Aluratek ABH01F User guide

Aluratek ABH01F User guide
On Ear Controls
Bluetooth Wireless Stereo Headphones
Quick Start Guide
Operation
Charging the battery
The battery is not fully charged and it is highly recommended that you charge ABH01F
before you begin using it.
LED
Note: Using ABH01F “out of the box” will not harm the device. You will experience reduced battery life as the
unit will not be fully charged.
Power On / Off / Pair
Connect the USB end of the cable provided to your PC / power adapter. Connect the
other end to the charging port of ABH01F. Please charge the battery for a minimum of
(4) hours. The Red LED will be on while charging. When charging is complete, the
red LED will turn off.
Play / Stop / Answer Call
/ End Call
aluratek.com
Operation
Power On
Press and hold the
Volume Control
Enter Pairing
Mode
Ensure ABH01F is turned OFF. Press and
hold
button for 8 seconds.
Red and blue LED
flashes rapidly
Power Off
Press and hold the
LED is on.
LED OFF
Headphone jack for wired
connection / charging jack
ABH01F
qsg Q10229
Function
Previous / Next Track
Microphone
LED Indicator
button for 3 seconds
button until the red
Blue LED ON
Copyright © 2012 Aluratek, Inc. All Rights Reserved.
Operation
Note: The pairing mode will last 2 minutes. ABH01F will switch to the standby mode automatically if
no devices can be connected within 2 minutes.
Pairing with the transmitter such as iPhone, smart phone, and tablet:
Please make sure the device supports A2DP profile. The pairing procedure will vary
depending on the actual device. Please refer to the user guide of your device for
detail instruction. The general pairing procedures are as follows:
1. Make sure ABH01F is turned ON.
2. Activate ABH01F pairing mode by press and hold the
button for 8 seconds.
(Red and blue LED will flash rapidly)
3. Activate your device’s Bluetooth function and set your device to search for Bluetooth
devices. Select ABH01F when it is found.
4. For transmitter with Bluetooth version 2.1, you will not need to input a code. If you
are prompted for PIN, please enter “0000”.
5. If prompted by your device to connect, please select “Yes”.
6. After connecting successfully, the blue LED will flash every 3 seconds.
Note: Please make sure the audio output is set to Bluetooth / ABH01F for audio streaming from the device.
Tech Support & Warranty Information
If you need further assistance, please contact the Aluratek support department for
troubleshooting prior to returning this device.
E-mail: [email protected]
Web: www.aluratek.com/support
Local (Tustin, CA): 714-586-8730
Toll free: 1-866-580-1978
Aluratek warrants this product against defect in material or workmanship for
1 Year from the date of purchase.
For more information, please visit: http://aluratek.com/warranty-return-policy
You can register your product online at: http://aluratek.com/product-registration
Radio and TV Interference Statement
WARNING!!! This equipment has been tested and found to comply with the limits of a
Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by whatever measures may be
required to correct the interference.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement