Philips HP4611/07, HP4611 Troubleshooting guide

Philips HP4611/07, HP4611 Troubleshooting guide
Using the appliance
Do not leave the appliance unattended when it is switched on.
The Salon ProCeramic Rollers is a roller set that has been specially designed
to create perfect long-lasting curly and wavy styles.
Read these instructions for use carefully before using the appliance and save
them for future reference.
1 Make sure all rollers are in the appliance, the clips and pins are
outside the appliance and the lid is closed.
2 Put the plug in the wall socket.
Check the condition of the mains cord regularly. Do not use the
appliance if the plug, the cord or the appliance itself is damaged.
Check if the voltage indicated on the appliance corresponds to the
local mains voltage before you connect the appliance.
If the mains cord is damaged, it must be replaced by Philips, a service
centre authorised by Philips or similarly qualified persons in order to
avoid a hazard.
Keep this appliance away from water! Do not use this product near
or over water contained in baths, washbasins, sinks etc.When used in
a bathroom, unplug the appliance after use since the proximity of
water presents a risk, even when the appliance is switched off.
For additional protection, we advise you to install a residual current
device (RCD) with a rated residual operating current not exceeding
30mA in the electrical circuit supplying the bathroom.Ask your
installer for advice.
After the appliance has heated up, remove the cover and wait a while
before taking out the first roller.
The rods of the appliance become very hot. Prevent contact with the
Only pick up the heated rollers by the cool-touch plastic rim.The
other parts of the rollers are hot.
Keep the appliance out of the reach of children.
Do not leave the appliance unattended when it is switched on.
Only use the appliance on dry hair.
Always unplug the appliance after use.
Never immerse the appliance in water nor pour water into it.
Always return the appliance to a service centre authorised by Philips
for examination or repair. Repair by unqualified people could cause an
extremely hazardous situation for the user.
The big rollers have a ceramic coating.This coating will wear in the
course of time.When this happens, the rollers will still function
Wait until the rollers and the appliance have cooled down and are dry
before storing them.
3 Switch the appliance on by setting the red rocker switch on the right
side of the appliance to '1'.The switch will light up when the appliance
is switched on.
4 Let the appliance heat up for about 10-15 minutes.When the red dots
on top of the rollers have turned white, the appliance is ready for use.
You can leave the appliance switched on while you are putting the
rollers in your hair.
5 Make sure the hair is clean, dry and tangle-free. Divide the hair into
6 Take a lock of hair and comb it through.You can use a little bit of
Tresemmé hairspray for better fixation.
Take locks with a width of approx. 4cm for the big rollers, approx. 3cm for
the medium rollers and approx. 2cm for the small rollers.
7 Take the end of the lock and start winding the lock round the roller.
Make sure the end of the lock is wound in the required direction.
Always hold the rollers by the plastic rim, because the other parts of the
rollers are hot. Usually the small rollers are used on the sides of the head
and the large rollers on top of the head.
8 Wind the roller towards the scalp, maintaining an even tension.
Fix the roller with a clip or pin.
Use the metal pins to fix the small and medium rollers and use the butterfly
clips to fix the large rollers.
9 Continue with the rest of the hair, always taking locks of the
appropriate width for the rollers.
10 Leave the rollers in the hair until the hair has completely cooled down.
You can use a hairdryer for additional heat to speed up the curling process.
11 Remove rollers from the hair by first removing the clip or pin and
then carefully removing the roller by unwinding the lock of hair.
12 Don't comb or brush the hair after styling, as this would destroy the
curls. Just run your fingers through the curls to divide them into
smaller strings and to get the most natural effect.
1 Always switch the appliance off and unplug it before cleaning it.
Preparing for use
Washing your hair
Everybody wants shiny and beautiful hair. A good hair-washing routine can
help to achieve this.When washing your hair, wet your hair thoroughly for
30-60 seconds.
1 Pour some TRESemmé shampoo into the palm of your hand. Spread it
between your hands and distribute it evenly through the hair.
2 Make sure the rollers and the appliance have cooled down before
cleaning them.
3 Clean the rollers with a moist cloth and remove any residues of e.g.
4 Clean the appliance with a moist cloth.
Never immerse the appliance in water nor pour water into it.
2 Gently massage your hair and scalp. Do not rough up the hair or pull
long hair up onto the scalp, as this may cause tangles.
5 Let the rollers dry completely before placing them back into the
3 Massage your scalp with your fingertips.This stimulates blood
circulation and is gentler to the hair cuticles.
1 Make sure the rollers and the appliance have cooled down and are
dry before storing them.
4 Rinse your hair thoroughly, as poor rinsing can result in dull hair.
5 Finish with a cold rinse for extra shine.
After shampooing, use TRESemmé conditioner for detangling the hair and
improving its condition.
Drying your hair
To get professional styling results, it is essential to prepare your hair for
1 After washing, squeeze excess water out of the hair with your hands
and then towel-dry the hair.
2 Dry you hair properly with a hairdryer to ensure a professional finish.
3 Dry your hair by making brushing movements with the dryer at a
small distance from your hair.
Use a comb to disentangle hair gently from the roots to the tips.
4 When you have finished drying, set the hairdryer to the cold setting
for a final cold shot.This closes the cuticles and leaves your hair
2 Place the rollers in the appliance.
There is a circle around each heating rod that indicates which roller size
should be placed on the rod.
3 Store the mains cord by winding it round the cord storage hooks in
the bottom of the appliance.
4 Place the clips and pins in the four compartments surrounding the
Do not throw the appliance away with the normal household waste
at the end of its life, but hand it in at an official collection point for
recycling. By doing this you will help to preserve the environment
(fig. 1).
Guarantee & service
If you need information or if you have a problem, please visit the Philips
website at or contact the Philips Customer Care Centre
in your country (you will find its phone number in the worldwide guarantee
leaflet). If there is no Customer Care Centre in your country, turn to your
local Philips dealer or contact the Service Department of Philips Domestic
Appliances and Personal Care BV.
HP4611/07 Salon ProCeramic Rollers
If problems should arise with the appliance and you are unable to solve
them by means of the troubleshooting guide below, please contact a Philips
service centre or the Philips Customer Care Centre in your country.
The appliance does
not work at all.
Perhaps there is a power
failure or the socket is not
Check whether the socket is
live by plugging in another
Perhaps the mains cord of
the appliance is damaged.
If the mains cord is damaged,
it must be replaced by Philips,
a service centre authorised
by Philips or similary qualified
persons in order to avoid a
4222 002 62912
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF