W and WIP Alarm panel
D A T A S H E E T
Doc. - Ref. 220-W
Version : February 2015
Description
The W series control panel is a wireless hybrid alarm system.
It is designed for residential and small business security applications.
The W alarm panel protects assets and persons in a defined area, thanks to the installations of RSI radio detectors.
With their LAN or 2G3G transmitters, the events are perfectly transmitted from the W and WIP panels to the security server.
The available variants allow for any needed combination :
LAN, 2G, 2G+LAN, 3G+LAN.
The WIP210 panel is fitted with two transmitters (2G3G and
LAN), allowing perfect reporting to the security server.
This panel is powered by USB 5V DC (5V DC for WIP6xx and
WIP 7xx) through an AC adapter/charger. In case of power failure, a rechargeable lithium battery will power the system.
The following customization options allow you to configure the alarm system as needed:
> WLAN 802.11 (WWB100) transmlitter option.
> Supervised wired input/outputs option (WIO100) to link the system to wired devices.
> A wired and supervised siren option (WIS100) connected to the W panel aslo allowing the use of additional Videofied wireless sirens (indoor and outdoor).
A programming keypad is mandatory to install, set up and use the W alarm panel.
Supervised Wireless Technology
The W series, along with all Videofied devices uses patented
S2View ® - Spread Spectrum, Videofied, Interactive, AES
Encrypted Wireless technology, providing optimum signal integrity and security.
Bi-directional RF communication between all system devices and the system control panel assure high signal reliability.
Integrated antennas eliminate protruding wires or rods cumbersome to install and unsightly to consumers, and if damaged could lead to potential system communication problems.
The panel supervises every device (excluding the remote keyfob) to monitor current open/close state, tamper condition, serial number, date of manufacture, firmware revision, and battery status.
Security
With the two modes of transmission, LAN/WLAN and GSM, the
W series panel ensures maximum safety. In case of LAN/WLAN connection loss, the W panel will switch immediately to GSM to transmit alarms and videos.
www.videofied.com
W and WIP Alarm Panel D A T A S H E E T
Certifications
868MHz (WIP 210/220/230 and W 210)
Compliant with the annex IV from the R&TTE 1999/5/CE Directive
NF&A2P - 2 boucliers – suivant le référentiel NF324-H58
Matériels de sécurité électroniques, détection d’intrusion
CENTRALE D’ALARME + TRANSMETTEUR
Marque commerciale :
Videofied
Référence Produits :
Centrale WIP210
Videofied
Videofied
Videofied
Normes :
NF EN50131-1 : 2007 - Grade 2 – Classe II
NF EN50131-3 :2009 - Grade 2
NF EN50131-5-3 :2005 - Grade 2
NF EN50131-6 :2008 Grade 2 –Type B
NF C 48-212 :2004
NF EN50130-4 :1995; A1:1998; A2:2003
NF EN50130-5 : 1998 Classe II
Organisme certificateur :
CNPP Cert.
Route de La Chapelle Réanville CS22265
F—27950 SAINT MARCEL
Tel : +33(0)2.32.53.63.63
Fax: +33(0)2.32.53.64.46
Sites Internet : http://www.cnpp.com
Email : [email protected]
Centrale WIP220
Centrale WIP230
Centrale W210
&
&
RTC 50131-3
RTC 50131-6
:2009
:2008
Organisme certificateur :
AFNOR Certification
11, rue François de Pressensé
N° de Certification :
93571 Saint Denis La Plaine Cedex
Tel : +33(0)1.41.62.80.00
Fax: +33(0)1.49.17.90.00
Sites Internet : http://www.afnor.org et http://www.marque-nf.com
Email : [email protected]
915MHz (WIP 620 /630)
UL 1610
USA FCC (Part 15C, 22H, 24E and 27)
Canada IC (RSS-210 Issue 8, RSS-132, RSS-133 and RSS-139)
920MHz (WIP 720/730)
Australia A-Tick
(AS/NZS4268, AS/CHS42 and AS/NZS 60950)
Ce symbole, apposé sur le produit ou sur son emballage, indique que ce produit ne doit pas être traité avec les déchets ménagers. Il doit être remis à un point de collecte approprié pour le recyclage des équipements
électriques et électroniques. En s’assurant que ce produit est bien mis au rebut de manière appropriée, vous aiderez à prévenir les conséquences négatives potentielles pour l’environnement et la santé humaine. Le recyclage des matériaux aidera à préserver les ressources naturelles.
Pour toute information supplémentaire au sujet du recyclage de ce produit, vous pouvez contacter votre municipalité, votre déchetterie ou la société qui a installé le produit.
www.videofied.com
2
W and WIP Alarm Panel D A T A S H E E T
Notes de sécurité / (EN) Security notes / (DE) Hinweise zur Sicherheit
Français English Deutsch
•
Retirez la batterie avant toute opération de maintenance !
•
Attention ! Il y a un risque d'explosion si la batterie utilisée est remplacée par un mauvais modèle !
•
Respectez la polarité lors de la mise en place de la batterie !
•
Ne jetez pas la batterie usagée !
Ramenez-la à votre installateur ou à un point de collecte spécialisé.
• Remove the battery before any maintenance !
• WARNING, there is a risk of explosion if a battery is replaced by an improper model !
• Observe polarity when setting up the battery!
• Do not throw the battery when it is used! Dispose of it properly according to Lithium Metal requirements
• Batterien vor jeglichen Wartungsarbeiten entfernen!
• Vorsicht, es besteht Explosionsgefahr, wenn eine Batterie durch eine Batterie falschen Models ersetzt wird!
• Achten Sie beim Einsetzen der Batterie auf die Polung!
• Entsorgen Sie Batterie nicht im normalen
Haushaltsmüll! Bringen Sie Ihre verbrauchten Batterie zu den öffentlichen
Sammelstellen.
FCC Regulatory Information for USA and CANADA
FCC Part 15.21 Changes or modifications made to this equipment not expressly approved by RSI Video Technologies may void the FCC authorization to operate this equipment.
FCC Part 15.105 Class B
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
> Reorient or relocate the receiving antenna.
> Increase the separation between the equipment and receiver.
> Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
> Consult the dealer or an experienced radio/TV technician for help.
Radio frequency radiation exposure information according 2.1091 / 2.1093 / OET bulletin 65
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1 This device may not cause harmful interference, and
2 This device must accept any interference received, including interference that may cause undesired operation.
Cet appareil est conforme à la Partie 15 des règlementations de la FCC et avec la norme RSS-210 de l’Industrie Canadienne.
Son fonctionnement est soumis aux deux conditions suivantes :
1 Cet appareil ne doit pas causer d’interférences nuisibles et
2 Cet appareil doit accepter toute interférence reçue, y compris les interférences pouvant entraîner un fonctionnement indésirable.
www.videofied.com
3
W and WIP Alarm panel D A T A S H E E T
Electrical data Transmission
Power Supply Communicator
W210 / WIP 210 / WIP 220 / WIP 230 Communicator type 2G & LAN Ethernet (WIP210)
5V
DC
/1A Mini-USB connector 2G (W210)
AC/DC adapter (110/230V
AC
/50-60 Hz) available (WPS100) LAN Ethernet (WIP220 / WIP620 / WIP720)
WIP 620 / WIP 630 / WIP 720 / WIP730 3G & LAN Ethernet (WIP230 / WIP630 / WIP730)
12V
DC
/1A - Wire connection Frontel
Backup battery
Battery technology Rechargeable 3.7V Lithium-ion battery
IP Stack
Video transmission
TCP/IP
By Frontel protocol to central monitoring station or App servers
Battery voltage (Fully charged) 4.1 V
2G3G Antenna Integrated
Low battery level
Guaranteed autonomy when the low battery level is reached
3.95 V
Average current consumption in standby mode
Max consumption
36h
600 µA
1 A
Optional modules
Wi-Fi
Wired Input/Outputs
Wired Siren
WWB100 (WLAN 802.11 b/g/n)
WIO100 (out of NF&A2P compliance)
WIS100
RF S2View
® technology
Radio type
Operating frequency
Bidirectionnal RF
868MHz - WIP210/220/230 - W210 (Europe, South Africa, Asia)
915MHz - FHSS - WIP620/630 (USA, Canada, South America)
920MHz - FHSS - WIP720/730 (Australia, South America)
Transmission security AES encryption algorithm
Radio jam detection Yes
Supervision Yes
Antenna Integrated
Tamper Detection
Tamper Wall and cover tamper detection
Video
Video format
Images per second
Image size
Video length
WMV or MPEG
5
320x240 or 640x480 pixels
4 to 12 seconds
Miscellaneous
Programming
Max number of devices
Max number of codes/badges
Arming modes
Keypad or USB
24
50
4
Areas 4
Event log
4,000 events stored on flash memory
Box
Physical and Environmental Data
Operating temperature
Maximum relative humidity
-10°/+55°C
75%, non-condensing
Material ABS—ULV0
International Protection Marking IP31 / IK06
Dimensions
Panel 143 mm x 200 mm x 44mm (LxWxD)
Installation/Mounting
Control Panel/Base
Two screws secures control panel cover to base; Three screws secure control panel base to the wall
EMEA SALES
23, avenue du Général Leclerc
92340 BOURG-LA-REINE
FRANCE
E-Mail : [email protected]
North American Headquarters
1375 Willow Lake Blvd, Suite 103
Vadnais Heights, MN 55110
USA
E-Mail : [email protected]
www.videofied.com
4
