Clarisonic Plus facial cleansing brush User manual

READ ALL INSTRUCTIONS BEFORE USE
TO USE
Prior to the first use, charge the Clarisonic Plus
handle for 24 hours.
* If you use makeup, remove eye makeup by
hand. forehead
* Wet your skin and the brush head with warm
water.
* Liberally apply cleanser to your skin or to the
brush head.
- seconds
each
* Push the on/off button to turn on your Plus.
* Select desired speed. seconds
* Follow T-TIMER® prompts while gently moving
brush head in small circular motions.
* Plus will automatically shut off after the noe)
cleansing cycle. 20
NOTE: Keep brush head flush to the skin. — seconds
Pressing too hard will impede the motion and
reduce effectiveness.
FEATURES OF YOUR PLUS
SPEED SETTINGS
The Plus offers a choice of 3 speeds: high, normal and low. Speed is
indicated both audibly and visually. To change speeds, press the speed
button while the Clarisonic Plus is on. The factory setting is low speed.
Speed settings for facial cleansing
Speed Audible indication Visible indication
High 5 ascending beeps upper red light on
Normal 3 ascending beeps lower red light on
Low 3 descending beeps no lights on
Body modes for cleansing targeted areas of the body
Constant no beeps upper red light on
Pulse no beeps lower red light on
CLEANSING TIMER (T-TIMER®)
For even and thorough cleansing of your face, the Plus features a
proprietary T-TIMER that beeps and pauses momentarily to indicate it is
time to move to another part of your face. We recommend the one-
minute setting: 20 seconds on your forehead, 20 seconds on your nose/
chin, and 10 seconds on each cheek.
T-TIMER settings for facial cleansing are indicated by different audible
sequences. To change the setting, press and hold the on/off button for 2
seconds. To change to a different setting, release the on/off button, then
press twice and hold.
Audible indication Cleansing duration T-TIMER beeps
1 long beep & 2 minutes at 40, 80, and 100
2 short beeps seconds
1 long beep only 2 minutes none
1 long beep & 1 minute (this is factory — at 20, 40, and 50
1 short beep selected default) seconds
With optional Body Brush Head attached
No beeps 3 minutes none
To pause the cleansing cycle for up to 30 seconds, press the on/off button.
The red lights flash in pause mode. To resume, press the on/off button.
CHARGING
Your system kit includes a charging cradle to hold and charge the brush
handle.
Place your Plus in its charging cradle overnight to recharge it. Allow 24 hours
for a full charge. A full charge allows up to 30 minutes of use, and about 20
minutes of use with the optional Body brush head. The green lights on the
back of the handle indicate charge level. When the battery is low, the brush
handle will beep immediately after use to alert you to place it in the cradle
for charging.
If your Plus stops working, place it in the charger for a MINIMUM Of $ hours. If
the issue is not resolved, please contact Customer Service.
UNIVERSAL CHARGING CRADLE for worldwide use
Compatible with international and domestic outlets (100-240 Volts AC; 50/60
Hz) with the respective country plug adapter.
If the shape of the plug does not fit the power outlet, use an attachment
plug adapter of the proper configuration for the power outlet.