R:\_New Working Instructions\Toddler Rails\PSR-3268

R:\_New Working Instructions\Toddler Rails\PSR-3268
 America.
MADE IN THE USA
#3268 BED SAFETY RAIL INSTRUCTIONS
Read These Instructions Carefully
Before Installing Bed Safety Rails.
NS
Your young child will sleep safe and secure in their own Young America bed with
the use of a pair Bed Safety Rails. Proper assembly will ensure every effort has been
made to design these Bed Safety Rails with your child's safety in mind.
They are certified to meet all safety requirements from ASTM International.
Thank you for purchasing a Young America Safety Rail. If you find that you are
missing a part or if a part is defective in any way, contact your Young America Baby
retailer for assistance.
Page 2
/AWARNING
SUFFOCATION AND STRANGULATION HAZARD
Gaps in and around bed rails have entrapped young children and killed infants.
* NEVER use with children younger than 2 years old. Use ONLY with older children who can get in and out of adult bed without
help. NEVER use in place of crib.
* NEVER use unless bed rail is tight against mattress, without gaps, and at least 9 inches from headboard and footboard. Do not fill
gaps with pillows, blankets, or other items that can suffocate children.
« NEVER use on toddler bed, bunk bed, water bed, or bed with inflatable mattress. Use ONLY on adult bed.
e Use only on Young America adult beds with mattress and slat roll.
/\WARNING
ENTRAPMENT HAZARD
NEVER use bedrail without properly securing bed rail to bed. Incorrect installation can allow bedrail to move away from the
mattress, which can lead to entrapment and death.
» Discontinue use if damaged, broken, or if any parts are missing.
**NOTE:
YOUR FURNITURE MAY HAVE DIFFERENT DESIGN
FEATURES THAN THOSE SHOWN IN DRAWING.
America.
MADE IN THE USA
Page 3
STEP 1: Install Pair Bed Safety Rails to Assembled Bed:
NOTE: WHEN INSTALLING PAIR OF BED SAFETY RAILS, THE BED SHOULD BE ASSEMBLED
WITH THE SIDE RAILS IN THE LOW POSITION ONLY!
1. Install 2 Bed Safety Rails as indicated below. The Safety Rail Brackets on the Safety Rails fit into
slots in the slat bearers on the side rails (Refer to Section "A") AND engage on the Top Edge of
the Bed Rails (Refer to Section "B").
2. When properly installed,
a) The bottom of the Bed Safety Rails must rest on top of the Slat Roll
b) The Safety Rail Bracket MUST engage on the top of the Bed Rail (Refer to Section "B").
c) The Bed Safety Rail Warning Label MUST not be visible (Refer to Section "C").
Section "A"
ENGAGED ON SIDE RAIL
AL
INSERT BRACKETS INTO
NOTCHES IN SLAT BEARER
High Position for Side Rails
ZA A BED SAFETY RAILS!!
A
A
( Section "A"
/ |, S |
A, e Install Bed Safety Rails
N 27 | in on inside of Side Rails
\
LZ AS )
VS CR > || |
77 | TE <A su
of = AP E SAZD-
> ЧИН И > “<
E> e > 8
<< rn AAN >
A > MZ
~ I
Bed Safety Rail
\
DO NOT USE WITH
Warning Label
Turn Metal Brackets so that they
face the inside of the Side Rail
SAFETY RAIL WARNING
LABEL IS NOT VISIBLE
\
America.
MADE IN THE USA
Page 4
Additional Warnings
e KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
e Before each usage, inspect bed for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use
bed if any parts are missing or broken. Ask your dealer or write to Stanley Furniture, 200 North Hamilton St
No. 200 High Point, NC 27260 for replacement parts and instructional literature if needed.
e DO NOT substitute parts. Use only parts supplied by manufacturer or parts of comparable quality and equal
dimensions. Do not allow ends of screws or sharp edges to be exposed.
e [f refinishing, use a non-toxic finish specified for children's products.
Cleaning
Mix together a mild solution of gentle dishwashing liquid and water, apply to crib surface using a soft clean
cloth lightly dampened in the solution. Rinse with clear water again using a soft clean cloth, then dry all
surfaces thoroughly with a soft dry cloth. NO ABRASIVE CLEANERS, SCOURING PADS, STEEL WOOL,
OR COARSE RAGS SHOULD BE USED TO CLEAN THIS FINE FURNITURE.
Periodic Maintainance
1. Periodically check to make certain all screws are fastened securely.
2. Check frequently that the bed safety rail brackets are inserted into the notches in the slat bearers.
3. Save this instruction sheet in the event you disassemble the bed safety rails and need to reassemble
them. This instruction sheet will also be useful in identifying replacement parts if needed at a future
date.
Stanley
FURNITURE
200 North Hamilton St
No. 200
High Point, NC 27260
For parts, contact your Stanley dealer. For additional
consumer information, call our Customer Services Department at
1-(800)-659-7297 Mon. - Fri., 8-5 Eastern
youngAmerica.com
ОРСК America.
07102013 MADE IN THE USA
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising