Safety Mechanism
The machine does not operate when the front cover is opened.
Also, if either of the two cutting buttons is released during the cutting operation, the machine will be stopped immediately.
Key Switch
The Power switch is key-activated to limit user access.
Counter
Cut cycles are indicated on a digital counter. It helps to determine
Cutting Height
Max. 640mm / 25.19”
Cu
tt
He ing
igh
t
Max. 70mm / 2.75”
C
pt
h
when the cutting knife should be sharpened or replaced.
PC-640 Specifications
Cutting Width
Max. 640mm / 25.19”
Max. 20mm / 0.79”
Cutting Depth
Special cutouts are provided on both edges of the clamp to pre-
Clamp System and Manual
Pressure
Max. About 10 kN (1,000 kgf)
th
id
W
Cu
g
tti
ng
tin
ut
vent the book spine from crushing.
De
Clamp
Cutting Speed
3.3 seconds per cycle (50 Hz)
2.8 seconds per cycle (60 Hz)
Voltage/Frequency
Single Phase 115 V, 50 / 60 Hz
Single Phase 230 V, 50 / 60 Hz
Rated Current
Single Phase 115 V, 50 / 60 Hz, 15 A
Single Phase 230 V, 50 / 60 Hz, 15 A
Machine
Dimensions
W1,070 x D1,185 x H1,315 mm / W42.2" x D46.7" x H51.8"
Machine Weight
318 kg / 700.5 lb
*The machine design and specifications are subject to change without any notice.
Distributed by
510 Kuze Ooyabu-cho, Minami-ku, Kyoto, 601-8206, Japan
Phone : +81-(0)75-934-6700 Fax : +81-(0)75-934-6708
www.horizon.co.jp
Standard Finishing Systems, 10 Connector Road, Andover, MA 01810
877-404-4460 978-470-1920 Fax 978-470-2771
www.standardfinishing.com
141003/MM/PC640/00E/TV
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising