p4professional

p4professional
P4PROFESSIONAL
P4PROFESSIONAL
C H A R G E R
400W 4 PORT PHANTOM 4™
BATTERY CHARGER
O P E R A T I N 1G
© Venom Group International 2016
MA N U A L
venompower.com
Thank you for purchasing the Venom P4 Professional Charger.
This Venom P4 Professional battery charger is designed to charge,
cycle, or storage charge up to four DJI Phantom 4™ batteries
simultaneously.
If you have read the entire manual and still are unclear regarding
any of the functions, warnings, or safety precautions, please
contact our customer service department PRIOR to using this
product.
Warnings & Safety Notes
These warnings and safety notes are VERY IMPORTANT. Please follow the instructions
for maximum safety; misuse can result in damage to the charger and battery. In extreme
cases, improper use can result in bodily injury or property damage.
• Never leave the charger unsupervised when connected to a power supply. If any
malfunction is observed immediately terminate the process, unplug the charger and
refer to the operation manual.
• Keep the charger away from dust, water, heat, direct sunlight and vibration.
• The circuit of this unit can be powered by AC 100-240V power source.
• This unit and the battery to be charged or discharged should only be set upon a heat
resistant, non-flammable and non-conductive surface. Keep all flammable or volatile
materials well away from operating area.
• Be sure to understand the specifications of the battery to be charged or discharged. If the
program is set up incorrectly the battery can be severely damaged. Lithium batteries when
improperly charged or discharged, can cause permanent damage or fire.
• Never attempt to disassemble or repair the charger or batteries. For any issues please
submit a support case at: www.venompower.com/pages/submit-a-support-case
• Lithium batteries prefer a partial rather than a full discharge. Frequent full discharges should be avoided if possible. Instead, charge the battery more often or use a larger capacity pack. (Cycle the battery completely once every 20 charge / discharge cycles to optimize the battery.)
venompower.com
0697
P4PROFESSIONAL
1.
Exterior of the Unit
1
2.
Using Your Charger 2
3.
Notes on the Cycle and Storage Modes
3-4
4.
Charging Your Phantom 4 Transmitter
5
5.Specifications6
6.
Warranty and Service6-7
7.Notes
8
© Venom Group International 2016
venompower.com
1. EXTERIOR OF THE UNIT
FRONT
Status Light
Indicator (X4)
Storage Battery
Mode Button (X4)
Transmitter Charge Port
TRANSMITTER
Cycle Battery
Mode Button (X4)
P4PROFESSIONAL
USB
C H A R G E R
USB
X4 POWER
2.3A USB Ports
100W X4
RIGHT
AC input power:
Input: 100~240 Volt
Circuit power:
Max 100W for charging(X4)
Transmitter:
17.5V out DC
Max 10W for discharging(X4)
USB:
5.3V / 2.3A (X2)
PART#: 0697
ON
OFF
Power Switch
venompower.com
AC POWER
100V - 240V
AC Power Input
1
0697
P4PROFESSIONAL
2. USING YOUR CHARGER
For the charger to operate, the charger must be plugged into
an AC power source and the ON / OFF switch located on the
right side of the unit must be in the ON position.
TO CHARGE
1. Power on the battery by pressing the power button on
the front of the battery once, then quickly press the button a
second time, holding it for up to 5 seconds until the lights on
the battery illuminate.
2. Place the battery in one of the four charging bays ensuring
the power button on the battery is facing the back of the
charger.
3. When the LED STATUS light on the charger illuminates and
turns RED, the battery is charging.
4. When the charge has completed, the LED light will turn
GREEN and begin to flash.
© Venom Group International 2016
2
venompower.com
3. NOTES ON THE CYCLE AND STORAGE MODES
This charger has a maximum discharge amperage of 0.65A
per channel. For this reason it is recommended that the
CYCLE or STORE modes only be used when the Phantom 4
battery has been discharged 50% or less. This is indicated
when no more than two of the four LEDs lights on the
Phantom 4 battery are illuminated. If initiating a CYCLE or
STORE mode process with a fully charged battery, the result
will be a lengthy discharge time. (Up to 8 hours for a CYCLE, 5
hours for a STORAGE charge.)
STORE:
(Recommended if the battery will be idle more than 21 days)
1) Power on the battery by pressing the power button on the
front of the battery once, then quickly press the button a
second time, holding it for up to 5 seconds until the lights
on the battery illuminate.
2) Place the battery in one of the four charging bays ensuring the power button on the battery is facing the back of the charger.
3) Press the “STORE” button that corresponds to that battery
bay.
4) When a storage charge is initiated, the RED LED light on
the charger will begin to flash.
venompower.com
3
0697
P4PROFESSIONAL
3.1 NOTES ON THE CYCLE AND STORAGE MODES CONT.
5. When the storage charge has completed, the LED light on
the charger will turn GREEN and begin to flash.
CYCLE:
Cycle mode will fully discharge the battery and fully charge
the battery after reaching full discharge.
(Cycle the battery once every 20 charge/discharge cycles to
optimize the battery.)
1) Power on the battery by pressing the power button on the
front of the battery once, then quickly press the button a
second time, holding it for up to 5 seconds until the lights
on the battery illuminate.
2) Place the battery in one of the four charging bays ensuring the power button on the battery is facing the back of the charger.
3) Press the “CYCLE” button that corresponds to that battery
bay.
4) The battery is discharging when the LED light on the
charger illuminates ORANGE.
5) When the RED LED light illuminates, the battery is
charging.
6) When the charge has completed, the LED light on the
charger will turn GREEN and begin to flash.
© Venom Group International 2016
4
venompower.com
4. CHARGING YOUR PHANTOM 4 TRANSMITTER
1) Turn off the remote controller before charging.
2) To charge the Phantom 4 transmitter, use the included
transmitter charge lead and plug it into the power
receptacle on the upper right corner on the front
of the charger.
3) Plug the other end of the charge lead into your
Phantom 4 transmitter.
4) The power LED indicator on the transmitter will display
solid RED while charging is in process.
5) The transmitter LED indicator will display a solid GREEN
when the transmitter is fully charged.
venompower.com
5
0697
P4PROFESSIONAL
5. SPECIFICATIONS (PER CHANNEL)
AC input power:
Input AC: 100~240Volt
Circuit power:
Max 100W for charging (X4)
Max 10W for discharging (X4)
Transmitter:
17.5V out DC
USB:
5.3V / 2.3A (X2)
6. WARRANTY AND SERVICE
We are so certain of the quality of our chargers that we offer a Venom® Limited Lifetime
Charger Replacement Plan. Venom® will, at its discretion, repair or replace a defective
charger free of charge within a period of 1 year from the original date of purchase. Year
2 onward, any Venom® charger can be exchanged for a brand new charger of the same
model for 30% off original retail pricing.
This is a non-transferable charger replacement plan and does not cover commercial use,
normal wear and tear, crash or water damage, modifications, or any damages arising as a
result of improper use. We reserve the right to deny replacement to any serial abusers of
our customer friendly policy.
All warranty claims are to be directed to venompower.com/pages/warranty-policy.
Important Notice
Venom® assumes sole responsibility for our products; therefore, dealers should not
be involved in any warranty issues. All warranty claims are to be directed to Venom®
Customer Service. Before returning any defective product, please contact Venom®
at http://venompower.com/pages/submit-a-support-case.
RELEASE OF LIABILITY
Venom®, It’s affiliates, manufacturers, distributors, or retail partners shall not be held
liable for any accident, injury to persons, or damage to property resulting from use,
© Venom Group International 2016
6
venompower.com
misuse, or abuse of any Venom® product. In purchasing a Venom® product the user
agrees to accept responsibility for all such risks.
GUARANTEE
All products are inspected and adjusted individually before leaving the manufacturer and
are guaranteed to be free of material defects and manufacturing faults.
Notice of Rights
All rights reserved. No part of this manual may be reproduced or transmitted in any form
by any means, electronic, mechanical, photocopying, recording, or otherwise, without the
prior written permission of Venom®. For information on getting permission for reprints and
excerpts, contact customerservice@venompower.com.
Notice of Liability
The information in this manual is distributed on an “As Is” basis, without warranty. While
every precaution has been taken in the preparation of the manual, Venom® does not have
any liability to any person or entity with respect to any loss or damage caused or alleged
to be caused directly or indirectly by the information contained in this manual or by the
products described in it.
Charging and discharging batteries has the potential for serious injury to persons and
damage to property. In purchasing this product, the user agrees to accept responsibility
for all such risks, and will not hold Venom®, it’s affiliates, manufacturers, distributors,
or retail partners responsible for any accident, injury to persons, or damage to property
resulting from the use of this product.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
This product may contain sharp edges or objects that can cause cuts or other bodily
injury. To prevent cuts or other bodily injury, avoid contact with sharp edges or objects
while handling.
This product contains chemicals known to the State of California to cause Cancer, Birth
Defects and other Reproductive Harm. Be responsible, dispose of properly.
Actual product may vary from product shown.
venompower.com
7
0697
P4PROFESSIONAL
Notes:
© Venom Group International 2016
8
venompower.com
VENOM GROUP INTERNATIONAL
14028 N. Ohio Street
Rathdrum, Idaho 83858 USA
CUSTOMER SERVICE
North America: 800.705.0620
Outside North America: 208.762.0620
For Customer Service issues
and the quickest warranty service
please visit www.venompower.com
and click the support tab
/venomgroup
0697
venompower.com
/Venom_RC
9
/venomgroupintl
0697
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising