universal x10 sender sm10

universal x10 sender sm10
MARMITEK
IH2040/08943
UNIVERSAL X10 SENDER SM10
Qualities
KEY Features:
* Connects to an existing alarm system and sends X-10
codes on the power line when an alarm is tripped.
* Provided with three selectable programs.
* Triggered by a contact closure or a low voltage input.
IH2040
-
© SM10
- Flash all lights in your home when your existing burglar alarm trips
or Blast your stereo when your alarm trips.
- Connect the powerflash to a magnetic switch to turn on lights when a
door or window opens, I.e. you don't have to own a burglar system.
- Trigger it from sensors such as a photo cell to turn on lights when it
gets dark, from a motion detector to turn on lights when someone
enters a room, ...
Applications
Connects to an existing alarm system and turns on lights when alarm trips. It has 3 modes of operation:
In Mode 1, the POWERFLASH will turn ON all Lamp Modules and Wall Switch Modules set to its House code
and will also turn ON any other Modules set to its Unit code, e.g. a stereo connected to an Appliance Module.
All Lamp Modules and Wall Switch Modules are left in the ON state when the alarm is de-activated but the
Module set to the same unit code as the SM10 will be in turn OFF state.
In Mode 2, the POWERFLASH will FLASH all lights connected to Lamp Modules or Wall Switch Modules. All
Lamp and Wall Switch Modules will be left in the ON state when the alarm is de-activated but Appliance Modules
set to the same House code as the SM10 will be in turn OFF state.
In Mode 3, the POWERFLASH will turn On all Lamp Modules and Wall Switch Modules set to the address as
programmed with the House and Unit code dails on the interface. When releasing the terminals, an Off command
is send to the set-up address.
Set the input switch to A for triggering the interface by a low voltage input (6-8 VAC, DC or audio), to B for
triggering the interface by a dry contact closure. Do not connect 220V to the input terminal!
The Powerflash has a test button which allows you to activate it whether or not it is connected to an alarm
system. The "All light Off" button allows you to turn Off anything which has been turned on by the interface.
To install the Powerflash: (It is expected to be installed inside the security controller panel)
- Connect the alarm output of the security panel to the screw terminals
- Connect the flying lead to the 230V power supply, most likely at the 230V side of the transformer.
Technical information
Supply current:
230V +/- 10% 50Hz
<= 20 mA capacitive
EMC emission:
according to EN 50081-1
EMC immunity:
according to EN 50082-1
Electrical safety:
according to EN 60950 and EN 60065
X-10 Powerline:
120kHz +/- 2kHz / 5 Vpk - pk
Ambient temperature:
- 10° C to + 50°C (operation) / -20° C to + 70° C (storage)
Dimensions:
55 x 90 x 38 mm (width x heigth x depth )
Supply voltage:
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement