Yamaha DKC-850 Internet Connection Manual

6/4/2011 Yamaha: Connect to Radio Service For …

Online Services

DKC-850 INTERNET CONNECTION GUIDE

Connection Example

Wireless connection

*Modem

Access point

Wireless bridge device

Ethernet cable

*Here, "m odem" refers to an ADSL modem , optical network unit (ONU), or cable m odem .

Instructions

PURCHASE A

COMPATIBLE LAN

BRIDGE DEVICE

Any LAN bridge compatible with your network should allow you to connect your instrument wirelessly. However, the following devices have been fully tested and are recommended for use with Yamaha instruments:

LINKSYS WET610N

BUFFALO WLI-TX4-AG300N

You may need to refer to the manufacturer's instructions to configure your adapter. A full list of compatible adapters is available at the Yamaha Download Site .

Set up your adapter to connect to your wireless network, following the directions provided for your adapter. If you have any problems connecting the bridge device to your network, please contact the device manufacturer for further support.

CONFIGURE THE

BRIDGE ADAPTER

ATTACH

ETHERNET CABLE

To your Disklavier

PRESS

Still can't connect? Follow these instructions…

…yamaha.com/connect/wirelessType?t…

Attach one end of an Ethernet cable to the rear port of the bridge adapter and the other end to the Ethernet port on your Disklavier.

Press the [Internet] button on your remote. Congratulations, you are now connnected. You should see the Internet Direct Connection home page.

1/2

6/4/2011

PRESS

Yamaha: Connect to Radio Service For …

If you see a screen saying that you are not successfully connected, you may need to set up your instrument to connect to your network. To do so, press [Setup], then [Network] from your remote control.

CONFIRM

NETWORK

SETTINGS

Here you can update your DHCP, DNS, proxy, and manual IP settings. In most cases you will not need to edit these settings.

Unless you are manually assigning DNS or IP locations for your instrument, you can set DHCP to "On" and your network should automatically configure the settings to connect successfully.

If you want to enter your DNS server addresses manually, you can choose "DHCP and DNS".

If you also want to enter your IP address, subnet mask, and gateway server information, select "Manual." Also, if you're using a proxy server you will need to enter its name and port here in order to connect.

Note: If you have any questions about the settings for your network, please contact your internet service provider or refer to the documentation for your router.

PRESS

After entering and confirming your network settings, return to the

Internet Direct Connection home page by pressing "Internet" on your remote.

Attention:

*Once connected to Internet Direct Connection, you'll be able to enjoy Yamaha's Piano Radio services. Don't have a subscription? Get one now .

*If you have connected successfully and would like to view Radio Service for Piano playback instructions, visit Playback

Instructions .

…yamaha.com/connect/wirelessType?t… 2/2