USB 3.0 SATA 3.0 Adapter

Introduction

Thank you for purchasing the LINDY USB 3.0 SATA 3.0 Adapter. This versatile adapter allows you to connect your SATA disk drives to your computers USB 3.0 port, without the need for dedicated drive housing.

Package Contents

USB 3.0 SATA 3.0 Adapter with USB 3.0 cable attached

Multi-Country power supply

This manual

Features

Super Speed USB 3.0 Interface

Compliant to SATA Specification Rev. 3.0

Supports 2.5”, 3.5” and 5.25” SATA drives

Compatible with Windows XP/Vista/Win7/Server 2003/2008/RC2 & Linux Kernel 2.6.31 and above

Installation

The LINDY USB 3.0 SATA 3.0 Adapter can be quickly and easily installed on Windows computers.

1. Connect your SATA drive to the USB Adapter.

2. Next connect the USB Adapter to an available USB 3.0 port on your computer.

3. After a short while you will see the Found New Hardware message and Windows will install the drive.

4. Once Windows has finished installing your drive you will see Your new hardware is installed and

ready to use.

5. Go to My Computer and you will be able to see your newly installed drive.

Disconnecting (Safely Remove Hardware)

Windows

1. Go to your System Tray in the bottom right of your display.

2. Double click on the Safely Remove Hardware icon.

3. You will be presented with a list of devices connected to your PC.

4. Highlight the drive you want to remove and click Stop and then OK.

5. You will then see the Safe To Remove Hardware.

6. You may now remove your drive.

LINDY No. 43119

www.lindy.com

Shielded cables must be used with this equipment to maintain compliance with radio frequency energy emission regulations and ensure a suitably high level of immunity to electromagnetic disturbances.

FCC Warning

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment and receiver

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

Consult the dealer or an experienced technician for help

You are cautioned that changes or modification not expressly approved by the party responsible for compliance could void your authority to operate the equipment.

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired operation.

WEEE (Waste of Electrical and Electronic Equipment),

Recycling of Electronic Products

In 2006 the European Union introduced regulations (WEEE) for the collection and recycling of all waste electrical and electronic equipment.

It is no longer allowable to simply throw away electrical and electronic equipment. Instead, these products must enter the recycling process.

Each individual EU member state has implemented the WEEE regulations into national law in slightly different ways. Please follow your national law when you want to dispose of any electrical or electronic products.

www.lindy.com