Hobbistar 60 Select Addendum

Hobbistar 60 Select Addendum
HOBBISTAR .60 SELECT ADDENDUM
Complete the following steps prior to page 10 in
the manual.
INSTALLING THE PROP AND SPINNER.
❏ 3. Install the spinner cone and tighten the four
Phillips screws. Insure the spinner cone does not contact
any part of the propeller
❏
1. Ream the spinner backplate to 5/16" [7.9mm] using a
hobby knife, prop reamer, or drill.
❏ 2. Install the backplate, prop, prop washer, and prop nut.
Tighten the propeller nut “finger tight,” then use a 12mm
wrench or a crescent wrench to fully tighten the nut – 1/2
turn, plus 1/8 turn.
HCAA18**ADDN01
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement