RS-800 Quick Installation Guide

RS-800 Quick Installation Guide
RS-800 Quick Installation Guide
1
10
14
8
2
3
6
5
12
4
15
13
11
9 13
7
1
Power Button
2
USB 2.0 (x2)
3
COM Port
4
Mini DP (x8)
5
Audio Out
6
LAN Ports (x2)
7
USB 3.0 (x2)
8
Display Port
9
HDMI Output
10 VGA Port
11
DVI
12
PS/2 Port
13 USB 2.0 (x4)
14
Power Switch
15
AC in
Package content:
- Power Cord
RapidSignage - Rapid Digital Signage Deployments
www.rapidsignage.com
RS-800 Configuration
Direct Connect:
1.
Connect the provided power adapter into the AC in (15)
2.
Connect Ethernet cable to the computer and to LAN port (6).
3.
Connect Mini DP cable to Mini DP port (4) to an Videowall.
4.
Configure your computer system’s network settings to:
a. IP address (TCP/IPv4): 192.168.100.2
b. Subnet mask: 255.255.255.0
5.
Open your browser (Google Chrome is recommended) and connect to the RS-800:
c. Default URL: http://192.168.100.1
d. Default login: admin
e. Default password: admin
RapidSignage - Rapid Digital Signage Deployments
www.rapidsignage.com
With DHCP networking:
If you want the RS-800 connect to a DHCP network, you need to directly connect with RS-800 first
and change the networking setting of the RS-800:
1.
Click SystemConfig on the main page of RS-800, then click Network config Tab.
2.
Double-click textbox of DHCP and make sure DHCP is turned on, then Click Apply.
3.
Click Power tab, and click Reboot button to reboot the RS-800.
4. After reboot, the RS-800 IP address will be displayed on the boot screen.
Example:
Change the RS-800 into the diagram below:
AP / Router / Switch
RapidSignage - Rapid Digital Signage Deployments
www.rapidsignage.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement