advertisement
◉
Touch to zoom
EL LAVA GLOW dreambEAN PO Box 478 Torrance, CA 90508 Contents ® Wireless Lava Glow Controller e Lava Glow Receiver 1. Open the battery compartment located on the bottom side of the Lava Glow controller. Insert 2 “AA” batteries. 2. The Lava Glow controller features a 3 position power switch located on the bottom side of the controller. e OFF = The controller is powered off e | ED OFF (middle setting) = This setting allows you to have full use of your Lava Glow controller without the internal LEDs being on. This setting conserves battery life. * ON LED = The controller and internal LEDs are powered on. 3. With your PlayStation game console powered on, plug the Lava Glow receiver into controller port 1 (or other if using multiple controllers) of your game console. LED will begin to flash slowly. Press the Connect button on the receiver (the led LED will flash rapidly). 4. Press the Connect button on the Lava Glow controller and the receivers LED will become solid. You are now connected and ready to enjoy your new Lava Glow Wireless controller. 5. When connecting multiple Lava Glow controllers, connect each controller separately. First connect player one's controller and than connect player two's controller. Trouble shooting: Problem: controller is not functioning Solution: confirm the controller and receiver are linked Solution: replace batteries Solution: try moving closer to the gaming console NOTE: The Lava Glow controller features a sleep mode to help conserve battery life. If the controller is powered on and is not in use, it Will go into sleep mode after 3 minutes. To awake the Lava Glow press any button and if needed re-link the controller and receiver as outlined in section 2 and 3 of this instruction manual. FCC NOTE: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try the interference by one of the following measures. ¢ Reorient or relocate the receiving antenna. * Increase the separation between the equipment and receiver. * Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. * Consult the dealer or an experienced radio/TV technician for help. Any changes or modifications made on the system not expressly approved by the manufacturer could void the user's authority to operate equipment. This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interfence, and (2) this device must accept any interference received, including interference that may cause undesired operation. FOR TECHNICAL SUPPORT PLEASE CONTACT: 1-877-999-DREAM or visit us on the web @ www.dreamgear.net www.isound.net
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project