Zonet ZFS3316P network switch null

Package Contents
One
One
One
One
ZFS3316P
Quick Installation Guide (English)
Quick Installation Guide (Spanish)
Power Adapter
Front Panel
LED indicators
LED
Status Operation
POWER Green Steady: Power is ON
Steady: Network cable connected and connection
established
LNK/ACT Green
Flash: Data packets are transmitting
Off: Network cable is unplug
Diagram
1
Rear Panel
16 RJ-45 ports
Side Panel
One Power Connector
Caution
• ZFS3316P must put on a surface that is able to hold at least 5kgs
weight
• Power adapter must be connected to the switch properly and
securely
• Suggested at least 10cm empty space around the unit for sufficient
ventilation and cooling
• Do not recommend to put any items on top of the switch
• ZFS3316P is not ideally to work in a high electromagnetic
environment, under direct sunlight, dust and vibrating surfaces
• Maximum distance between the switch and the end node is 100
meters
• Must use an unshielded or shielded twisted-pair (UTP/STP)
Category 5 or better cables to ensure proper transmission
• Loss of data packet may encounter when using cable other than
Category 5
2
Installation
1. Connect the power adapter to
the wall socket, and then
connect it to the “Power” socket
of ZFS3316P.
2. Connect all your computers,
network devices
(network-enabled consumer
devices other than computers,
like game console, or switch /
hub) to the LAN port of
ZFS3316P with UTP/STP
Category 3/4/5 cables.
Troubleshooting
1. Check the power adapter and power wall-jet to make sure they are
function properly. Check if the switch is turned-ON and power LED
is steady.
2. Check all cable connections between computer and the switch to
make sure they are connected properly.
3. Maximum distance is 100 meters from the switch to end nodes.
4. Link LED(s) is ON/flashing at the connected port(s) of the switch.
5. Test your computer’s network adapter to make sure it is installed
and functioned properly.
6. Check issues such as network collisions, domain limitations, and
other physical installation aspects. Make sure they all meet IEEE
standard network installation requirements, more details can be
found at www.ieee.org.
7. If problem still persists, write down your software/hardware
configuration and LED error indications and contact your local
retailer or the store purchased for further assistance.
3