Handleiding Brodit Telefoonhouder

Handleiding Brodit Telefoonhouder
30 January, 2016, www.brodit.com, © 2016 Brodit AB
Product 530166
530166 Active holder with cig-plug With tilt swivel. Slim design with charger integrated in the holder and with
USB on-the-go connectivity.
Are you using your Pidion every day in your work? Then a Brodit active holder will make your days much easier!
By keeping the device in an active holder, you will always have it within easy sight and reach while driving
between jobs. Not only that; this active holder supplies a fully charged
battery at all times, as well as USB on-the-go! This means that the Symbol can be run as both host and client
(depending on the equipment connected to the holder).
The active holder has a unique slim design with the charging box integrated in the holder, so the cigarette lighter
cable has no hefty charging box on the cable. The holder is made of black ABS plastic which is cold and heat
resistant so you can use it in any environment. It is safe to use because of the short circuit protection and its high
efficiency which reduces the heat produced in the unit.
Attach the holder to a ProClip Mounting Platform in order to get a firm installation in any car or truck. The holder
can be used with the following cables:
Item no 945021 Micro USB - RS-232 (driver required)
Item no 945020 Micro USB - USB-A female
EAN: 7320285301665
Item no 530166 fits:
Pidion BIP-5000 (For all countries)
https://www.telefoonhouderwinkel.nl
1 (2)
INSTALLATION INSTRUCTIONS
1.
2.
3.
4.
Please read all of the instructions and look at the pictures before attaching the holder.
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed
screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel.
3. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly
tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the
holder is firmly in place, but still can be adjusted.
4. The holder is in place.
https://www.telefoonhouderwinkel.nl
2 (2)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising