IW-RA100

Chassis Quick Reference

Major Components Installing Power Supply

Standard 12” x 9.6” ATX M/B

1U Form Factor

Power Supply 1 x PCI Slot Expansion

(Via Riser Card)

3

1 x 3.5" HDD Carrier

Rear I/O Access Type

1 x Slim CD-ROM / DVD-ROM Carrier

LED Module

( w/2 x USB Ports )

Blower Fan

1 x 3.5" HDD Carrier

Front Panel Controls and Indicators

A. System Reset Button

B. USB 2.0 Ports

C. HDD Activity LED

D. Power LED

E. Failure LED

F. LAN1 LED

G. LAN2 LED

H. Power On Switch

H D C F G E A B

Top Cover Assembly

1

4

1. Release two screws on

the front with PSU bracket.

2. Release two screws on chassis

bottom.

2

3. Release two screws on the back.

4. Moving power supply unit forward a little bit for detachment.

Installing Slim CD-ROM / DVD-ROM

4

3

2

1

4

2

1

1

1. Release the screws on the side for removing top cover.

2. Then pull back to remove the top cover.

Installing Hard Drive

2

1. Release attached screws and moving

the HDD carrier toward the side of fan

bar for detachment.

2. Assembly HDD with the carrier and

fix with four screws.

3. Place HDD assembly into chassis

and fix with attached screw.

1

3

2

1. Release two screws to remove slim CD-ROM/DVD-ROM blank cover.

2. Assembly slim CD-ROM/DVD-ROM with four screws.

3. Slide the CD-ROM/DVD-ROM into the tray until lock.

4. Attach two screws to fix the CD-ROM/DVD-ROM bracket into the chassis.

I/O Shield Assembly

1

2

1. Put the I/O Shield inside the chassis to attach on the rear windows.

2. Attach with two screws to fix I/O Shield.