Savi W710-W720 Cisco UC Int. Connect Quick Start Guide

Savi W710-W720 Cisco UC Int. Connect Quick Start Guide
Savi® W710™/W720™ Quick Setup Guide
Welcome:
Using a Plantronics Savi headset for PC
calls will deliver a simpler, more
comfortable and better sounding
audio experience than you could get
using just your computer’s internal
microphone and speaker.
Getting started:
Follow the steps below to get call answer/end
controls with your Savi headset and Cisco® Unified
Communications Integration for Cisco WebEx
Connect™.
1. Connect your Savi base to the computer. If
this is the first time you are connecting, wait
for the installation process to complete.
2. To get call control features, please
download the latest version of Plantronics
software at plantronics.com/software.
3
4
Note: Check with your IT staff before installing
software on your computer.
*This picture shows the
Binaural (W720) version
Savi W710/W720 Key Features:
 Manages PC, deskphone and mobile
calls from a single headset
 One-touch call answer/end, vol +/-,
mute and flash across devices
 Wireless freedom up to 350 feet
from your desk
 Conference in up to three
additional Savi headsets
 Monaural (W710), Binaural (W720)
Configuring Cisco Unified Communications
Integration for Cisco WebEx Connect to always
route call audio to the headset:
3. Click Edit in the upper left corner of the
Cisco WebEx Connect main screen.
4. Then select Settings.
5. Next choose Audio/Video.
6. Select your Plantronics headset in the drop
down for both Speakers and Microphone.
7. You can also adjust the Speakers and
Microphone volume in this screen.
8. When you are finished, select Save.
6
6
5
Note: USB configuration settings are unique for each USB
port. If you connect the headset to a different port you
will need to make these changes again to set behavior
for that USB port.
8
©2011 Plantronics, Inc. All rights reserved, Plantronics, the logo design, Savi, W710 and W720 are trademarks or registered trademarks of Plantronics, Inc. Cisco is a registered trademark of Cisco Systems Inc. and/or its affiliates in the U.S. and other
countries. Published 05.11
Making and Receiving Calls with Cisco Unified Communications Integration for Cisco WebEx Connect
To MAKE a call:
To call an existing contact, select the
Contact Tab (1) and select the contact
you would like to call. Right click on their
picture (2), select Start Call (3) and
choose a number (4).
You can also enter a phone number
manually using the search box located
near the top of the Cisco WebEx Connect
main screen (5).
1
1
5
2
4
3
4
When a call is placed, a call notification
will appear in the Cisco WebEx Connect
main screen, and the audio will be
routed to your headset.
To RECEIVE a call:
When you receive a call, a notification
window will appear in the lower right
corner of your computer screen (6).
To answer the call, use the controls on
your headset or click the green Answer
button (7) in the call notification
window.
6
7
©2011 Plantronics, Inc. All rights reserved, Plantronics, the logo design, Savi, W710 and W720 are trademarks or registered trademarks of Plantronics, Inc. Cisco is a registered trademark of Cisco Systems Inc. and/or its affiliates in the U.S. and other
countries. Published 05.11
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising