RC8.2e RTR QS Guide color
 f ‚A
NOTE! Before using your factory assembled
RC8.2e RTR, review all instruction
manuals and this quick-start guide. )
| GLIA Tl 4
BRUSHLES
HONDA
Start h ere... Battery Charging:
QUICK START GUIDE — ННЕЕЕЕЛОЛЕ
charging. ALWAYS charge a LiPo battery in LiPo mode.
NEVER leave the battery unattended while charging!
era 6 AA batteries Ш A |
Step 1:
Install the battery
pack into the
Slide the bottom panel
off of transmitter.
Install 6 AA batteries.
Re-install the bottom
panel of transmitter.
Step 2:
Lock the battery Pull for Throttle
strap into place Throttle set fo neutral!
with the hook
and loop straps.
Vehicle on second!
Install the TTY Ready 10 go! ALWAYS turn off the switch)
and unplug the battery
when you are finished
driving your vehicle, the vehicle is
not in use, or the battery pack has
died. Failure to do so may result in
sudden acceleration, battery
damage, or fire.
Contact Team Associated:
Associated Electrics, Inc.
26021 Commercentre Dr.
Lake Forest, Ca 92630 USA
www.TeamAssociated.com
www.RC10.com
Customer Support:
Tel: (949) 544-7500
Fax: (949) 544-7501 J)
NOTE!
If you have any problems with the operation
of your RCS.2e RTR racing vehicle, please
consult the following list of common
occurances. If you are still experiencing
Ir oubleshooting difficulty, please contact us.
N J
i Description Problem Solution В
No power Battery is discharged..............cewem... Charge battery.
Battery not plugged in.................... Plug battery in.
No light on speed control................. Reset speed control using your
instruction manual.
Receiver LED remains red................ Re-bind transmitter to the receiver
No throttle Motor not plugged in............e.=.=.... Plug motor in.
Speed control out of adjustment...... Reset speed control using your
instruction manual.
Motor failure......ccoeev iii icine Replace motor.
No steering Servo not plugged in..............wcee... Plug servo in.
Locked up steering linkage.............. Free up steering linkage.
Servo failure... Replace servo.
Throttle Goes backwards when you pull........ Switch any two motor wires.
the trigger, or forward when Check throttle reversing switches
pushing brakes/reverse. on transmitter. Reset speed
control.
Steering Goes right when turning the wheel... Check steering reversing switches
left (or left when turned right.) on transmitter.
Vehicle is Vehicle has a problem on power...... Check for loose wires.
glitching Vehicle takes off........................... Check for loose wires or dead
radio batteries.
Radio Interference.
Reverse No reverse or БгаКеб...................... Reset speed control, or send in for
repair. Check that reverse mode
has not been turned off. Refer to
speed control instructions.
Vehicle dies or Speed control overheats................. Let speed control cool.
slows Motor overheats..............e...e..e.eve.. Let motor cool and check
recommended gearing for
motor type.
Gear mesh set too tight.................. Reset gear mesh (see instruction
manual).
LiPo mode engages............e..evvecena LiPo mode on the ESC has engaged,
recharge your batteries.
N J
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising