d3190au aero 2000 hair dryer

d3190au aero 2000 hair dryer
AERO 2000
USE & CARE
MANUAL
PLEASE READ
PRIOR TO USE
To register your product go to
www.remington-products.com.au
www.remington.co.nz
2 YEAR WARRANTYD3190AU
IMPORTANT SAFEGUARDS
Warning: When the hair dryer is used in a bathroom, unplug
it after use since the proximity of water presents a hazard
even when the hair dryer is switched off.
When using electrical appliances, especially when children
are present, basic safety precautions should always be
followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
KEEP AWAY FROM WATER
DANGER – As with most electrical appliances, electrical
parts are electrically live even when the switch is off.
To reduce the risk of death by electric shock:
• Always unplug it immediately after using.
• Do not place or store an appliance where it can fall or be
pulled into a bath or sink.
• Do not use while bathing.
• Do not place or drop into water or other liquid.
• If an appliance falls into water, “unplug it” immediately.
Do not reach into the water.
For additional protection, the installation of a residual current
device (RCD) with a rated residual operating current not
exceeding 30mA is advisable in the electrical circuit supplying
the bathroom. Ask your electrical contractor for advice.
WARNING – TO REDUCE THE RISK OF BURNS,
ELECTROCUTION, AND FIRE, OR INJURY TO PERSONS.
•
•
An appliance should never be left unattended when plugged in to a power
outlet.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
2
•
•
•
•
•
•
•
•
•
concerning use of the appliance by a person responsible for their safety.
Keep the appliance and the power cord away from the edge of table
or countertops and out of reach of children and persons with reduced
physical, sensory or mental capabilities.
This appliance is not a toy. Children shall be supervised to ensure they do
not play with the appliance.
Use this appliance only for its intended use as described in this manual.
Do not use attachments not recommended by Remington.
If the supply cord is damaged, it must be replaced by the manufacturer,
its service agents or similarly qualified persons in order to avoid a hazard.
Do not use on people who are sleeping.
Never drop or insert any object into any opening of this appliance.
Do not use outdoors or where aerosol (spray) products are being used or
where oxygen is being administered.
Do not direct hot air towards the eyes or other heat sensitive areas.
Attachments, where provided, may be hot during and after use. Allow
them to cool before handling.
When using the appliance, keep your hair away from the air inlet grille. Do
not let your hair get drawn into the appliance.
SAVE THESE INSTRUCTIONS
3
D3190AU AERO 2000 HAIR DRYER
USE AND CARE INSTRUCTION MANUAL
Thank you for purchasing your new Remington® Aero 2000 hair dryer.
This is a powerful 2000 watt dryer with a concentrator attachment and cool
shot button for versatile drying and styling power.
1
2
3
4
5
KEY PARTS
1.
2.
3.
4.
5.
6.
7.
8.
6
Concentrator
Air Outlet grille
Air Inlet grille
Cool shot button
Speed settings
0 – Off
x – Low speed
X – High speed
Heat settings
Low heat
Medium heat
High heat
Handle
Hang loop
7
8
4
HAIR MAINTENANCE
For optimal results, shampoo and condition your hair prior to styling and towel
dry to remove excess moisture.
QUICK DRYING
Select a high heat and high speed setting and roughly dry your hair. Use a brush
or your hand to shake out excess moisture whilst drying, keeping the hair dryer
moving constantly.
STRAIGHTENING
Select high heat and speed and roughly dry the hair. When the hair is nearly
dry, attach the concentrator nozzle (which minimises frizz) and reduce the heat
and speed. Section the hair according to thickness and begin with straightening
the bottom layers first. Using a round or flat brush, follow the brush with the
concentrator from above, gliding down each section of hair from roots to tips.
Once the bottom layers have been straightened, then straighten the mid section
and complete by straightening the top layers.
NATURAL WAVY TEXTURE
Using a low heat/speed setting, `scrunch’ sections of hair with your fingers into
the palm of your hand, while directing the airflow through your fingers. For more
volume lean forward and dry the hair in the upside down position.
LIFT & VOLUME
Using the hair dryer on low heat/speed setting, work from the roots of the hair
and begin at the back of the head. Section your hair and use a brush or fingers
to dry against its natural growth pattern. This creates lift at the roots, which
creates a style with volume.
COOL SHOT
This hair dryer is equipped with a cool shot that is used to set your hairstyle.
Squeeze and hold the cool shot button to rapidly cool and set your hair once it
has been styled.
STYLING
Set the hair dryer to low heat/speed setting and attach the concentrator nozzle
for precision drying. Section the hair and style using a round thermal styling
brush. Concentrate the airflow directly on the hair while styling in the direction
you desire. If necessary, hold the airflow for 2 – 5 seconds on each section
while curling under or over for additional hold.
5
USER INSTRUCTIONS
This hair dryer is equipped with a thermostat that will cycle ‘OFF’ if the
temperature exceeds the comfort level due to partially blocked air inlet or air
outlet openings. In the event that the hair dryer stops during use, turn off all
switches and allow the hair dryer to cool down, at which time the thermostat
will automatically reset. Before using again, check that the air inlet and air
outlet openings are not blocked. Unplug the hair dryer and clean the openings
if necessary. During use, do not block the air openings or let your hair be drawn
into the hair dryer.
MAINTENANCE
Your hair dryer is designed for household use and is virtually maintenance free.
No lubrication is needed. When cleaning becomes necessary, turn all switches
off and disconnect the hair dryer from the power outlet.
To maintain peak product performance, it is important to clean the air inlet grille
at the back of the hair dryer. To access the air inlet filter simply apply thumb and
index pressure to the side of the grille and pull away from the dryer. The filter
and grille can now be cleaned with a soft brush or a vacuum cleaner. To replace,
align the three lugs on the rear grille with the three notches at the back of the
hair dryer. The exterior of the hair dryer can be cleaned by wiping it with a damp
cloth.
STORAGE
When not in use, always unplug the hair dryer from the power outlet. Allow the
hair dryer to cool and store out of the reach of children in a safe, dry place.
Never wrap the power cord around the hair dryer as this will cause the cord to
wear prematurely and break. Handle the cord carefully for long life and avoid
jerking, twisting or straining especially at the plug connections. If the cord
becomes twisted in use, periodically straighten it.
You may also use the hang loop to store the hair dryer within convenient reach,
ensuring that water cannot be splashed onto it when it is hung up.
WARNING: Do not use this appliance near bathtubs, showers, basins or
other vessels containing water.
As with all electrical appliances, the power cord must be regularly
checked for wear and tear. Immediately cease using this product if the
power cord shows any signs of damage.
This product conforms to radio frequency interference requirements.
Any product purchased and used commercially carries a limited 90 Day Warranty.
6
Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Limited
WARRANTY AGAINST DEFECTS
In this warranty:
Australian Consumer Law means the Australian consumer law set out in Schedule 2 to the
Competition and Consumer Act 2010;
CGA means the New Zealand Consumer Guarantees Act 1993;
Goods means the product or equipment which was accompanied by this warranty and purchased
in Australia or New Zealand, as the case may be;
Manufacturer, We or us means:
1. for Goods purchased in Australia, Spectrum Brands Australia Pty Ltd
ACN, 007 070 573; or
2. for Goods purchased in New Zealand, Spectrum Brands New Zealand Limited,
as the case may be, contact details as set out at the end of this warranty;
Supplier means the authorised distributor or retailer of the Goods that sold you the Goods
in Australia or in New Zealand; and
You means you, the original end-user purchaser of the Goods.
1. Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law, or the CGA. You are entitled to a replacement or refund for
a major failure and compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods
fail to be of acceptable quality and the failure does not amount to a major failure.
2. The benefits provided by this Warranty are in addition to all other rights and
remedies in respect of the Goods which the consumer has under either the
Australian Consumer Law or the CGA. The original purchaser of the Goods is
provided with the following Warranty subject to the Warranty Conditions:
3. We warrant the Goods for all parts defective in workmanship or materials for the
period of two (2) years from the date of purchase (Warranty Period). If the Goods
prove defective within the Warranty Period by reason of improper workmanship or
material, we may, at our own discretion, repair or replace the Goods without charge.
Warranty Conditions
4. The Goods must be used in accordance with the manufacturer’s instructions. This
Warranty does not apply should the defect in or failure of the Goods be attributable
to misuse, abuse, accident or non-observance of manufacturer’s instructions on the
part of the user. As far as the law permits, the manufacturer does not accept liability
for any direct or consequential loss, damage or other expense caused by or arising out
of any failure to use the Goods in accordance with the manufacturer’s instructions.
5. Exhaustible components (such as shaver heads, cutters and foils) of the Goods are included
under this Warranty only where there is a defect in workmanship or materials used.
6. The warranty granted under clause 3 is limited to repair or replacement only.
7. Any parts of the Goods replaced during repairs or any product replaced remain the
property of the manufacturer. In the event of the Goods being replaced during the
Warranty Period, the warranty on the replacement Goods will expire on the same
date as for the Warranty Period on the original Goods which are replaced.
7
8. In order to claim under the warranty granted under clause 3 you must:
(a) Retain this warranty with your receipt/proof of purchase; and
(b) Return the Goods to us at the relevant address below or to the Supplier by prepaid freight
within the Warranty Period accompanied with (i) the legible and unmodified original proof
of purchase, which clearly indicates the name and address of the Supplier, the date and
place of purchase, the product name or other product serial number and (ii) this warranty.
9. This warranty is immediately void if:
(a) Any serial number or appliance plate is removed or defaced;
(b) The Goods have been serviced or otherwise repaired by a person not
authorised to do so by us or where non approved replaced parts are used.
10. The Goods are designed for domestic use only. A limited 90-day Warranty applies to
any industrial or commercial use of the Goods. The Goods must be connected to the
electrical voltage requirements as specified in the ratings label located on the Goods.
11. This warranty does not cover the cost of claiming under the warranty
or transport of the Goods to and from the Supplier or us.
12. This warranty is only valid and enforceable in Australia against Spectrum Brands
Australia Pty Ltd and in New Zealand against Spectrum Brands New Zealand Limited.
Contact us or the Supplier for further details.
Spectrum Brands Australia Pty Ltd
Locked Bag 3004
Braeside, VIC 3195
AUSTRALIA
Customer service in Australia: 1800 623 118
E-mail: consumer.enquiry@remington-products.com.au
Website: www.remington-products.com.au
Spectrum Brands New Zealand Limited
PO Box 9817
Newmarket, Auckland 1149
NEW ZEALAND
Customer service in New Zealand: 0800 736 776
E-mail: info@remington.co.nz
Website: www.remington.co.nz
REMINGTON SERVICE HOTLINE
Australia 1800 623 118 (toll free)
New Zealand 0800 736 776 (toll free)
® Registered Trademark of Spectrum Brands, Inc. or one of its subsidiaries
©2016 Spectrum Brands, Inc.
Rev. 07/16
Part No. T22-0004511
8
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising