GETTING TO KNOW YOUR TElsTRA PRE

GETTING TO KNOW YOUR TElsTRA PRE
GETTING TO
KNOW YOUR
Telstra
Pre-paid
4G USB
LET’S GET THIS SHOW
ON THE ROAD
WHAT’S
INSIDE
Your Telstra Pre-Paid 4G USB has been tested to
the highest standards to deliver you the best
possible coverage and speed experience on the
network without equal.
03 Safety first
This guide will help you get connected as quickly
and as easily as possible. It’ll guide you through
installation and run through all the handy extra
features that are included.
06 Let’s get started
09 Getting connected
13 Device home page
16 Extra features
17 Problem solving
20 Extra bits you should know
If all goes to plan you’ll be up and running in no time,
so you can get connected whilst on the move.
2
SAFETY
FIRST
Please read all the safety notices before using this device.
RADIO FREQUENCY ENERGY
This device is designed to be used at least 20cm from
your body. Do not use the device near fuel or chemicals or
in any prescribed area such as service stations, refineries,
hospitals and aircraft. Obey all warning signs where posted.
Your wireless device is a low-power radio
transmitter and receiver. When switched on it
intermittently transmits radio frequency (RF)
energy (radio waves).
The transmit power level is optimised for best
performance and automatically reduces when
there is good quality reception. Maximum
power is only used at the edge of network
coverage so under most circumstances the
power output is very low. Under poor network
conditions the device transmits at a higher
power, may get hot and have a significantly
shorter battery life.
RADIO FREQUENCY SAFETY INFORMATION
The device has an internal antenna. For optimum
performance with minimum power consumption do not
shield the device or cover with any object. Covering the
antenna affects signal quality, may cause the device to
operate at a higher power level than needed, and may
shorten battery life.
3
4
LET’S GET
STARTED
DECLARATION OF CONFORMITY –
SPECIFIC ABSORPTION RATE (SAR)
Your package contains the following:
N14945
The wireless device is designed to be used at
least 20cm from the body. We declare that
the product detailed in this manual, and in
combination with our accessories, conform with
the essential requirements of The Radio
Communications Standard (Electro-magnetic IC
Radiation Human Exposure) 2003 and the Australian
Communications and Media Authority Section
376 of the Telecommunications Act 1997 when
used at a distance of not less than 20cm from
the body. The worst case SAR result is published on
the manufacturer’s website at zte.com.au
• Telstra Pre-Paid 4G USB
• Telstra Pre-Paid Next G® SIM card
• Telstra Pre-Paid Welcome Guide
• Getting Started Guide
• USB extension cable
• Manufacturer’s Warranty Card
ROHS DECLARATION
(RESTRICTION OF HAZARDOUS SUBSTANCES)
ZTE declares that the Wireless device is free from
hazardous materials and complies with EU directive
2002/95/EC (commonly known as the RoHS Directive)
and the amendments.
5
6
YOUR TELSTRA
PRE-PAID
4G USB
LED Indicator
The LED lights indicate the status of your device and when
you are sending or receiving data.
LED Indicator
Dual Antenna Ports
7
LED Indicator
Status
Red blinking
Offline. Not registered on network
Green solid
Registered on 4G network
Green blinking
Active data transfer on 4G network
Blue solid
Registered on 2G/3G network
Blue blinking
Active data transfer on 2G/3G network
8
GETTING
CONNECTED
1. Insert sim card
2. SETTING UP YOUR DEVICE
•Your SIM card should already be inside the device. Check
to make sure. To remove top cover gently slide back cover.
Insert USB into USB port on your PC or other device.
•To Insert the SIM card, slide in as shown
with the gold chip facing down. Replace cover.
9
•The Setup Wizard will run automatically and after
a couple of minutes a new desktop icon called Telstra
Pre-Paid 4G USB will be installed.
10
•You can double click on the icon or open a browser and
type in http://m.home to manage your connection
settings if required.
If the Setup Wizard doesn’t start automatically then
select Computer from your Desktop or Start Menu.
Select the file AutoRun.exe or the file with a Telstra logo
and follow the prompts.
You are now ready to activate your SIM card.
3. activate your sim card
•Activate your SIM card online via telstra.com/activate
You can also activate your SIM via the Device home page.
•To activate via the Device home page click on the desktop
icon called Telstra Pre-Paid 4G USB or enter http://m.home
into a browser.
•Scroll to the bottom of the page and click on Account
Services. Follow the prompts to activate.
If you have any issues activating you can contact our
support centre on 125 8880 or from a non-Telstra phone
call 13 2200 and say “Pre-Paid”.
For more information on activating and managing your
service see your Telstra Pre-Paid Welcome Guide.
4. ENDING YOUR SESSION
•Select Disconnect from the Device home page then
unplug your device.
11
12
device
HOME PAGE
You can activate, check data usage and change the
settings of your Telstra Pre-Paid 4G USB through
your Device home page.
To access your home page double click on the
desktop icon called Telstra Pre-Paid 4G USB or
enter http://m.home into a web browser.
ou can only access the Device home page while
Y
your device is connected.
For full details on using your Device home page,
click on Help, located in the top right of your
home screen.
Handy Hint: You need to select the Disconnect button from
the home screen before you can adjust any settings.
Check data usage
•Click on the Information tab from the home screen
then select Record for a summary of usage.
or
• For a more detailed view, click on ‘Click here to
access your Account Services’.
• Click on ‘Check usage’ or login to My Account.
• You will need a username and password or you may
need to register.
13
14
EXTRA
FEATURES
Add or CHANGE SIM PIN
CONNECTING AN EXTERNAL ANTENNA
• Click on the Disconnect button on the home screen
to disconnect your device.
Your Telstra Pre-Paid 4G USB works with a Mimo Dual TS9
port antenna which is available from your retailer. Insert
the connectors carefully to avoid damage to your device.
• From the Settings tab select Device settings,
then click USIM PIN Management.
• Select Enable, then enter a PIN and click Apply.
USING A MEMORY CARD (OPTIONAL ACCESSORY)
ou can also use your device as an external storage drive
Y
when connected via USB.
ou will need a microSDHC card (store up to 32GB).
Y
Open the back cover of the device by sliding it down
and insert the memory card as shown.
Handy Hint: By default your Pre-Paid SIM card has no
existing PIN.
15
16
PROBLEM
SOLVING
HAVING TROUBLE GETTING ONLINE?
WARRANTY AND SUPPORT
There are a number of factors that could prevent you from
connecting to the internet. Try these troubleshooting steps.
•All calls and support for PIN numbers, SIM card registration,
account and billing information, network services and other
general enquiries should be directed to Telstra.
1. Install and test the USB device in another computer
2. Check your SIM card is working in another device e.g. mobile phone
3. Insert a known working SIM card into your USB device
4. Confirm your account is active - contact Telstra
5. Uninstall the USB device and re-install using
Windows ‘Safe Mode’ - consult a PC technician for
help if required (PC only)
For help topics you can chat to us at livechat.telstra.com
or visit telstra.com/ppmbb
17
Call 125 8880 or from a non-Telstra phone call 13 2200
and say “Pre-Paid”.
•See your warranty card for warranty and service
information.
•For additional information you can access the full user
manual by clicking Help from your Device home page or via
zte.com.au
18
Extra bits
you should know
Technical specifications
coverage
Network and
Frequency Band
Tri Band 4G 900/1800/2600 MHz
Dimensions (W×H×D)
90 x 28.4 x 13mm
Dual Band 3G 850/2100 MHz
Quad Band 850/900/1800/1900 MHz
Weight
26g
microSD™ or
microSDHC™ card
Up to 32GB
External Antenna Ports
TS9
Operating Systems
Microsoft Windows 7, Windows 8
(Windows RT not supported), Windows
Vista® and Windows® XP 32 and 64 bit.
Coverage depends on your location, device and
whether your device has an external antenna attached.
Visit telstra.com/mbb-coverage to check if you
are covered.
NETWORK LOCK
•Your wireless device is locked to the Telstra network.
®
Mac OS 10.5.8 and above.
®
•When you insert a non-Telstra SIM card you are presented
with unlock instructions.
•Contact Telstra to obtain your 16 digit unlock code.
•An unlocking fee may apply.
•5 incorrect attempts will block the unlock process and the
device will then only work with a Telstra SIM card.
•Contact Telstra for more information.
19
20
NOTES
Windows and Windows Vista are trademarks of the Microsoft
group of companies. The spectrum device is a trade mark
of Telstra Corporation Limited. ™ and ® are trade marks
and registered trade marks of Telstra Corporation Limited
ABN 33 051 775 556.
21
22
FOR MORE INFORMATIoN:
125 8880
telstra.com/ppmbb
Visit a Telstra Store or Partner
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising