Resetting the Controller

Resetting the Controller
Gocycle Service Notice 4.1: Resetting the Controller
GOCYCLE SERVICE NOTICE 4.1
MANDATORY
HIGHLY
RECOMMENDED
X
RECOMMENDED
WITHOUT SERVICE ACTION, LOWER THAN
EXPECTED PERFORMANCE CAN OCCUR
RECOMMENDED
Resetting the Controller
Service Issue
Controller may need rebooting.
Power to the motor can come on and off intermittently.
Corrective Action
From time to time, the controller may require rebooting—much like a PC. If it appears that the controller
is not functioning correctly, such as intermittent power, perform the following reboot sequence:

Unplug the controller from the battery pack underneath the frame. Wait for 15 seconds. Plug the
controller back into the battery pack. You should here either one beep (EU mode) or two beeps
(USA mode.)

To reset to EU mode (for customers operating Gocycle within the EU): With the Gocycle at a
stop (such as with the brake held on), press and hold the red power button for 7 to 10 seconds
until you hear 1 beep, then release the button immediately.

To reset to USA mode (for customers operating Gocycle with the United States): With the
Gocycle at a stop (such as with the brake held on) press and hold the red power button for about
20 to 50 seconds until you hear 2 beeps, then release the button immediately.
WARNING! Operating the Gocycle in USA mode is not legal on public roads within the EU.
Operating in USA mode within the EU is only legal on private property, such as a racing track.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising