Power Acoustik HP-10S headset

Farenneit
МАЛА РТИ EME. CORA
1—1
IR Wireless Stereo Headphone
USER’ S MANUAL
Installing batteries into the Headphone
* Lift the battery compartment caver(®) located on the earpiece.
- Insert 2 AAA alkaline batteries(not included) according to polarity
* Close the battery compartiment cover(®).
Using the Headphone
1.Push power switch on the Headphone(®). The red power indicator(®)
illuminates.
2 Turn volume control knob to adjust the volume(ú).Da not cover the
infrared light sensor(D®) while adjusting the volume.
3.Auto mute eliminates static when IR signal is blocked or you are cut of
transmitting range.
AN
(1) (3)infrared light sensor
(2) battery compartment cover
(4) power indicator
(5) power switch
(6) volume control knab
NOTE
The unit uses infrared rays to transmit the audio signal.If the headphone
is placed too far from the transmitter,a hissing noise may occur. This is
characteristic of infrared system and does not mean that system is defective.
Special Features:
1. The headphone has auto mute function:
When the IR transmitter turns off or the headphone does not receive the
IR signal, the headphone automatically turns off its power amplifier and
mutes.
2.The headphone has auto poweroff function:
After 3-5 minutes if the headphone does not receive the IR signal, it will
automatically turn off.
Cleaning the Headphones
Remove dust or stains with a damp cloth only. Do not use alcohol,
benzene or thinner.
CAUTION
Listening at high volume levels can lead to permanent hearing damage.
WARNING
Do not try to disassemble headphone.
Do not place headphone near heat sources or in direct sunlight.
Do not place on very cold surfaces.
Do not place headphones where there is moisturerain,ra‘n, vibration,shock
or excessive dust environment.
Da not store in an unstable location or in a magnetic zone Keep and operate
Headphone in a well-ventilated environment.
Do not use oil or grease any mechanical parts. All moving parts require no
lubrication.
If any liquid should accidentally fall on or get into the producl,immediately
switch off power.
Turn power off the headphone when itis not in use for a long time.
Specification
System: Infrared light
Carrier frequency: L channel 2.3MHz
R channel 2.8MHz
Modulation: FM
Mode: Stereo
S/N: >=60dB
Channel separation: >=40dB
Distorlion: <1%
Frequency response: 30-20,000Hz
Power: 2XR3 (AAA)
Current consumpation: approx. 25mA max (play)
Approx. 15mA (mute)
Weight: approx. 5.640z (battery is not included)