MXA-5000

MXA-5000
INSTRUCTIONS
Thank you for purchasing the MXA-5000
AIS RECEIVER
AIS
RECEIVER.
MXA-5000
Please read these instructions carefully before
installation and operation.
PRECAUTIONS
•R
NEVER apply AC power to the [DC 12 V] connector on
the rear panel. This could cause a fire or damage the receiver.
•R
NEVER connect the receiver to a power source of more
than 16 V DC such as a 24 V battery. This will damage the
receiver.
•R
NEVER connect the receiver to a power source using
reverse polarity. This will damage the receiver.
•R
NEVER cut the DC power cable between the DC plug
and fuse holder. If an incorrect connection is made after
cutting, the receiver may be damaged.
• R NEVER expose the receiver to rain, snow or any liquids.
The receiver may be damaged.
FEATURES
m Power divider bult-in
A power divider is built-in the MXA-5000. This provides
easy installation as well, since no extra antenna is
necessary— just connect the receiver between your VHF
marine transceiver and an antenna.
• The internal power divider protects the receiver from a transmit
signal of the VHF marine transceiver.
m GPS receiver is connectable
When a GPS receiver is connected, the GPS information
is added to the received AIS information, and can be sent
to the connected PC or navigation system.
SUPPLIED ACCESSORIES
q DC power cable.............................................................. 1
w Angle............................................................................... 2
e Set screws (M3×6 mm)................................................... 4
r Self-tapping screws (M5×20 mm)................................... 4
t Spring washers............................................................... 4
y Flat washers.................................................................... 4
1 mm = 1/32 inch
e
w
r
t
• R N EVER apply more than 25 W RF power or out of
VHF marine frequency (156.000 to 161.450 MHz) to the
[RADIO] connector on the rear panel. This will damage the
receiver.
• DO NOT use or place the receiver in areas with temperatures below –20°C (–4°F) or above +60°C (+140°F) or in
areas subject to direct sunlight, such as the dashboard.
•D
O NOT use chemical agents such as benzine or alcohol
when cleaning, as they can damage the receiver’s surfaces.
• Place unit in a secure place to avoid inadvertent use by
children.
PANEL DESCRIPTIONS
m Dualwatch operation
Two independent receivers can simultaneously receive
CH87B (161.975 MHz) and CH88B (162.025 MHz).
q
• R NEVER touch the receiver with wet hands. This may result in an electric shock or damage the receiver.
y
Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorporated (Japan) in the United States, the United Kingdom, Germany, France,
Spain, Russia and/or other countries.
All other products or brands are registered trademarks or trademarks of their
respective holders.
q Power indicator
w Antenna connectors
r Multi connector
PC DATA OUT
DATA IN
DATA OUT
e DC power connector
q POWER INDICATOR
Lights green during power ON.
w ANTENNA CONNECTORS
m [ANTENNA]
C onnects to a VHF marine antenna with a PL-259
connector.
m [RADIO]
Connects to a VHF marine transceiver with a PL-259
connector.
• VHF marine transceiver: Output power 25 W nominal and
transmit frequency range from 156.000 MHz to 161.450
MHz.
hen a VHF marine transceiver is connected with an
W
antenna through the MXA-5000, its receive sensitivity
will be reduced (Insertion loss: approx. 3 dB). This is
normal, and does not indicate the receive’s malfunction.
e DC POWER CONNECTOR [12V DC]
Connects the supplied DC power cable from this connector to an external 12 V DC power source.
r MULTI CONNECTOR
m [PC DATA OUT]
Connects to a PC.
m [DATA IN]
Connects to a GPS receiver.
m [DATA OUT]
Connects to a navigation equipment.
CONNECTIONS
DATA PC DATA
OUT
OUT
Bolting torque
0.22–0.25 N·m
Wire information
AWG28 to AWG16
Fuse replacement
One fuse is installed in the supplied
DC power cable. If a fuse blows or the
receiver stops functioning, track down
the source of the problem, if possible.
Replace the damaged fuse with
properly rated fuse.
Stripped skin length
6–8 mm
Less than
2 mm
DO NOT use a solid conductor
cable, otherwise the connected
cable may be disconnected.
DATA IN
to antenna
AIS receiver
CAUTION:
NEVER connect a 24 V DC
power source directly. This
will damage the receiver.
Fuse rating: 0.5 A
12 V battery
Red
Black
PC conncetion
PC DATA OUT
PC
DATA IN
VHF Marine transceiver
This connection is not necessary if you
have no VHF marine transceiver.
DATA OUT
GPS
receiver
Navigation
equipment
1
5
6
9
Pin 2: Data
Pin 5: Ground
D-sub 9 Pin
1
13
14
25
D-sub 25 Pin
Pin 3: Data
Pin 7: Ground
INSTALLATION
q Attach the supplied angles to bottom side of the receiver,
and tighten the two supplied screws (M3×6 mm) on each
angle.
wM
ount the receiver securely with the four supplied screws
(M5×20 mm) to a flat surface which is more than 10 mm
(13/32 inch) thick and can support more than 2 kg (4.4 lb).
Set screws
Self-tapping
screw
Angle
Spring washer
Flat washer
SPECIFICATIONS
D General
• Frequency coverage • Type of emission
• Antenna impedance • Operating temp. range • Power supply requirement
:161.975 MHz, 162.025 MHz
:16K0F1D (GMSK)
:50 W nominal
:–20°C to +60°C; –4°F to +140°F
:12 V DC nominal (10.8 V to 15.6 V)
(negative ground)
• Current drain
:0.25 A
• Dimensions (Projections not included)
Without Angle
:132(W) × 34(H) × 155(D) mm
5 3⁄16(W) × 1 11⁄32(H) × 6 3⁄32(D) in
Angle attached
:158(W) × 39(H) × 155(D) mm
6 7⁄32(W) × 1 17⁄32(H) × 6 3⁄32(D) in
• Weight (Approx.)
Without Angle
:400 g (14.1 oz)
Angle attached
:460 g (16.2 oz)
• DATA input interface
:IEC61162-1: 2000 (4,800 bps)
Sentence formatters :RMC, GGA, GNS, and GLL
Input level
:Less than 2 mA
(When 2 V is applied)
• DATA output interface
To navigation equipment
Sentence formatter
Output level
To PC
Sentence formatter
Output level
:
:IEC61162-2 (38,400 bps)
:VDM
:5 V, 40 mA max
RS-422 ballanced type
:Baud rate 38,400 bps
:VDM
:±5 V, ±35 mA typical
RS-232C unballanced type
D Receiver
• Sensitivity
:0.35 µV (typical)
• Adjacent channel selectivity :More than 70 dB
• Spurious response :More than 70 dB
• Intermodulation
:More than 65 dB
• Hum and noise
:More than 40 dB
• Conducted spurious emission:Less than –57 dBm
All stated specifications are subject to change without notice or obligation.
1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan
A-6721H-1EX
Printed in Japan
© 2008 Icom Inc.
DECLARATION
OF CONFORMITY
We Icom Inc. Japan
1-1-32, Kamiminami, Hirano-ku
Osaka 547-0003, Japan
Declare on our sole responsibility that this equipment complies with the
essential requirements of the Radio and Telecommunications Terminal
Equipment Directive, 1999/5/EC, and that any applicable Essential Test
Suite measurements have been performed.
Kind of equipment:
AIS RECEIVER
Type-designation:
MXA-5000
Düsseldorf 28th Nov. 2008
Place and date of issue
Icom (Europe) GmbH
Himmelgeister straße 100
D-40225 Düsseldorf
Authorized representative name
Y. Furukawa
General Manager
Version (where applicable):
This compliance is based on conformity with the following harmonised
standards, specifications or documents:
i) EN 60945: 2002
ii) EN 60950-1: 2001: A11: 2004
iii) EN 62287-1 2006
iv)EN 61993-2: 2002
<Intended Country of Use>
■ AT ■ BE ■ CY ■ CZ ■ DK ■ EE
■ FI ■ FR ■ DE ■ GR■ HU■ IE
■ IT ■ LV ■ LT ■ LU ■ MT■ NL
■ PL ■ PT ■ SK ■ SI ■ ES ■ SE
■ GB■ IS ■ LI ■ NO■ CH■ BG
■ RO■ TR ■ HR
T he MXA-5000 complys with
the essential requirements of
the European Radio and Telecommunication Terminal Directive 1999/5/EC, and that any
applicable Essential Test Suite
measurements have been performed.
Signature
• List of Country codes (ISO 3166-1)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
Country
Austria
Belgium
Bulgaria
Croatia
Czech Republic
Cyprus
Denmark
Estonia
Finland
France
Germany
Greece
Hungary
Iceland
Ireland
Italy
Latvia
Codes
AT
BE
BG
HR
CZ
CY
DK
EE
FI
FR
DE
GR
HU
IS
IE
IT
LV
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
Country
Liechtenstein
Lithuania
Luxembourg
Malta
Netherlands
Norway
Poland
Portugal
Romania
Slovakia
Slovenia
Spain
Sweden
Switzerland
Turkey
United Kingdom
Codes
LI
LT
LU
MT
NL
NO
PL
PT
RO
SK
SI
EP
SE
CH
TR
GB
A-6721H-2EU-q
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising