V1 FINAL FOR PRINT RF-MONO70C I 70" Carbon Fiber Monopod Quick Setup Guide Features Using your monopod To set up your monopod: 1 Unscrew the leg locks and extend the leg to the desired length. 2 Tighten the leg locks to adjust the monopod to the desired height. Caution: Incorrectly securing a leg lock can cause the monopod leg to retract unexpectedly and could result in damage to the monopod or to the attached camera or camcorder. 3 To remove the mounting plate, unscrew the quick-release plate locking knob, then press the safety lock pin and lift the plate away from the head. 4 Secure your camera or camcorder to the mounting plate with the 1/4" screw on the bottom of the plate. Tighten the screw firmly to avoid unintended lateral movement of your device. Package contents • Monopod with pan head • Mounting plate Note: mounting plate is on the pan head. • Wrench (1) • Quick Setup Guide Important safety instructions • Make sure that all levers, handles, knobs, and leg locks are correctly tightened before use. • Do not carry or transport the monopod with camera equipment attached (for example, over your shoulder or cradled in your arms). • Do not store or expose your monopod to excessive heat or cold, or use near any flame or fire. • Do not oil or grease any part of the monopod. • Do not use any solvents or thinners to clean your monopod. Use only a mild detergent and wipe dry with only a soft, lint-free cloth. • Do not exceed the load limit of this product. (See Specifications) Specifications Model RF-MONO70C Folded height Minimum operating height Maximum operating height Maximum tube diameter Net weight Maximum load capacity 22.8 in (579 mm) 22.8 in (579 mm) 70 in (1778 mm) 1.14 in (29 mm) 1.82 lbs. (820 g) 20 lbs. (9 kg) One-year limited warranty Visit www.rocketfishproducts.com for details. Contact Rocketfish: For customer service please call 1-800-620-2790 www.rocketfishproducts.com Distributed by Best Buy Purchasing, LLC 7601 Penn Avenue South, Richfield, MN 55423-3645 USA © 2010 BBY Solutions, Inc., All Rights Reserved. ROCKETFISH is a trademark of BBY Solutions, Inc. All other products and brand names are trademarks of their respective owners. ENGLISH 10-0540 # Component Description 1 Quick-release mounting plate Mount your device to this removable plate. 2 1/4" screw Tighten to secure your device to the mounting plate. 3 Mounting base plate Clamp the quick-release mounting plate to this base plate. 4 Variable angle head ball Allows the head to be adjusted to any angle. 5 Safety lock pin Prevents the mounting plate from falling out when the quick release clamp knob is released. 6 Pan locking knob Locks the horizontal movement of the head. 7 Quick-release plate locking knob Locks the quick-release mounting plate to the tripod. 8 Head ball locking knob Sets the head at different angle. Loosen to permit movement of the head ball. Tighten to stop movement of the head ball.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project