Harley Davidson Viking Motorcycle Sissy Bar

www.vikingbags.com
888-208-1949 |
[email protected]
HARLEY VIKING MOTORCYCLE SISSYBAR BACKPACK INSTRUCTION
Instruction
Step 1
Make sure that the two long straps (used for wearing the bag on the back) are securely tucked into the pocket on the
backpack.
Step 2
Place the bag on the bike such that the wide-strap goes around the backrest as shown in the image. You may place the
bag facing forward or backward depending on whether you want to place it on the seat or the luggage rack.
Step 3
Once in place, connect the two short straps on the bottom of the backpack on both sides using easy buckles and pull
the straps to tighten them. The two straps must be connected such that they form a loop around the uprights
Step 4
Ensure that the short straps connected through easy buckles are tight and the wide-strap holds the backrest tightly.
Backrest
Wide Strap
Short Strap Buckle
Upright
Fig 1 (a) Installed on Passenger Pillion
Wide-Strap
Short Strap Buckle
Luggage Rack
Fig 1 (b) Installed on Luggage Rack
Warnings
✓
✓
✓
✓
When installed on a luggage rack, do not exceed the load limit of the luggage rack.
Secure the bag straps to the rack or passenger upright to prevent bag shifting during motorcycle operation.
Verify that all straps are secured to prevent strap contact with the rear wheel during motorcycle operation.
When installing on passenger pillion, the maximum total weight should not exceed 25 pounds.
copyright © 2016 Vikingbags