MODEL 7050 50 PSI Compressor Operator`s Manual

MODEL 7050 50 PSI Compressor Operator`s Manual
MODEL 7050
50 PSI Compressor
Operator’s Manual
CONTENTS
Page No.
INSPECTION……………………..…………………………….….….……1
GENERAL INFORMATION……………………………………….…….…1
SAFETY PRECAUTIONS…………………………………………………2
BASIC OPERATING COMPONENTS……………………………………3
OPERATING INSTRUCTIONS……………….……………….………….4
-Initial Positioning and Installation….……………………….….…….……4
-Operation……………………………..…………………………………4
ROUTINE MAINTENANCE………………….…………….………….…..5
-Removing and Cleaning the Air Intake Filter..……………………….……5
SPECIFICATIONS………………………………………….…..….………6
TROUBLE SHOOTING…………………………………….….….……….7
SYMBOLS……………………………………………………….……….…7
LIMITED WARRANTY…..………...………………………….….….…….8
INSPECTION
Upon receiving your Probasics Model 7050 Compressor, inspect the packaging for
signs of damage in transit. Inspect the unit thoroughly. Any sign of damage, external or
internal, should be reported to your Homecare Dealer immediately.
GENERAL INFORMATION
This manual provides information necessary to operate the Probasics Model 7050
50 PSI Compressor. This unit is designed for efficient, continuous high pressure
performance. The Model 7050 Compressor provides high pressure which clinical
studies have indicated are required for optimal particle size (2 microns or less).
The unit operates quietly and effectively due to the unique design of the WOBL piston.
This unit operates using standard 120 VAC current, it is easy to clean, very low
maintenance, compact, light-weight, and portable. The unit is designed for use with:
-Compatible with hand-held nebulizer system.
-Heated nebulizer.
-Dual action humidifier/nebulizer.
-Pediatric mist tent.
-High output pneumatic nebulizer .
-Deluxe nebulizer with oxygen diluter.
-Child / adult mist tent.
1
SAFETY PRECAUTIONS
When using electrical products, especially when children are present, basic safety
precautions should always be followed. Read all instructions before using.
Important information is highlighted by these terms:
DANGER
Urgent safety information for hazards that will cause serious injury or death.
WARNING
Important safety information for hazards that might cause serious injury.
CAUTION
Information for preventing damage to the product.
NOTE
Information to which you should pay special attention.
READ ALL USER’S MANUAL BEFORE USING.
SAVE USER’S MANUAL
Note
Connect power cord and plug to properly grounded wall outlet or adapter.
Note
Unplug the power cord when it is necessary to disconnect AC power source.
Note
The NCA01 TRITON-Comp. is not designed to drive ventilators.
Note
Follow the national requirement to dispose unit.
Caution
Ingestion of aerosols into the compressor may result in damage to the unit and void the
limited warranty.
2
BASIC OPERATING COMPONENTS
PRESSURE GAUGE
(Indicates pressure)
HANDLE
REGULATOR
(Determines
Pressure output)
INTAKE FILTER
OUTLET
POWER RESET
(Restarts unit
after overload)
POWER CORD
ON/OFF SWITCH
(Starts and stops unit)
"On" position
FIGURE 1
"Off" position
3
OPERATING INSTRUCTIONS
INITIAL POSITIONING AND INSTALLATION
1. Select a suitable location for the unit near a 120 VAC, 15 Ampere, grounded power
outlet.
2. Grasp handle on top of cabinet and position the unit so that operating controls are
Accessible to the user and back of unit is away from wall.
3. Make certain that the power switch located in the center of the control panel is in the
OFF position (Figure 1) and plug power cord into grounded power outlet or grounded
adapter.
4. Be certain that all connections to outlet ( i.e. tubing , nebulizers , etc.) are snug and
not leaking aerosol.
5. When used in conjunction with mist tents, etc., place unit outside of tent and place unit
at a level below discharge end of the delivery tubing.
OPERATION
1. Press Power On/Off switch to ON position (figure 1).
2. Connect the equipment you intend to use with the Probasics Model 7050 compressor
and then adjust the pressure that the unit is delivering by adjusting the regulator (figure 1)
as follows:
a. Pull regulator knob out to unlock adjustment.
b. Turn dial of regulator to desired pressure.
-clockwise – increase pressure
-counter clockwise – decrease pressure
c. Push knob towards unit locking regulator pressure.
…and observe the pressure gauge – adjust up or down to desired output pressure.
4
ROUTINE MAINTENANCE
REMOVING AND CLEANING/REPLACING THE FILTERS
Pull air intake filter out from front of unit (figure 1) and replace a new one when dirty.
Do not wash it.
Pull cabinet filter out from back of unit (figure 2) and wash in warm soapy water and
rinse weekly. Use a soft absorbent towel to remove excess water and place filter back
in unit. User is requested to perform and record when the filters are replaced or
cleaned.
Caution
Do not submerge in water as this will result in damage to the vacuum pump.
CABINET
FILTER
FIGURE 2
5
SPECIFICATIONS
Size (L) x (W) x (H)
12.2 x 7.7 x 15.3 in
Weight
17.2 lbs
(310 x 196 x 390 mm)
(7.8kg)
Model
NCA01L
Electrical Requirements
115 VAC
60Hz
Flowrate @ Pressure
0
41
10
20
30
40
50
34
27
22
16
11
Power Consumption (W)
@ 0 PSI
170
Operating Temperature range
50° F~ 104° F (10 ~ 40°C)
Operating Relative Humidity
95%
Storage & Transport Temperature/Relative Range
room condition preferred
Circuit Breaker
5A 125/250 VAC
Equipment Classifications
With respect to protection from
Electrical shock ClassΠ
Electrical hazard protection class: Type B
Degree of protection against the ingress of water: IPX0- Protection is not provided.
No AP/APG: Equipment not suitable for use in the presence of a flammable anaesthetic
mixture with air/oxygen or nitrous oxide.
6
TROUBLE SHOOTING
If the Probasics Model 7050 Compressor malfunctions, refer to the trouble shooting
chart below for probable cause and remedy.
If the unit fails to operate correctly after
using the troubleshooting chart below, contact your Homecare Dealer for further
assistance.
TROUBLE SHOOTING CHART
PROBABLE
TROUBLE
A. Unit not operating
REMEDY
CAUSE
1. Plug not firmly in wall.
1. Check plug at outlet .
2. No power at wall outlet
2. Check power source,
fuse in house
B. Limited air flow
1. Faulty Delivery Tubing.
2. Leak
Blocked intake filter.
C. All other problems
1. Disconnect delivery tubing
at outlet . If proper flow is
restored, check
equipment and tubing for
obstructions or kinks.
Replace if needed.
2. Check fitting at outlet and
tubing.
3. Replace air intake filter.
1. Contact Homecare Dealer.
Symbols
UL 60601-1 Table DI, IEC symbols
7
LIMITED WARRANTY
The compressor portion of the Probasics Model 7050 Compressor is warranted to be
free from defective workmanship and materials for a period of one year from date of
purchase by the dealer, as a result of normal use and service for purpose for which it
was intended, as determined by PMI. PMI will replace the part or parts so determined
by it to be defective with new/rebuilt parts. Any defective part(s) will be repaired or
replaced at PMI’s option. The Homecare Dealer must obtain prior approval from PMI
before returning the unit for repair.
NOTE
This warranty does not cover providing a loaner unit, compensating for costs incurred in
rental while said unit is under repair, or costs for labor incurred in repairing or replacing
defective part(s).
THERE IS NO OTHER EXPRESS WARRANTY. IMPLIED WARRANTIES, INCLUDING
THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE,
ARE LIMITED TO THE DURATION OF THE EXPRESS LIMITED WARRANTY AND TO
THE EXTENT PERMITTED BY LAW ANY AND ALL IMPLIED WARRANTIES ARE
EXCLUDED. THIS IS THE EXCLUSIVE REMEDY AND LIABILITY FOR
CONSEQUENTIAL AND INCIDENTAL DAMAGES UNDER ANY AND ALL
WARRANTIES ARE EXCLUDED TO THE EXTENT EXCLUSION IS PERMITTED BY
LAW. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED
WARRANTY LASTS, OR THE LIMITATION OR EXCLUSION OF CONSEQUENTIAL
OR INCIDENTAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY
NOT APPLY TO YOU.
This warranty gives you specific legal rights, and you may also have other rights, which
vary from state to state.
For Service Call Your Authorized Probasics Homecare Dealer:
15 South Main Street
2nd Floor
Marlboro, New Jersey
07746
Phone: 732-683-1900
Fax:
732-683-1945
www.pmiusa.biz
8
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising