Stirling STS 2406 Steam Station Iron User manual

Steam Station Iron
High steam pressure and a smooth
ceramic soleplate for efficient crease
removal. Safety features include auto
shut off and boil dry protection.
Features:
1.7L
6
Ceramic Soleplate
1.7L Tank
2400W Power
Easily smooth creases with a
high quality non-stick finish
Convenient removable water tank
with a large 1.7L capacity for
longer use without refilling
2400W total power delivers
maximum steam and heat in
minimum time
6 Bar
High pressure steam for fast,
efficient crease removal
For more information please call 1300 663 907 or visit www.stirlingappliances.com.au
Starting Up:
Warnings:
-
Only use tap water in the water tank, do not use rain water, bottled water, detergents, descaling agents or any other chemicals.
Do not touch the iron soleplate at any time during use to avoid risk of burns.
Before storing ensure the Steam Station Iron has completely cooled down. This may take up to 2 hours.
Never leave iron face down on any surface. Always place iron back on the main unit or stand the iron vertically in between
ironing strokes.
Position the Steam Station Iron on a firm level table, bench or ironing board.
1.
2.
Remove the water tank and fill with
normal tap water, ensuring the water
does not exceed the MAX fill line.
4.
Press the iron release button and
rotate the iron clockwise to release
from the locking mechanism.
NOTES
Press the ON/OFF button, the
unit will beep once. The iron
thermostat light will turn on.
Plug the unit into a household
power point and turn power
point on.
5.
Select the desired steam setting by
pressing either the right or left arrows.
The corresponding light will flash to
indicate the boiler is heating to the
selected setting.
7.
3.
6.
Once the selected steam setting
light has stopped flashing and
the iron thermostat light is off
the unit is ready for use.
Select the desired soleplate
heat setting by rotating the iron
temperature dial.
8.
9.
Once you have finished ironing turn
the unit off by pressing and holding
the ON/OFF button and removing
the plug from the power point.
To iron with steam, press the steam
button and release as desired.
- The unit may make a pumping noise for a few
seconds, this is normal.
- Always refer to garment manufacturer
recommendations for the correct temperature setting.
Model Specifications
STS2406
Power
2000-2400W
Tank Capacity
1.7L
Warranty
3 years