Electric Mirror Integrity Lighted Mirror Installation Instructions

INTEGRITY™
LIGHTED MIRROR
Installation Instructions
IMPORTANT SAFTEY INSTRUCTIONS
Must be installed by a qualified technician.
Read these installation instructions. Keep these instructions for future use.
Follow all instructions. Install in accordance with manufacturer's instructions.
FAILURE TO FOLLOW INSTRUCTIONS COULD RESULT IN DEATH OR SERIOUS INJURY.
FAILURE TO FOLLOW INSTRUCTIONS VOIDS WARRANTY.
This luminaire must be mounted or supported independently of an outlet box.
Make sure electrical connections are wired correctly. Power and neutral wires must
be connected to the luminaire disconnect. Insert the power wire into the black colored
insert and the neutral wire into the white colored insert.
The ground must be connected. Do not defeat the safety purpose of the grounding wire inside the chassis.
The chassis must be grounded to avoid possible electrical shock.
CAUTION
READ ALL INSTRUCTIONS PRIOR TO INSTALLATION
WARNING:
TO PREVENT INJURY, THE MIRROR MUST BE INSTALLED IN ACCORDANCE WITH THE MANUFACTURER’S
INSTRUCTIONS
CAUTION: THE ONLY USER SERVICEABLE PARTS INSIDE ARE THE LAMPS.
OTHER COMPONENTS MUST BE SERVICED BY QUALIFIED ELECTRICIANS. LUMINAIRE DISCONNECT MUST BE
DISCONNECTED PRIOR TO COMPONENT SERVICING
UNPACKING YOUR LIGHTED MIRROR
Verify Contents
Prior to installation, unpack items and verify contents. The lighted mirror comes with 2 boxes and lamps:
BOX 1: CHASSIS ASSEMBLY
Label will include part number: INT-(size)-C
2
BOX 2: MIRROR ASSEMBLY WITH INTEGRAL HANGERS
Label will include part number: INT-(size)-M
THERE’S ONLY ONE™ ELECTRIC MIRROR® | E [email protected] | T +1 425 776-4946 | F +1 425-491-8200 | W www.electricmirror.com
INSTALLATION
1. MOUNT THE CHASSIS ON THE WALL
Before mounting chassis on wall, identify mirror location on wall. Drill marks should be measured
from the edge of the mirror NOT FROM EDGE OF CHASSIS. There are multiple mounting holes that can be
chosen from to accommodate mounting locations. The chassis shall be installed with a minimum of (4) 1/4” x
1-1/2” lag screws or other engineering approved fasteners. Use wall anchors or reinforced backing areas to support
chassis. See individual product specifications for mounting hole locations.
2. INSTALL LAMPS
Lamps should fit within the lamp holders provided in chassis. Rotate lamps to lock into place.
3. WIRING DETAILS
Please note, all electrical installations should be carried out by a fully qualified electrician in conformance with the
National Electrical Code and local building codes.
4. POWER CONNECTION
Before proceeding to power supply wiring, make sure the MC cable is brought in through the wall and into the
chassis knockout. Insert ground wire in the grounded connector. Insert the hot and neutral wires into the luminaire
disconnect. The hot wire is inserted into the black port (number 1) and the neutral wire is inserted into the white
port (number 2).
THERE’S ONLY ONE™ ELECTRIC MIRROR® | E [email protected] | T +1 425 776-4946 | F +1 425-491-8200 | W www.electricmirror.com
3
5. MIRROR MOUNTING
After wiring process is completed, mirror is ready to be hung on the chassis. The weight of the mirror is supported
at the top of the chassis. The mirror clip, at the bottom of mirror, is used to keep the mirror from moving away
from the wall. Hang mirror on chassis by aligning tabs on chassis through mirror hanger slots while holding the
mirror against the chassis. Slide the mirror down inserting the chassis tabs into the hanger slots. Make sure both
tabs are engaged through hanger slots and the mirror clip overlaps the hanging bracket clip.
4
THERE’S ONLY ONE™ ELECTRIC MIRROR® | E [email protected] | T +1 425 776-4946 | F +1 425-491-8200 | W www.electricmirror.com